Havis DS-GTC-7X0 Series Bedienungsanleitung

Owner’s Manual

Havis Docking Station

For Getac Z710 & ZX70 Rugged Tablets

www.havis.com

1-800-524-9900

DS-GTC-711

DS-GTC-711-2

DS-GTC-703

DS-GTC-703-2

DS-GTC-714

DS-GTC-714-2

DS-GTC-715

DS-GTC-715-2

DS-GTC-716

DS-GTC-716-2

DS-GTC-7X0 Series

DS-GTC-711

DS-GTC-711-2

DS-GTC-703

DS-GTC-703-2

DS-GTC-714

DS-GTC-714-2

DS-GTC-715

DS-GTC-715-2

DS-GTC-716

DS-GTC-716-2

Before Beginning (Original Instructions)

Havis is pleased to provide this Owner’s Manual to aid in the proper

installation and use of the DS-GTC-7X0 Series Docking Station for

the Getac Z710 & ZX70 Rugged Tablets.

For questions regarding the set-up of your DS-GTC-7X0 Series Docking Station,

please contact Havis at 1-800-524-9900 or visit www.havis.com for additional

product support and information.

This Owner’s Manual applies to the following Part Numbers:

• NEVER STOW OR MOUNT THE DOCKING STATION DIRECTLY IN A VEHICLE

AIRBAG DEPLOYMENT ZONE.

• DO NOT USE COMPUTER WHILE DRIVING.

• READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION.

• DO NOT STORE, INSTALL, OR OPERATE THE DOCKING STATION WHERE WATER, MOISTURE,

STEAM, DUST, ETC. ARE PRESENT

• DO NOT DOCK OR UNDOCK YOUR COMPUTER UNLESS IT IS POWERED OFF. DOCKING OR

UNDOCKING WITH YOUR COMPUTER IN ON, STANDBY, HIBERNATION, OR SLEEP MODES

CAN CAUSE PERMANENT DAMAGE.

• FOR THE DS-GTC-711, DS-GTC-711-2, DS-GTC-714, DS-GTC-714-2, DS-GTC-715,

DS-GTC-715-2 DOCKINGS STATIONS: DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE

source rated for a continuous, regulated 12DC output (Havis Part Number LPS-164 or

equivalent). Failure to comply with this requirement will cause product damage that is NOT

repairable and is NOT covered under warranty.

• FOR DS-GTC-703, DS-GTC-703-2, DS-GTC-706, DS-GTC-706-2 DOCKING STATIONS:

DO NOT CONNECT DIRECTLY TO VEHICLE VOLTAGE SOURCE: The Getac Z710/ZX70 tablet

output. Failure to comply with this requirement will cause product damage that is NOT

repairable and is NOT covered under warranty.

• FOR DOCKING STATION MODELS EQUIPPED WITH A BUNDLED POWER SUPPLY

REFER TO THE SUPPLIED GETAC POWER SUPPLY REFERENCE GUIDE.

• WHEN TABLET IS DOCKED, THE BATTERY WILL ONLY CHARGE BETWEEN

0°C to 50°C (32°F to 122°F).

PLEASE REFER TO GETAC Z710/ZX70 OWNER’S MANUAL FOR MORE INFORMATION.

Table of Contents

Parts Included

Port Replication Capability

Installation

Cable Management

Operation - Docking

Operation - Undocking

• Donot place metal objects or containers of liquid on top of the Docking Station

• If a malfunction occurs, immediately unplug the Power Supply and remove the tablet

(Part # LPS-164)with this Tablet

• Donot leave theDocking Station in ahigh temperature environment (greater than 70°C, 158°F)

for along period of time

Precautions

Power Supply Input 12.0 V DC-In

Dimensions 8.7” ( 22.1 cm) H x 9.2” ( 23.4 cm ) W x 2.9” ( 7.4 cm ) D

Weight 1.5 lbs ( 0.68 kg )

Operating Environment -20° C to 50° C ( -4° F to 122°F )

Storage Environment -40° C to 70° C ( -40° F to 158° F )

FCC 47CFR, Part 15 compliance:

to the model DS-GTC-7XX not expressly approved by Havis, Inc. could void

the user's authority to operate this equipment.

EC DECLARATION OF CONFORMITY

Manufacturers Name: Havis, Inc.

Manufacturers Address: 75 Jacksonville Road, Warminster, PA 18974 USA

This declaration of conformity is issued under the sole responsibility of the manufacturer.

Product name: Tablet Docking Station

Model: DS-GTC-7XX, where ‘x’ may be any alphanumeric character and which describes product options.

(Object of Declaration) May be followed by any alphanumeric characters which describe product options.

Product Options: This declaration covers all options of the above product which bear the CE Marking.

Is in conformity with the following directives, standards, or other normative documents:

EMC Directive 2014/30/EU EN 55022::2010/AC:2011

EN 55024:2010

RoHS Directive 2011/65/EU EN 50581:2012

The object of the declaration described above is in conformity with Directive 2011/65/EU of the European Parliament and of the

Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment.

Supplementary Information:

The object of the declaration described above is in conformity with the relevant Union harmonisation legislation.

Signed for and on behalf of Havis, Inc.:

Warminster, PA, USA June 10, 2014 Bruce Jonik, Director of Engineering , Havis, Inc.

Hardware Kit

Docking Station

Parts Included

(Optional, Part #s

DS-GTC-711-2/713-2/

714-2/715-2/716-2)

(DS-GTC-711/711-2)

(DS-GTC-714/714-2)

(DS-GTC-715/715-2)

Port Replication Capability

(DS-GTC-711-2, DS-GTC-712-2, DS-GTC-703-2, DS-GTC-714-2, DS-GTC-715-2)

In reference to the GETAC Z710 & ZX70 Antenna connections

Full Port Replication (JAE Connector Only)

(DS-GTC-711, DS-GTC-711-2)

Antenna Connectors (SMA)

(Optional - DS-GTC-711-2)

Power InputHDMISpeakerUSB 2.0

(x2)

SerialEthernet

(RJ45)

Lite Port Replication (POGO Connector Only)

(DS-GTC-714, DS-GTC-714-2)

Power InputSpeakerUSB 2.0

(x2)

SerialEthernet

(RJ45)

Antenna Connectors (SMA)

(Optional - DS-GTC-714-2)

Power Only Port Replication (POGO Connector Only)

(DS-GTC-715, DS-GTC-715-2)

Power InputSpeaker Antenna Connectors (SMA)

(Optional - DS-GTC-715-2)

Antenna Connectors (SMA) Tablet Interface

ANT. A ANT. B

Z710 WWAN GPS

ZX70 WWAN GPS

Installation

1) Align Docking Station mounting holes with the holes on VESA 75mm

hole pattern device. Using the four (4) M4 x 0.7x12mm Pan Head Screws

(Hardware Kit Item 3), four (4) Washers, M4 (Hardware Kit Item 4), and four (4)

Lock Washers, M4 (Hardware Kit Item 5), secure the Docking Station to device.

Torque screws to 20 in-lbs (2.3Nm) ± 10%.

A) Havis Desktop Stand installation (sold seperately, Part # DS-DA-218).

B) In-Vehicle mounting system installation.

Desktop Stand

(VESA 75 mm)

M4 x 0.7x12mm

Pan Head Screws

Lock Washer, M4

Washer, M4

M4 x 0.7x12mm

Pan Head Screws

Lock Washer, M4

www.havis.com • 1-800-524-9900 7

This loop must be large enough

to allow full range of expected

rotation and extension without

stressing connections.

Collect cables and secure

to the mounting system.

(Note: Mounting system not included)

Cable Management

1) Tip the Docking Station to a position that is comfortable to work with.

2) Connect all cables that are necessary for computing needs.

3) Use Zip Ties (Hardware Kit Item 1) to strain relieve cables. Strain Relief Points

are located on the bottom and sides of Docking Station and should be used

to anchor each cable.

4) Create a service loop with cables to ensure that no tension is on the

connectors and to enable intended motion.

5) Tie oﬀ cables onto a stationary part of the mounting system.

Use as many zip ties as

necessary to secure cables.

Operation - Docking

1) Ensure Docking Station is unlatched by lifting Latch Handle.

DO NOT FORCE TABLET ONTO DOCKING STATION.IF THERE IS RESISTANCE,

CHECK ALIGNMENT OF TABLETON DOCKING STATION.

NOTE: Ensure a proper connection by aligning the tablet’s

Alignment Sockets with the Docking Station’s Alignment Posts

Alignment Posts

DS-GTC-7X0 Series Docking Station

Alignment Sockets

Bottom of Getac Z710 Rugged Tablet

Latch Tab will engage

in front of your tablet

Operation - Docking

2) Hold tablet in landscape orientation, and guide into the Docking Station.

Next, lower tablet into the bottom of the Docking Station, while ensuring

that the alignment sockets are aligned with the Docking Station’s

Alignment Posts.

3) When tablet is properly seated in the Docking Station, lower the Latch

Handle to secure tablet in place.

If there is excessive force while

lowering the Latch Handle, check

orientation and position of tablet

Operation - Docking (continued)

Operation - Undocking

1) If previously locked, unlock Docking Station using supplied key.

2) While holding tablet with one hand, lift the Latch Handle on the top

of Docking Station.

3) Once unlatched grab both sides of tablet, carefully lift tablet up and out

of Docking Station.

4) For theft deterrence, secure tablet by locking Docking Station with

supplied key (Hardware Kit Item 2).

Dieses Handbuch passt für folgende Modelle

Andere Havis Dockingstation Handbücher

Havis

Havis DS-GD8 Bedienungsanleitung

Havis

Havis DS-PAN-1000 Series Bedienungsanleitung

Havis

Havis DS-PAN-1200 Series Bedienungsanleitung

Havis

Havis DS-GTC-711 Bedienungsanleitung

Havis

Havis DS-PAN-801 Bedienungsanleitung

Havis

Havis DS-DELL-410 Series Bedienungsanleitung

Havis

Havis DS-PAN-504 Bedienungsanleitung

Havis

Havis DS-PAN-421 Bedienungsanleitung

Havis

Havis DS-PAN-412-2 Bedienungsanleitung

Havis

Havis Ledco Installations- und Betriebshandbuch

Havis

Havis DS-DELL-900 Series Bedienungsanleitung

Havis

Havis DS-GTC-1200 Series Bedienungsanleitung

Havis

Havis DS-PAN-900 Series Bedienungsanleitung

Havis

Havis DS-DELL-300 Series Bedienungsanleitung

Havis

Havis TC-106 Bedienungsanleitung

Havis

Havis DS-PAN-801 Bedienungsanleitung

Havis

Havis DS-PAN-401 Bedienungsanleitung

Havis

Havis DS-GTC-220 Series Bedienungsanleitung

Havis

Havis DS-DELL-101 Bedienungsanleitung

Havis

Havis DS-GTC-226 Bedienungsanleitung

Havis

Havis DS-PAN-211 Bedienungsanleitung

Havis

Havis DS-PAN-701 Bedienungsanleitung

Havis

Havis DS-PAN-1101 Bedienungsanleitung

Havis

Havis DS-GTC-1100 Series Bedienungsanleitung

Beliebte Dockingstation Handbücher anderer Marken

Sony

Sony Dream Machine XDR-DS12iP Bedienungsanleitung

Acer

Acer USB Type-C Dock II Bedienungsanleitung

ATEN

ATEN UC-2000 Bedienungsanleitung

Xcellon

Xcellon HDD-202 Bedienungsanleitung

Dok

Dok CR09 Bedienungsanleitung

Philips

Philips BTM630/12 Bedienungsanleitung

IOGear

IOGear Travel Pro GUD3C09 Bedienungsanleitung

RKI

RKI SDM-E2 Bedienungsanleitung

iHome

iHome iP15 Bedienungsanleitung

VITURE ONE

VITURE ONE MOBILE DOCK Bedienungsanleitung

Lindy

Lindy 42984 Bedienungsanleitung

CipherLab

CipherLab 8001 Bedienungsanleitung

Pyle

Pyle PIPDSP2 Bedienungsanleitung

Avol

Avol AS2350 Bedienungsanleitung

Datalogic

Datalogic JoyaTouch Bedienungsanleitung

Philips

Philips DC190/79 Bedienungsanleitung

Targus

Targus DOCK315EUZ Bedienungsanleitung

Akasa

Akasa DuoDockX3 AK-DK08U3-BK Bedienungsanleitung