Honeywell AQUATROL AQ25142B Leitfaden

AQ25142B, AQ25144B, AQ25A42B,

AQ25A44B, AQ25242Bor AQ25244B

Control Panel Mounting

LOCATION

Mount the AQ251, AQ25A or AQ252 panel as close as

possible to the connected hydronic system components

(boiler, DHW tank, circulators, etc.) to minimize the length of

wiring between these components and the AQ Control Panel.

The location should be:

• Less than 90% relative humidity, non-condensing

• Between 32° and 125° F (0° to 50° C)

• On an interior wall in a well-ventilated area

• Easily accessible for installation of wires, programming of

the control, and maintenance / diagnostics after installation

(preferably at eye level)

• Free of the possibility of water leakage or spray into the

control

• A sturdy structure such as a stud framed wall, a plywood

panel or separate electrical panel.

USE OF INSTALLATION TEMPLATE

1. Using masking tape, attach the mounting template to

the vertical surface where the panel is to be installed.

Ensure that the template is level before proceeding.

2. Using a sharp pencil, mark the location of the four

mounting screws indicated on the template. Push

sufficiently hard so the pencil cuts through the template

and marks the wall in all four mounting locations.

3. Remove the template from the wall and set aside.

4. Drill holes large enough to accommodate No. 8 or 10

screws and mounting plugs (not included).

5. Once the plugs are placed in the wall, insert the top two

screws until they are extending about 0.5 in. (12.7 mm)

out from the wall.

6. Carefully hang the control panel on the top two screws

and check that the bottom two mounting holes align with

the bottom two plugs already in the wall.

7. Insert the bottom two screws and screw them in

completely so they are snug. Do not overtighten the

screws, or the panel’s plastic housing may be

damaged.

8. Complete the mounting by securing the top two screws

until they are also snug.

MOUNTING TEMPLATE

AQ25142B, AQ25144B, AQ25242BOR AQ25244BCONTROL PANEL MOUNTING

Automation and Control Solutions

Honeywell International Inc. Honeywell Limited-Honeywell Limitée

1985 Douglas Drive North 35 Dynamic Drive

Golden Valley, MN 55422 Toronto, Ontario M1V 4Z9

customer.honeywell.com

® U.S. Registered Trademark

69-1976—03 M.S. Rev. 10-09

69-1976-03

5-7/8 (149)

M25455

AAAQ25142B/ AQ25144B/ AQ25A42B/ AQ25A44B/ AQ25242B/ AQ25244B

13 (330)

THIS TEMPLATE MAY BE USED FOR INSTALLING AN

AQ25142B, AQ25144B, AQ25A42B, AQ25A44B,

AQ25242BOR AQ25244BCONTROL PANEL.

DIMENSIONS IN INCHES (MM).

5/16 (8)

3/16 (5) x (2)

69-1976—03

Dieses Handbuch passt für folgende Modelle

Andere Honeywell Bedienfeld Handbücher

Honeywell

Honeywell Lynx Touch L5100 Installationsanleitung

Honeywell

Honeywell MRP-2002 Bedienungsanleitung

Honeywell

Honeywell MS-9200UDLSE Bedienungsanleitung

Honeywell

Honeywell TrolATemp TZ-3 TotalZone Bedienungsanleitung

Honeywell

Honeywell NOTIFIER NCA-2 Bedienungsanleitung

Honeywell

Honeywell Galaxy Dimension series Kurzanleitung zur Einrichtung

Honeywell

Honeywell Fire-Lite Alarms MS-9600LS Bedienungsanleitung

Honeywell

Honeywell SMX-AUS Bedienungsanleitung

Honeywell

Honeywell ENVIRAZONE PANEL W8835 Bedienungsanleitung

Honeywell

Honeywell AQ254 Series Bedienungsanleitung

Honeywell

Honeywell GF505 Bedienungsanleitung

Honeywell

Honeywell Domonial cmi Bedienungsanleitung

Honeywell

Honeywell Fire-lite ECC-LOC Bedienungsanleitung

Honeywell

Honeywell Notifier NFS2-640 Bedienungsanleitung

Honeywell

Honeywell Vigilon 4 loop Installations- und Betriebshandbuch

Honeywell

Honeywell NOTIFIER SLC Bedienungsanleitung

Honeywell

Honeywell HCM 200 Bedienungsanleitung

Honeywell

Honeywell NOTIFIER ID2000 Series Leitfaden

Honeywell

Honeywell NOTIFIER RP1r Bedienungsanleitung

Honeywell

Honeywell MINI-ZONE 69-1361 Kurzanleitung

Honeywell

Honeywell Galaxy 18Galaxy Betriebsanleitung

Honeywell

Honeywell Notifier ID50 Merkblatt

Honeywell

Honeywell Fire-Lite Alarms MS-9600 Bedienungsanleitung

Honeywell

Honeywell Notifier NFS-320 Technisches Handbuch

Beliebte Bedienfeld Handbücher anderer Marken

RDZ

RDZ PC-HRX Bedienungsanleitung

STG-BEIKIRCH

STG-BEIKIRCH MZ3 Technisches Handbuch

Efka

Efka Variocontrol V810 Bedienungsanleitung

Cebora

Cebora 208-10 Bedienungsanleitung

AMX

AMX AutoPatch CP-15 Bedienungsanleitung

Satel

Satel CA-6 KLED-S Bedienungsanleitung

Evolution

Evolution IQ plus 800 Bedienungsanleitung

Fagor

Fagor 8040 TCO CNC Bedienungsanleitung

AKO

AKO PROCool AKO-17635-2 Bedienungsanleitung

ABB

ABB 6136/30M-101 Bedienungsanleitung

Telikou

Telikou BK-603 Belt Pack Bedienungsanleitung

Mapei

Mapei Mapeheat Thermo Touch Bedienungsanleitung

Bosch

Bosch D9412GV4 Bedienungsanleitung

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries SC-SL4-AE2/1 Bedienungsanleitung

Sminn

Sminn BOX L VF1L EI Bedienungsanleitung

Balboa

Balboa TP600 Bedienungsanleitung

Nice

Nice HSCU1 Technische Daten

Truma

Truma CP plus Bedienungsanleitung