8
For deleting the current item of setting, press "C" to delete
3) Steps for timer setting
(I) Select the settings of the serial number
Press the "TIMER SET" button, and the serial number starts blinking
Press the "+" or "-" to change the serial number until you get the serial number that you need to set or modify.
(II) Select date
Press " TIMER SET" button once again, and the cursor on the left side of day starts blinking
Press the "▲" or “▼” keys to move the cursor to the corresponding day, press the "+" to add the corresponding
day, or press "-" to delete the day until you have completed the selection of all dates
(III) Set the start time
Continue to press the " TIMER SET" button, the hour starts blinking
Press the "+" or "-" to adjust the hour
Continue to press the " TIMER SET" button, the minute starts blinking
Press the "+" or "-" to adjust minute
(IV) Set the shutdown time
Then press the "TIMER SET" button, the display is off, and the hour starts blinking
Press the "+" or "-" to adjust the hour.
Continue to press the " TIMER SET" button, the minute starts blinking
Press the "+" or "-" to adjust minute
(V) Set temperature
Then press the " TIMER SET" button, and the temperature set starts blinking. At this moment, the temperature
displayed is normally set temperature, which can be adjusted by pressing "+" or "-"
(VI) Press " TIMER SET" button to continue setting, and press "OK" complete the setting
6. Timer switch
"TIMER ON/OFF" is to control the timed opening and closing
Restart the machine after power is cut off, the timer setting is kept, but the current date and time must be reset
NOTE 1: Press the 1000W button or 2000W button, or IC button to active the heating when timer
ON after finish a timing setting. The heater only has flame effect working if you have not selected
the desired heating.
NOTE 2: Repeat the same procedures to set more timing cycles if required after the 01 timing cycle
is finished.
NOTE 3: When the week timer setting is finished, "TIMER ON/OFF" function can be effective.
Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats (e.g. Due to blocked air vents).
For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least 15 minutes. Reconnect the
supply to the mains and switch on the appliance.
Troubleshooting
