5
System setup - Menu page 2 keys
Array address system
Each Array panel used to make an Array Surface has a unique address number (1-4 from left to right), this denotes the position of the Array panel when viewed using software
applications such as Avita and Ancora.
The master panel is the conduit of communications from the Satellite panel(s) to devices connected to the system. Once the user has decided an
order in which to arrange the Array panels, then this has to be dened within the Array system.
»Each Array panel is prescribed a number from left to right (as shown in the diagram) irrespective of being a master or slave
»A single panel is always set as ‘MASTER Addr: 1’
»For two or more Array panels, the master panel will be the panel with the Connector pod or PC base and the number that follows in the
addresses, ‘MASTER’ or ‘SLAVE’, will be determined by their position within the surface
Panel interface COMMS
»Toggle through options by pressing ‘App comms’ key
»Select USB or Network depending on how the Array panel is connected to the computer
Network settings
The default IP address is 192.168.0.96, Subnet Mask: 255.255.255.0, Gateway: 192.168.0.1
»Select the integer to be adjusted, indicated with > or < by pressing the ‘Next IP value’ or ‘Previous IP value’ keys
»Increase the value or decrease the value (press and hold for a faster count)
»Press ‘Exit’ to return to the conguration mode
1234
Configuration mode - Menu page 1 keys
Setting the brightness
The brightness of the keys can be set from a choice of ve levels of brightness from DIM to BRIGHT.
»Press the ‘Bright’ key to toggle through brightness settings of the keys on that panel
»Slave panels always follow the Master panels brightness setting
Screen Saver
The screen saver for an Array panel can be set to O / 1 minute / 30 minutes (default) / 60 minutes / 120 minutes. It is recommended that you use the shortest convenient time to
prolong the life of the displays.
»Press the ‘Screen saver’ button to toggle through the required duration
»The screen saver mode is activated after the set time has elapsed from when the last key was pressed, and deactivated after any button press, wheel or T bar movement
»Slave panels always follow the Master panels screen saver setting
Panel test
»Press the panel test key to enter the panel test mode
»Each key, when pressed, will change colour corresponding to the names on the keys or display
»RGB only - navigation wheel will display position last selected
»If tted, the Jog/Shuttle wheel test is indicated by a pulse count number which increases (clockwise) or decreases (counter clockwise)
»If tted, the T-bar test is indicated by a pulse count number which increases (away from the operator) or decreases (towards the operator)
