HEPER LF8035.523-US Montage- und Bedienungsanleitung

1/3 2022-1 / 25/05/2022

Installation & Maintenance

Instructions

HEPER USA LLC

W227 N546 Westmound Drive Waukesha, 53186

Wisconsin, United States

+1 312 910 9740

[email protected]

REGIO 3 Module (LF8035.523-US)

79 lbs

https://heperlighting.com/us/lf8035.523-us/

2/3

3/3

English ( USA )

Safety

- The product must be installed in accordance with applicable

NEC standards by a qualified electrician familiar with the

installation of exterior lighting fixtures.

- The product must be operated under specified voltage at all

times.

- Do not install if parts are damaged.

- Power must be disconnected while installing or servicing to

avoid electrical shock.

- Failing to comply with warnings and installation steps in this

document might void warranty.

- Do not touch the light source.

- Make sure that temperature of the product is at a safe level before

touching.

- Do not allow cables to touch sharp edges of metal parts or other sharp

objects to avoid damage or abrasion.

- Check all of the cable connections including grounding before

powering the product.

- Check the proper grounding of the metal housing before powering the

product.

- Only use the product for its intended purposes.

- Do not use accessories not approved or recommended by

HEPER.

- Replace any broken/cracked protective surface with a new

one

- Carefully hold the LED light module, while the bolt is loosened

for angle arrangement and be careful not to get your hand

stuck.

Installation

- The surface on which the product will be mounted must be flat and

level

- Holes should be opened on the surface the product will be mounted

and the product should be placed as shown on the visual

- The base angle adjustment should be made according to the direction

of the area to be illuminated Note: The base angle is max ± 13 °

- To connect the product with the mains, use a minimum IP 66 rated

connector. Note: IP connectors are not provided with the product.

- If the product has 1 or 2 modules, proceed directly to step 5. For the 3-

module product, make the terminal connections in the connection box

as shown in the visual.

- You can adjust the light angle settings by loosening and tightening the

nut as shown.

Replacement of the light source

- Disconnect the power coming into the product.

- Unscrew and detach the LED Module as shown on the visual.

- Reinstall the product following the same steps.

Replacement of the control gear

- Disconnect the power coming into the product.

- Unscrew the driver box cover to access the driver location as shown in

the image.

- Detach the driver and place the new one.

- Reinstall the product following the same steps.

Cleaning - Maintenance

- The product was designed and manufactured to operate for a long

period of time. To ensure maximum lifespan of the product, regular (i.e.

every six months) visual inspection and cleaning with a solvent-free

cleaner using a soft cloth is recommended.

- Do not clean or service while the product is power connected.

Disposal

- In accordance with EU Directive WEEE (Waste Electrical and

Electronic Equipment), luminaires must not be disposed of with

other household waste. At the end of their life, luminaires must

be taken to the appropriate local facility available for the

disposal or recycling of electronic products.

Wiring Color Codes

- Ground - GREEN

- Line - BLACK

- Neutral - WHITE

- Dim(+) - RED/PURPLE

- Dim (-) - GRAY/ORANGE

Disclaimer

- HEPER reserve the right to make technical and design changes.

Dieses Handbuch passt für folgende Modelle

Andere HEPER Außenleuchte Handbücher

HEPER

HEPER NORMA Montage- und Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

HEPER

HEPER DOMINO AFX 2 Module Montage- und Bedienungsanleitung

HEPER

HEPER NORMA L Montage- und Bedienungsanleitung

HEPER

HEPER MINIMO 4x90 Montage- und Bedienungsanleitung

HEPER

HEPER MINIMO 3x90 Montage- und Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

HEPER

HEPER DOMINI AFX MIDI 1 Module Montage- und Bedienungsanleitung

HEPER

HEPER DOMINO AFX 1 Montage- und Bedienungsanleitung

HEPER

HEPER DOMINI 12 LED Montage- und Bedienungsanleitung

HEPER

HEPER TURA LL2036.756-US Montage- und Bedienungsanleitung

HEPER

HEPER PRIFMA ML EVO 1 Montage- und Bedienungsanleitung

HEPER

HEPER HANDRA LH5007.595-US Montage- und Bedienungsanleitung

HEPER

HEPER KREIS C Montage- und Bedienungsanleitung

HEPER

HEPER LL2031.511-US Montage- und Bedienungsanleitung

HEPER

HEPER TURA 2x16 LED Montage- und Bedienungsanleitung

HEPER

HEPER LF8019.698-US Montage- und Bedienungsanleitung

HEPER

HEPER LL2030.861-US Montage- und Bedienungsanleitung

HEPER

HEPER TILA S AFX 3 Module Montage- und Bedienungsanleitung

HEPER

HEPER PRIFMA AFX 1 Module Duo Montage- und Bedienungsanleitung

HEPER

HEPER PUNTO S Ex Montage- und Bedienungsanleitung

HEPER

HEPER DOMINO AFX 3 Module Montage- und Bedienungsanleitung

HEPER

HEPER LP4024.537-US Montage- und Bedienungsanleitung

HEPER

HEPER TROLI LB6009.693 Montage- und Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

NEBO

NEBO NEB-LSP-0020 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung

LIGMAN

LIGMAN DE-20023 Bedienungsanleitung

Spectroline

Spectroline MAXIMA ML-3500 Series Bedienungsanleitung

Pro-Elec

Pro-Elec PELL0264 Bedienungsanleitung