Hayward Navigator Series Bedienungsanleitung

Hayward Pool Products

620 Division Street, Elizabeth, NJ 07201

908.351.5400 • Hayward.com

NAVIGATOR®/POOLVAC SERIES

Suction Pool Cleaner

Owner’s Manual

TURBINE SUCTION CLEANER SAFETY WARNINGS

FOR YOUR RECORDS

Owner’s Manual

Congratulations on your purchase of your Hayward automatic suction pool

cleaning system. Your Cleaner is the smart, ecient way to clean your in-ground

pool.

Hayward Turbine Cleaners are powered by your pool’s ﬁlter system and are

designed to work well with most systems. The performance of the Cleaner in your

pool will be relative to its power source. Because the operation and performance

of the Cleaner are system reliant, there is a remote possibility

that a service call may be necessary to complete the proper installation of your

Cleaner. This call will be at the consumer’s expense.

Lastly, one or more of the accessories designed for the Cleaner, including

additional hose* sections, might be applicable to your installation. Consult

your Hayward dealer for prices and availability. For Technical Assistance,

call Hayward at 908.355.7995 (USA only).

Purchase Date:

Serial Number:

DO NOT use to remove large debris in new pools.

REMOVE cleaner and hose before adding ANY chemicals to your pool.

DO NOT swim with cleaner.

Store the cleaner in a shaded safe area.

Hoses must be stored straight. DO NOT coil the hose.

KEEP AWAY from children and pets.

REMOVE cleaner when performing backwash.

REMEMBER safety ﬁrst.

For complete warnings and safety information visit Hayward.com

KEY

Attention

Tip Pressure Adjustment

Pump

CARTON CONTENTS PREPARING THE POOL

Please complete the following steps

to prepare your pool for installation:

DEBRIS

Remove any large objects and

excessive debris from the pool.

WATER LEVEL

Conﬁrm that water level is at the

recommended level.

WATER CHEMISTRY

Make sure water is properly

balanced and that the pool is free

from algae.

FILTER

Clean or backwash the ﬁlter.

Clean the hair and lint prior to

installing the Cleaner.

Connector/Leader Hoses

PoolVac V-Flex / Navigator V-Flex:

x9 Connectors

x1 Leader

PoolVac - PoolVac XL - Navigator -Navigator Pro

x7 Connectors

x1 Leader

Accessory Kit

Navigator Pro®

Connector

Leader

VO94

Regulator

Valve

V093C

Cone

Adapter

Pressure

Gauge pH: 7.2 - 7.8

Chlorine: 1.0-3.0 P.P.M

Total Alkalinity: 80 - 120 P.P.M

INSTALLATION

Sizing Suction Hose

Step 1

Connect hose sections.

Note: Make sure all connections

are tight to prevent air leaks.

TIP: Wetting the hose ends will

make it easier to connect the hose

sections.

If optional Leaf Canister is purchased, install between 1st and 2nd

hose sections.

Step 2

Pull hose to farthest point of the pool + 2 extra hose sections.

Step 3

Fill hose completely with water.

Insert Flow Gauge into the leader

hose. Attach the C-Clip of the

gauge onto the 1st hose section.

Make sure the Flow Gauge is under water.

V574 FLOW

GAUGE

C-CLIP

LEADER HOSE

FIRST HOSE

SECTION

TO SKIMMER

OR VAC-LOCK

INSTALLATION

Step 4

Connecting to Skimmer:

Connect the V093C Skimmer

Cone adapter to tapered male

end of the vacuum hose.

Connecting to Hayward

Vac Lock:

Insert the hose end directly into

the Vac Lock without using the

cone.

Step 5

Check the water ﬂow reading on

the Flow Gauge.

The black disk should be between

the “MIN” and “MAX” markings.

If the disk is in the proper location,

move on to step 6.

If the black disk is outside of the box on the “MAX” side and you

have connected your hose to the skimmer, reduce the vacuum/

water ﬂow by using one of the following:

• Suction Valve(s) in the ﬁlter system

• Hayward V094 Regulator Valve

• An optional Hayward Automatic Skimmer Vacuum Plate*

CLEANER HOSE

V093C CONE

ADAPTER

V094 REGULATOR

VALVE

V093C CONE

ADAPTER

TO MAIN DRAIN

(if applicable)

TO PUMP

To install the VO94 Regulator Valve:

1. Remove the hose from the V093C Skimmer Cone

2. Close the Regulator Valve by rotating the blue collar clockwise

until tight.

3. Insert the Valve into the Skimmer Cone and the hose end into the

Valve.

4. Turn the ﬁlter system on and allow it to eliminate any air in the

system.

5. Turn the blue collar clockwise until proper reading appears.

*Follow the installation instructions included with the Skimmer Vacuum Plate.

Reading Too High?

1110

INSTALLATION

Reading Too Low?

An initial vacuum reading that is TOO low to meet the water ﬂow

setting necessary to operate the Cleaner is indicative of a system

problem, and not a problem with the Cleaner.

The Regulator Valve and Skimmer Vacuum Plate cannot be used

to INCREASE the initial vacuum reading.

View our YouTube video or contact your authorized Hayward

Dealer for assistance.

Step 6

Step 7

Submerge the Cleaner into the water to remove all air. Fill hose

completely with water.

Step 8

1312

FINE ADJUSTMENTS

Your Cleaner should move about

the pool without spending an

excessive amount of time against

the steps or other obstructions.

If the cleaner seems to get “hung

up,” turn the rear ﬂapper adjuster

to Position I.

• Not Climbing the Walls or Stays on the Floor

• Sticking on Steps/Liner/Obstacles

If the Cleaner does not seem to be

“sticking” to the wall, turn the rear

ﬂap adjuster to Position III.

• Sucking Air At Surface or Climbing Too High

Be aware that your Cleaner will climb the vertical walls in concrete

and ﬁberglass pools if there is at least a seven inch (7”) radius

where the walls and ﬂoor meet.

Due to the programmed steering, the Cleaner will not climb a wall

every time it comes into contact with one.

7” +

SUCTION

1514

IMPORTANT TIPS

Periodically check the water ﬂow/vacuum to be sure that your

Cleaner is operating as eciently as possible.

Remember, too much vacuum is just as bad as too little.

Periodically check to make sure that the Cleaner hose is securely

attached to its suction source (i.e. Skimmer, Skimmer Vac Plate,

Vac Lock, etc.)

Disconnect the Cleaner hose from the Skimmer/Regulator Valve,

or, if using a “dedicated line,” turn cleaner valve o prior to

“backwashing”, so as not to restrict water ﬂow.

DO NOT COIL HOSE

When storing your Cleaner, the hose sections must be stored

straight. A coiled hose will create a memory in the hose that will

impede the Cleaner’s ability to move properly.

Coiled hoses are not covered under the Hayward Warranty.

Use only original Hayward spare parts and hoses to insure proper

operation.

When the Cleaner is out of the pool, always disconnect the leader

hose from the Cleaner’s head.

1716

MAINTENANCE TIPS

Check the condition of the “shoes, wings, and ﬂaps” periodically.

WEAR MARK

GOOD SHOE WORN SHOE

WEAR LINE

Hayward not responsible for damage caused by worn or broken

parts. Or damage caused by misuse of the cleaner.

Step 2

Step 1

Shoe Replacement:

1918

Wing Replacement:

Step 1

Step 2

MAINTENANCE TIPS

Step 3

Step 4

Andere Handbücher für Navigator Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hayward Schwimmbadroboter Handbücher

Hayward

Hayward TigerShark Bedienungsanleitung

Hayward

Hayward DYNA-SKIM SP1091LX Bedienungsanleitung

Hayward

Hayward TRX-20 Bedienungsanleitung

Hayward

Hayward TigerShark QC Bedienungsanleitung

Hayward

Hayward 2 wheel Bedienungsanleitung

Hayward

Hayward Navigator V-Flex Bedienungsanleitung

Hayward

Hayward Navigator Bedienungsanleitung

Hayward

Hayward DV4000 Bedienungsanleitung

Hayward

Hayward TriVac 500 Bedienungsanleitung

Hayward

Hayward Aquabug Bedienungsanleitung

Hayward

Hayward Navigator Pro Bedienungsanleitung

Hayward

Hayward Navigator Bedienungsanleitung

Hayward

Hayward Navigator Pro Konfigurationshandbuch

Hayward

Hayward AquaVac 250Li Bedienungsanleitung

Hayward

Hayward Aquabug Bedienungsanleitung

Hayward

Hayward SharkVAC XL Bedienungsanleitung

Hayward

Hayward Pool Vac Ultra Bedienungsanleitung

Hayward

Hayward DV5000 Bedienungsanleitung

Hayward

Hayward ABOVE GROUND SERIES Bedienungsanleitung

Hayward

Hayward Navigator Bedienungsanleitung

Hayward

Hayward Navigator Pro Bedienungsanleitung

Hayward

Hayward TriVac 700 Bedienungsanleitung

Hayward

Hayward Pool Vac Ultra Bedienungsanleitung

Hayward

Hayward Navigator Bedienungsanleitung

Beliebte Schwimmbadroboter Handbücher anderer Marken

POOLGOODS

POOLGOODS PoolGobbler Pro Bedienungsanleitung

Maytronics

Maytronics Dolphin POOL UP Bedienungsanleitung

iRobot

iRobot Verro 600 Bedienungsanleitung

Kokido

Kokido SKOOBA K535CBX/18/EU Bedienungsanleitung

SmartPool

SmartPool Robo-Kleen PLUS Bedienungsanleitung

Brilix

Brilix BARACUDA Bedienungsanleitung

Aiper

Aiper Orca 1200 Pro Bedienungsanleitung

Polaris

Polaris Vac-Sweep 380 Bedienungsanleitung

Pentair

Pentair Prowler 710 Bedienungsanleitung

BWT

BWT D500 Bedienungsanleitung

Kokido

Kokido xtrovac 70 Bedienungsanleitung

Pentair

Pentair RACER Bedienungsanleitung

Pentair

Pentair REBEL 2 Bedienungsanleitung

Zodiac

Zodiac VX55 4WD Bedienungsanleitung

SmartPool

SmartPool Robo Kleen Plus Bedienungsanleitung

Steinbach

Steinbach Twin Bedienungsanleitung

STA-RITE

STA-RITE PoolShark Vacuum Bedienungsanleitung

Zodiac

Zodiac Baracuda G3 Bedienungsanleitung