HID ICLASS R10 Bedienungsanleitung

Installation Guide

iCLASS™Reader Models R10, R30, R40, RW300, RW400

An ASSA ABLOY Group company ASSA ABLOY

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page - www.hidcorp.com e-mail – [email protected] iClass™ Reader Installation Manual 6090-900 Rev 8 Page 1of 3

PARTS INCLUDED SPECIFICATIONS

•1 -

iCLASS Reader •R10 (Mullion)……………..10 - 16VDC / 65-225mA

•1 - Installation Manual •R30/RW300 (Euro)………10 - 16VDC / 80-260mA

•2 - 3.5mm x .6 pitch x 12mm Phillips machine screws •R40/RW400 (US)………...10 - 16VDC / 80-260mA

•3 - #6-32 x .375” Phillips self-tapping machine screws •Cable distance to Host…..Wiegand - 500 feet (152m) max

•2 - #6 x 1.5” Phillips sheet metal screws RS-232 - 50 ft (15m)

•1 - #6 x .375” Spanner security screw, anti-tamper •Temperature………………-35° C to 65°C

Recommended: •Open collector output…….sink - 40mA, source - 1mA

•Up to 9 wire splices Standards:

•Cable, 5-9 conductor (Wieg. or RS232), 22awg shielded •Read/Write* capability in ISO 15693-2 mode with HID

•Linear DC Power supply iCLASS credentials

•Metal or plastic junction box •Read/Write* capability in ISO 14443-B2 mode with HID

•Magnetic switch - Ademco 945T, Sentrol 1038T, GRI 100T iCLASS 16Ks and other 3rd party credentials

or 110T or Aleph DC-2531 •CSN read capability for ISO 14443-A1 with HID Mifare

•Security Tool (for anti-tamper screw) HID 04-0001-03 and other 3rd party Mifare credentials

* R10, R30, R40 are read-only

INSTALLATION

1- Disassemble

2 - Lift Bottom of Bezel 4 - Lift top of Reader Assembly

1- Remove Screw 3 - Slide Bezel up and remove 5 - Slide down and remove

2- Install Tamper Switch

An internal magnet provides tamper indication when used with a magnetic reed switch connected to an external alarm

system. (Except R10). Locate Switch behind the left side of the mounting plate, centered between the mounting holes.

Electrical Back Box Wall Surface

Installation Guide

iCLASS™Reader Models R10, R30, R40, RW300, RW400

An ASSA ABLOY Group company ASSA ABLOY

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page - www.hidcorp.com e-mail – [email protected] iClass™ Reader Installation Manual 6090-900 Rev 8 Page 2of 3

3- Preparing/Mounting

Install Mounting Plate to wall surface or back box, then reassemble reader (reverse Step 1 procedure).

Dimensions are in inches (centimeters).

R10 Mounting Plate R30/RW300 Mounting Plate R40/RW400 Mounting Plate

4- Connecting 5- Testing

Yellow *Speaker

Blue *Hold

•Turn Power On - watch the sign-on LED and hear the

speaker tones sequence.

Violet ***Open Collector

White Data 1

•Use a Test Card - watch for the LED flash and hear the

Speaker tone for each card read.

Green Data 0

Orange *GreenLED 6- Optional Features

Brown *Red LED

Red +DC (10-16 VDC)

•RS232 interface/Host Mode - for applications requiring a

serial link. See Protocol Document 6090-902 for information

Black Ground

Gray ***RX (Serial Receive)

•Open Collector Output – controls an external device

(13.8VDC Max) operating in Host Mode only. See iCLASS

Application Note for details

Red/Green ***DSR (Not Used)

Pink ***TX (Serial Transmit)

•Configuration Options - Configure LED, Speaker, and other

features. See How To Order Guide or iCLASS Application

Note for details

Installation Guide

iCLASS™Reader Models R10, R30, R40, RW300, RW400

An ASSA ABLOY Group company ASSA ABLOY

_____________________________________________________________________________________________________

HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690

Web page - www.hidcorp.com e-mail – [email protected] iClass™ Reader Installation Manual 6090-900 Rev 8 Page 3of 3

Red/Yellow ***DTR (Not Used)

Drain **Shield Ground

•Hold Input – when asserted, this line either buffers a card

read or disables a card read until released, as configured.

* Optional Connections. **Drainwire canbe data returnline whena separate power supplyis used. *** Not used on R10, R30, R40

FCC WARNING:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation. For proper regulatory compliance, the drain wire should not be connected to ground at the power supply

end of the cable. The reader is intended to be powered from a limited power source output of a previously certified power supply.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HID Kartenleser Handbücher

HID

HID ProxPro II 5455 Bedienungsanleitung

HID

HID iCLASS R10 Bedienungsanleitung

HID

HID iCLASS SE U90 Series Bedienungsanleitung

HID

HID iCLASS SE R10F Bedienungsanleitung

HID

HID Signo Series Bedienungsanleitung

HID

HID iCLASS R10 Bedienungsanleitung

HID

HID iCLASS SE U90 Series Bedienungsanleitung

HID

HID Mercury MR62e Bedienungsanleitung

HID

HID iCLASS bio500 Bedienungsanleitung

HID

HID iCLASS RK40 Bedienungsanleitung

HID

HID multiCLASS RMK40 Bedienungsanleitung

HID

HID pivCLASS R10-H Bedienungsanleitung

HID

HID ProxPro II Reader Bedienungsanleitung

HID

HID MaxiProx 5375A Bedienungs- und Wartungsanleitung

HID

HID ProxPoint Handbuch

HID

HID iCLASS SE Bedienungsanleitung

HID

HID Signo 20 Bedienungsanleitung

HID

HID iCLASS SE Bedienungsanleitung

HID

HID SmartID SK10 Bedienungsanleitung

HID

HID iCLASS SE Biometric Reader Bedienungsanleitung

HID

HID R10E Bedienungsanleitung

HID

HID MiniProx 5365 Bedienungsanleitung

HID

HID iCLASS R90 Handbuch

HID

HID OMNIKEY 5121 Bedienungsanleitung

Beliebte Kartenleser Handbücher anderer Marken

Lindy

Lindy 43185 Bedienungsanleitung

Lindy

Lindy 43185 Bedienungsanleitung

ViziT

ViziT RD-4F Bedienungsanleitung

Jinmuyu Electronics

Jinmuyu Electronics MR811 Series Bedienungsanleitung

AVID ID

AVID ID AVID1043 Bedienungsanleitung

Conrad

Conrad PCMCIA Bedienungsanleitung

Rosslare

Rosslare DR-6255 Bedienungsanleitung

Lindy

Lindy 51541 Bedienungsanleitung

Diapro T?bbi Ürünler

Diapro T?bbi Ürünler Across System Bedienungsanleitung

Johnson Controls

Johnson Controls Kantech tyco ioSmart Bedienungsanleitung

ACS

ACS ACR122L Bedienungsanleitung

Secukey

Secukey S2-MF Bedienungsanleitung

Elecom

Elecom MR-SMC07 series Bedienungsanleitung

Alien

Alien ALR-9800 Bedienungsanleitung

ACS

ACS ACR310 Bedienungsanleitung

Datamars

Datamars R-IN1300 MID Bedienungsanleitung

Alarm Lock

Alarm Lock AL-PRE2 Bedienungsanleitung

xpr

xpr B100PROX-AH Benutzerhandbuch