Haztec 7-7250 Bedienungsanleitung

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 1 - June 2021

Thank you for purchasing this Haztec product. Before proceeding with installation, it is essential to

read and understand this instruction booklet.

▪This product must be installed by persons competent in vehicle electrical installations

▪Care should be taken to ensure that water ingress cannot occur through mounting or

wiring holes

▪Regularly inspect the product to confirm correct operation

▪DO NOT stare directly into the light it produces as permanent damage to the eyes may

result

▪Use only a mixture of mild soap and water to clean this product

▪DO NOT direct a high-pressure water jets at this product

▪DO NOT allow solvents, fuels or acetone-based cleaners etc. to come into contact with

this product

Basic Operating Specifications:

Supply voltage range:

12/24VDC

Maximum current draw:

4A @ 12V / 2A @ 24V

Fuse rating:

Standby current:

0.02A @ 13.8V

Operating temperature range:

-30OC to +70OC

LED power:

50W

LED :

10 x Cree high power

Beam peak intensity:

59377cd

Beam distance:

485m

Beam pattern:

Spot

Operating distance:

65m

Radio frequency:

433.92Mhz

▪3045 lumen light output

▪25Obeam angle horizontal & vertical

▪Full 360Ocontinuous rotation

▪+90O~ -30Otilt angle

▪Fast & slow modes

▪Auto-park function

▪DIM function

▪Auto-park feature

▪Wireless remote or wired operation

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 2 - June 2021

Connection Instructions:

Wire

Connect to

Function

Red

Positive [+] via fuse

Main feed

Red/Black

Negative [-]

Ground/Earth

Control Loom

Green

Positive [+] momentary

switched output

Power On/Off

Orange

Positive [+] switched output

Red

Down

Brown

Left

Yellow

Right

Purple

Fast/Slow

Blue

Dim

Black

Negative [-]

Ground

Wireless Remote Operation:

▪Press the power button to switch the Searchlight on or off. The Searchlight will auto-park

when switched off

▪Operate the Searchlight by pressing the directional buttons

Up = Down = Left = Right =

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 3 - June 2021

▪Press the Fn button to change between slow and fast operation

Wireless Remote Programming:

▪Switch off the DC power or disconnect from battery

▪Ensure there is no other transmitter operating at the same time

▪Switch on the DC power and within 5 seconds press the Remote Up and Down

buttons simultaneously

▪The Searchlight will flash to acknowledge connection with the Remote

▪To program a second Remote (upto 4 Remotes can be used with the same Searchlight.

Programming a 5th will replace the first); Within 5 seconds of programming the first remote,

press the up and down buttons simultaneously on the second Remote or repeat from

step 1

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 4 - June 2021

CAUTION! Transit packaging is fitted to this product. Please ensure that it is fully removed before

attempting to operate the device

Installation:

1. Remove the 4 x M4 sockets screws from the

dome lens. Each screw has an ‘O’ ring fitted.

Make sure to keep these safe for future use

2. Carefully remove the dome lens and the

transit packaging from the LED module

3. Ensure that the surface where the Searchlight

is to be mounted is clean and dry. Position

the base seal onto the surface ensuring

that the cable entry hole is positioned

towards the rear of the vehicle

Cable

entry

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 5 - June 2021

4. Mark the position of the 4 mounting holes

and the cable entry hole, remove the seal

and drill them to accept the M6 x 35mm

socket screws and power cable

5. Ensure there is no swarf and that the holes are deburred. A customer supplied rubber

grommet should be used to prevent cable damage. Position the base seal so that the

mounting holes align

6. Pass the power cable and control loom through the cable entry hole and position the

Searchlight onto the base seal, ensuring that it is seated correctly

7. To access the Searchlight mounting holes; remove the 3 x screws from the main

housing

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 6 - June 2021

8. Secure the Searchlight in place using the 4 x M6 x 35mm cap screws and nyloc nuts

N.B. Tighten the cap screws to a maximum torque of 2.75Nm. This value is critical to

prevent ingress. Verify using a calibrated torque wrench

9. Replace the Searchlight housing and secure in place with the 3 x fixing screws –hand

tighten only

2.75Nm

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 7 - June 2021

10. Re-fit the dome lens ensuring that the seal is seated correctly on the base

11. Secure the lens in place using the 4 x M4 x 16mm socket screws and ‘O’ ring seals

provided

N.B. Tighten the socket screws to a maximum torque of 0.65Nm –this value is critical

to prevent ingress. Verify using a calibrated torque wrench

0.65Nm

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 8 - June 2021

Basic Dimensions:

Haztec International Ltd ∙ Moorfield Road ∙ Leeds ∙ LS19 7BN ∙ UK

T: +44(0)113 202 9115 ∙ inf[email protected] ∙ www.haztec.uk

7-7250 LRS LED

Remote Control Searchlight

M104.1.2 - 9 - June 2021

Kit Contents:

Qty

Part

Description

7-7250-S

LRS LED 12/24V 50W Searchlight

7-7250-DOME

Dome lens

7-7250-DS

Dome seal

7-7250-BS

Base seal

M6 x 35mm socket cap screw

9-00121-002

M6 nyloc nut

M4 x 16mm socket screw c/w ‘O’ ring

Control loom

Remote controller

Andere Haztec Scheinwerfer Handbücher

Haztec

Haztec 7-7250-M LRS LED Bedienungsanleitung

Beliebte Scheinwerfer Handbücher anderer Marken

VIZULO

VIZULO Micro Martin Benutzerhandbuch

EuroLite

EuroLite LED IP FL-100 SMD Bedienungsanleitung

Cooper Wheelock

Cooper Wheelock XB12 Bedienungsanleitung

Allen + Roth

Allen + Roth 17624-000 Bedienungsanleitung

ADJ

ADJ 4 STAGE PAK Bedienungsanleitung

Cooper Lighting

Cooper Lighting EGL91SW233 Bedienungsanleitung

Max

Max 37496 Bedienungsanleitung

BEGA

BEGA 85 143 Bedienungsanleitung

Beamz

Beamz 151.226 Bedienungsanleitung

EuroLite

EuroLite LED IP FL-8 Bedienungsanleitung

Ledj

Ledj PERFORMER 36 RGB Bedienungsanleitung

Perel

Perel ELS3 Bedienungsanleitung

Perel

Perel ELS3WD Bedienungsanleitung

LumX

LumX LM 36130 Bedienungsanleitung

Xtricity

Xtricity 4-80053 Bedienungsanleitung

Stahl

Stahl 6521/4 Series Bedienungsanleitung

Ecosense

Ecosense EcoSpec Bedienungsanleitung

Ayrton

Ayrton minipanel FX Bedienungsanleitung