Heat & Glo LOGS-2531 Bedienungsanleitung

Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 1. Log Identication

Figure 3. Log #1 Installed

CAUTION: Logs are fragile, handle with care.

NOTICE: To simplify the installation process, use

Figure 1 to positively identify each individual log

before beginning installation.

Figure 2. Empty Firebox with Front Hearth Installed

LOG #1: Locate the cutout on Log #1, place it over the pilot hood and set the log on the left side of the rebox. Rotate Log

#1 clockwise until it contacts log pin A and the rebox wall. Ensure that the end of Log #1 is in contact with the air scoop.

See Figure 3.

LOGS-2531, LOGS-2532, LOGS-2533

MODELS: SUPREME-I25-IFT, SUPREME-I30-IFT, SUPREME-I35-IFT, I30X-AU

Installation Instructions

CAUTION! Risk of Cuts or Abrasions. Wear protective

gloves and safety glasses during installation.

Leave this manual with party responsible for use

and operation.

MODEL: SUPREME-I25-IFT

PILOT HOOD

AIR SCOOP

12345

SUPREME-I25-IFT SRV LOGS

LOG ID SRV PART # MOLDED LOG #

1SRV2531-711 31-1

2 SRV2531-712 31-2

3SRV2531-713 31-3

4SRV2531-714 31-4

5 SRV2531-715 31-5

LOG #2: Set Log #2 on the burner between pins B and C. Rotate the log counter clockwise until it contacts both pins B and

C and slide it back until it contacts the Air Scoop. Ensure Log #2 is not covering any ports. See Figure 4.

Figure 4. Log #2 Installed

SHOULDER SCREW

AIR SCOOP

2Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 7. Log #5 Installed

LOG #5: Place the non-bark end of log 5 on the at spot of log 3. The front right corner on the other end of log 5 will sit at

the intersection of the grout lines on the base refractory. See Figure 7.

Figure 6. Log #4 Installed

Figure 5. Log #3 Installed

LOG #3: With the burnout of Log #3 facing left, line the big end up with the edge of the basepan and the rebox wall or

refractory. The small end will sit half on the end of Log #2 and half on the air scoop as shown in Figure 5.

LOG #4: The Y-end of Log #4 should sit on the at spot of Log #2, the other end will sit on the at spot of Log #1. See Figure 6

GROUT LINE

Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 11. Empty Firebox with Front Hearth Installed

Figure 12. Log #1 Installed Figure 13. Log #2 Installed

MODELS: SUPREME-I30-IFT, I30X-AU

PILOT HOOD

AIR SCOOP

LOG #1: Locate the cutout on the end of log 1 and place over the pilot hood and air scoop. The other end of Log #1 will sit

against log pin A. See Figure 12.

LOG #2: With the bark end of Log #2 towards the back of the rebox, set the log onto the burner behind log pins B and C

as shown in Figure 13. Rotate the log counter clockwise so that it contacts the air scoop, along with pins B and C.

AIR SCOOP

Figure 10. Log Identication

12345

NOTICE: To simplify the installation process, use Figure 10 to positively identify each individual log before beginning

installation.

SUPREME-I30-IFT, I30X-AU SRV LOGS

LOG ID SRV PART # MOLDED LOG #

1SRV2532-711 32-1

2 SRV2532-712 32-2

3SRV2532-713 32-3

4SRV2532-714 32-4

5 SRV2532-715 32-5

4Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 16. Log #5 Installed

LOG #5: The non-burnout end of log 5 will sit on the at spot of log 3. The corner of the other end will sit on the base

refractory grout line. See Figure 16.

Figure 15. Log #4 Installed

LOG #4: Set the non-Y end of Log #4 on the at spot of Log #1. The end of the log #4 will sit ush with the back of Log #1.

The Y-end of log #4 will sit on the at spot of Log #2. See Figure 15.

LOG #3: With the burnout of Log #3 facing left, set the large end against log pin D, place the small end on the at spot of

Log #1. See Figure 14.

Figure 14. Log #3 Installed

123

GROUT LINE

Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 18. Empty Firebox with Front Hearth Installed

Figure 19. Log #1 Installed Figure 20. Log #2 Installed

MODELS: SUPREME-I35-IFT

PILOT HOOD

AIR SCOOP

LOG #1: Locate the cutout on the end of Log #1. The other end of Log #1 will set between log pins A and B. Rotate the

cut-out end back until the cut-out fully engages the air scoop. See Figure 19.

LOG #2: The short side of the Y on Log #2 will sit between log pins D and E, the long end of the Y will sit against log pin C.

The opposite end of Log #2 will sit on the air scoop. See Figure 20.

1 2

Figure 17. Log Identication

12345

NOTICE: To simplify the installation process, use Figure 17 to positively identify each individual log before beginning

installation.

SUPREME-I35-IFT SRV LOGS

LOG ID SRV PART # MOLDED LOG #

1SRV2533-711 33-1

2 SRV2533-712 33-2

3SRV2533-713 33-3

4SRV2533-714 33-4

5 SRV2532-715 33-5

6 SRV2538-715 33-5

AIR SCOOP

6Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19

Figure 23. Log #5 Installed

LOG #5: The non-burnout end of Log #5 will sit on the at spot of Log #3. The corner of the other end will sit on the base

refractory grout line. See Figure 23.

Figure 22. Log #4 Installed

LOG #4: Set the non-Y end of log 4 on the at spot of Log #1. The end of Log #4 will sit ush with the back of Log #1. The

Y-end of Log #4 will sit on the at spot of Log #2. See Figure 22.

LOG #3: With the burnout facing left, place the big end of Log #3 against log pin F and slide back until it contacts log pin G

as shown in Figure 21. The small end will sit on the at spot of Log #2.

Figure 21. Log #3 Installed

Figure 24. Log #6 Installed

Figure 25. Log #6 Installed

LOG #6: Slide the burn out end of Log #6 between log #5 and log #3. Push the log back until it touches the rebox. The

left side will touch pin H. The right side of the log touches Log #3. See Figures 24 and 25.

Dieses Handbuch passt für folgende Modelle

Andere Heat & Glo Kamin im Innenbereich Handbücher

Heat & Glo

Heat & Glo EXCLAIM-36 Bedienungsanleitung

Heat & Glo

Heat & Glo 8000TRC Montageanleitung

Heat & Glo

Heat & Glo MEZZO36 Bedienungsanleitung

Heat & Glo

Heat & Glo LCOR-36TRB-IPI Bedienungsanleitung

Heat & Glo

Heat & Glo 6000GBV Bedienungsanleitung

Heat & Glo

Heat & Glo FB-GRAND Bedienungsanleitung

Heat & Glo

Heat & Glo 6000GL-IPI-S Bedienungsanleitung

Heat & Glo

Heat & Glo SL-5 Bedienungsanleitung

Heat & Glo

Heat & Glo EXCLAIM-50 Bedienungsanleitung

Heat & Glo

Heat & Glo EM-415 Bedienungsanleitung

Heat & Glo

Heat & Glo NORTHSTAR-BK Bedienungsanleitung

Heat & Glo

Heat & Glo SL-5F Bedienungsanleitung

Heat & Glo

Heat & Glo RED60 Bedienungsanleitung

Heat & Glo

Heat & Glo TRUE-36C Bedienungsanleitung

Heat & Glo

Heat & Glo TIARII-BK-IPI Bedienungsanleitung

Heat & Glo

Heat & Glo 6000CLX-IFT-S Bedienungsanleitung

Heat & Glo

Heat & Glo SOHO24B Leitfaden

Heat & Glo

Heat & Glo TRUE-36G-IFT Bedienungsanleitung

Heat & Glo

Heat & Glo FDN-5-PIER Bedienungsanleitung

Heat & Glo

Heat & Glo SL350TRSI-N-CE Bedienungsanleitung

Heat & Glo

Heat & Glo SL-550TR-E Bedienungsanleitung

Heat & Glo

Heat & Glo Bravo Bedienungsanleitung

Heat & Glo

Heat & Glo Wood Burning Fireplace HST-48D Bedienungsanleitung

Heat & Glo

Heat & Glo Grand-XTS Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch