Honeywell ADEMCO 4190SN Montageanleitung

N6450-1V1 2/09 Rev. A

ADEMCO 4190SN

V-Plex®Two-Zone (SIM)

Serialized Interface Module

INSTALLATION AND SETUP GUIDE

General Information

The ADEMCO 4190SN V-Plex®is a 2-

zone expander, which allows use of the

available expansion zones provided by

controls that support V-Plex loop

devices. The 4190SN consists of two

protection loops, known as the left

(primary) and right (secondary) loops.

The left loop can be used for:

•closed-circuit devices, with or with

out EOLR supervision

•open-circuit devices with EOLR

supervision

•fast-response (10 millisecond)

devices.

Follow the chart to the right for

cutting the correct jumpers and

choosing the correct resistor when

using the left loop.

The right loop can be used for:

•closed-circuit devices only

•has no EOLR supervision

•400 millisecond response time.

The jumpers do not affect the

operation of the right loop. The right

loop cannot be used alone.

Supervision

The tamper/supervision response of

the 4190SN is determined by the zone

response type assigned to the left loop

zone. While the system is armed,

tamper/supervisory faults will report

as alarms if the left loop zone is

assigned a burglary response type and

will report as troubles if the left loop

zone is assigned a non-burglary

response type (i.e., fire, panic, aux).

While the system is disarmed, tamper/

supervisory will always report as

troubles.

Programming Notes

Program the unit like any other zone,

according to the alarm control’s

installation instructions. Enter the

following information when prompted

for in programming:

“INPUT TYPE” = “6” (SL—Serial

Number Device)

Left Zone = Loop 1

Right Zone = Loop 2

JUMPERS

USAGE (APPLIES TO

LEFT ZONE – LOOP 1

ONLY)

RED Cut for fast response

(10msec)

BLUE Cut for use with no

EOLR (closed-circuit

only). Doing this

automatically puts an

internal 10K ohm resistor

in series with the zone.

NONE CUT Use the 10K ohm

resistor provided, with

switches in either an

open-circuit or closed

circuit configuration. The

4190SN draws 2mA from

the V-Plex loop in this

mode.

4190SN

TAMPER PINS

(SHORTENED WHEN

COVER IS IN PLACE)

MOUNTING

HOLES (3)

BLUE

JUMPER

TERMINAL ASSIGNMENT

1 (+) POLLING LOOP (+)

2 (-) POLLING LOOP (-)

3 (+) LEFT LOOP 1 (+)

4 (-) COMMON (-)

5 (+) RIGHT LOOP 2 (+)

RPM

+ +

RPM

ALWAYS OBSERVE POLARITY.

ALWAYS CONNECT IN PARALLEL.

SEE TEXT FOR WIRE GUAGE AND WIRE LENGTH LIMITS.

RIGHT LOOP (LOOP 2): FOR N.C. SERIES CIRCUITS

ONLY. USE SEALED (REED) CONTACTS. SEE NOTE 1.

RIGHT LOOP NOT SUPERVISED. SEE UL NOTE 2 BELOW.

LEFT LOOP (LOOP 1): FOR N.C. CIRCUIT (INTERNAL EOLR)

OR N.C. AND/OR N.O. CIRCUIT (EXTERNAL EOLR). SEE

NOTES 2 AND 3. LEFT LOOP SUPERVISED. CLASS B, STYLE B.

SERIAL # ID

4190SN-001-V1

POLLING LOOP - SUPERVISED CLASS B, STYLE 4

CIRCUIT, 25 OHM MAX LINE IMPEDANCE

POLLING LOOP

TERMINALS ON

CONTROL

RED

JUMPER

UL Notes

1. The 4190SN is designed to meet

the following UL standards:

UL609 Commercial Burglary,

UL864 Commercial Fire, UL985

Household Fire, and UL1023

Household Burglary

2. The right loop may not be used

for Commercial Fire or UL

Commercial Burglary

installations.

3. For Commercial Fire usage: Use

N.O. contacts on the left loop.

Supervise (style B) this loop

using Model #EOL100 Fire Listed

10K ohm EOLR.

4. For UL Commercial Burglary

Usage: Use N.O. or N. C. contacts

on the left loop. Supervise using

the 10K ohm EOLR supplied.

5. All circuits are power-limited.

6. For dry indoor use only.

7. Do not install in air-handling spaces.

Note: See control panel instructions for

minimum earth ground impedance.

Specifications

Physical:

Width: 2-1/8” (53mm)

Height: 3-1/4” (81mm)

Depth: 1” (25mm)

Electrical:

Voltage Input: 8 – 12VDC

Current Drain: 2mA

Max. Loop Wire Run: 100’

Wire Gauge: 18-22 AWG

Max. Loop Line Impedance: 300 ohm

max.

REFER TO THE INSTALLATION

INSTRUCTIONS FOR THE CONTROL

PANEL WITH WHICH THE DEVICE IS

USED, FOR DETAILS ON LIMITATIONS

OF THE ENTIRE ALARM SYSTEM.

NFPA-72 Compliant

For the latest warranty information,

please go to:

http://www.security.honeywell.com/hsc/r

esources/wa/index.html

ÊN6450-1V1cŠ

N6450-1V1 2/09 Rev. A

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

Honeywell International Inc.

www.honeywell.com/security

Inhaltsverzeichnis

Andere Honeywell Steuereinheit Handbücher

Honeywell

Honeywell RM7824A Bedienungsanleitung

Honeywell

Honeywell UCIP-GPRS Bedienungsanleitung

Honeywell

Honeywell VR8205 Bedienungsanleitung

Honeywell

Honeywell AlarmNet 7847i-E Montageanleitung

Honeywell

Honeywell 804973 Bedienungsanleitung

Honeywell

Honeywell PENA D MLS2000SSP Installations- und Betriebshandbuch

Honeywell

Honeywell PRO3200 Bedienungsanleitung

Honeywell

Honeywell THP9045 Bedienungsanleitung

Honeywell

Honeywell RA116A Bedienungsanleitung

Honeywell

Honeywell 4232CBM Montageanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell Braukmann D06G Bedienungsanleitung

Honeywell

Honeywell V5852A Service-Handbuch

Honeywell

Honeywell 5496 Bedienungsanleitung

Honeywell

Honeywell RM7800L1087 Bedienungsanleitung

Honeywell

Honeywell FF-SRE6029 Bedienungsanleitung

Honeywell

Honeywell SM110 Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell VC Series Bedienungsanleitung

Honeywell

Honeywell PRO32OUT Bedienungsanleitung

Honeywell

Honeywell NETAXS NX4L1 Bedienungsanleitung

Honeywell

Honeywell 39358 Bedienungsanleitung

Honeywell

Honeywell REDLINK ERM5220R Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung