Honeywell G410 Bedienungsanleitung
1
Français p.
Español p.
IMPORTANT INSTRUCTIONS
AND OPERATING MANUAL
LP GAS GRILL
Model: G410
Thank you for choosing our product! If you have any issue about the product, please
contact us via customerservice@honeydrillshop.com, our customer service team will
assist you with order, shipping status, assembly and operation.
2
TABLE OF CONTENTS
Safety Information ...................................................................................................................... 3
Package Contents ...................................................................................................................... 5
Hardware Contents .................................................................................................................... 5
Preparation ................................................................................................................................. 6
Assembly Instructions ................................................................................................................ 6
Operation Instructions ................................................................................................................. 13
Care and Maintenance ................................................................................................................. 17
Troubleshooting ........................................................................................................................... 20
Assembler/Installer:
This manual contains important information that is necessary for the proper
assembly and safe use of this appliance. Read and follow all warnings and instructions before
assembling and using this appliance.
Leave these instructions with the consumer .
Consumer/User: Follow all warnings and instructions when using this appliance.
Retain these instructions for future reference.
If you smell gas:
1. Cut off gas to the appliance.
3. Open lid.
4. If odor continues, keep
away from the appliance and
department.
1. Do not store or use gasoline
vapors colse to this or any other
appliance.
2. An LP (liquid propane) cylin-
der not connected for use shall
not be stored colse to this or
any other appliance.
3. This grill is only for outdoor
using and shall not be used in
a building, garage, under
overhangs or any other
enclosed area.
4. Do not leave a lit grill unat-
tended. Keep children and pets
away from the grill at all times.
WARNING
DANGER
3
mbustion of such fuels contain
chemicals, including Benzene, known to the State of California to cause cancer, birth defects or
other reproductive harm. This product contains chemicals, including lead and lead compounds,
known to the State of California to cause cancer, birth defects or other reproductive harm. Wash
hands after handling.
CALIFORNIA PROPOSITION 65
DANGER
• Do not use in an explosive atmosphere. Keep grill area clear and free from combustible
SAFETY INFORMATION
CAUTION
• Do not use gasoline, kerosene or alcohol for lighting.
• The LP gas cylinder used with this appliance must be:
of the U.S. Department of Transportation (D.O.T.) or the National Standard of Canada,
CAN/CSA-B339, Cylinders, Spheres and Tubes for Transportation of Dangerous Goods;
and Commission, as applicable; and
(c) Provided with a cylinder connection device compatible with the connector for outdoor
cooking appliances. This grill is not intended to be used in or installed on recreational
vehicles and/or boats.
•
increase, may open the relief valve and leak the gas.
• Always open grill lid slowly and carefully as heat and steam trapped within the grill can hurt
you severely.
Thank you for choosing our product! If you have any issue about the product, please
contact us via Amazon Message, our customer service team will assist you with order,
shipping status, assembly and operation.
4
SAFETY INFORMATION
• Do not place the grill under overhead
combustible construction or awnings.
Minimum clearance from sides and
back of unit to combustible construction,
36 inches (915.0mm) from sides and
back.
NOTE: The installation must conform with
local codes or, in the absence of local
codes, with either the National Fuel Gas
Code, ANSI Z223.1/NFPA 54, Natural
Gas and Propane Installation Code, CSA
B149.1, or Propane Storage and
Handling Code, B149.2.
WARNING
CAUTION
other appliance.
• An LP cylinder not connected for use shall not be stored close to this or any other
appliance.
• This grill is for using with propane gas only (proane cylinder not included).
• Never attempt to attach this grill to the self-contained propane system of a boat, camper trailer,
motor home or house.
• Do not attempt to move the grill while it is lit or when it is hot. The casters should be locked
down when not moving the grill.
• Do not use the grill unless it is completely assembled and all parts are securely fastened and
tightened.
• Keep all combustible items and surfaces at least 36 inches (91.50 cm) away from the grill at all
times.
• Do not touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid
burns, unless you are wearing protective gear (pot holders, gloves, BBQ mittens, etc…).
• Do not alter this grill in any manner.
• Clean and inspect the hose before each use. If there is obvious abrasion, wear, cuts, or
leaks, the hose must be replaced prior to operating the appliance. The replacement hose
• Move gas hoses as far away as possible from the hot surfaces and dripping hot grease.
• Keep the grill’s valve compartment, burners and circulating air passages clean. Inspect the
.
• The use of alcohol, prescription or non-prescription drugs may influence the operator’s ability
to properly assemble or safely operate the grill.
•Do not leave a lit grill unattended. Keep children and pets away from the grill at all times.
level surface.
• Do not use the grill in huge winds.
close to this
shall be in accordance with supplier’s standard.
PACKAGE CONTENTS
Assemble the bottom plate (10) and Cart frame (8) to
left cart assembly (6) ,Right cart assembly (11) using
M6x12mm bolts (AA)。
Assemble the locking caster (12) to the left cart asse-
mbly (6) ,Attach the non-locking caster (14) to the right
cart assembly (11) using wrench (II) 。
6
ASSEMBLY INSTRUCTIONS
2
1
Assemble the back panel (9) to the left cart assembly(6)
and right cart assembly (11) using M6x12mm bolts (AA)
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list on previous page and hardware contents above. If any part is missing or damaged, do
not attempt to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 50 minutes with 2 people.
Tools Required for Assembly and Leak Testing (not included): Phillips screwdriver, Spray bottle,
Pliers, Adjustable Wrench
CAUTION
THIS UNIT IS HEAVY. Two people required for safe assembly.
Two people required for safe assembly. Some parts may contain sharp edges. Wear protective
gloves if necessary. Read and follow all safety statements, warnings, assembly instructions and
use and care instructions before attempting to assemble and use.
First assemble the Door post (CC) to the
Bottom plate, Then assemble magnet base
(13) to the Bottom plate using M5x10mm
bolts (BB) 。
7
ASSEMBLY INSTRUCTIONS
Assemble the lid handle (28) using
M6x12mm bolts(AA) to the lid。
Assemble the Thermometer (27) to the lid。
First remove the stronger,Assemble the
Lid & body assembly (1) to the cart left
&right cart assembly using M6x12 mm
bolts (AA) and M6 nuts (HH)
3
4
First assemble the Handle (4) and match
holder (26) to the right door (15) using
M4x5mm bolts (EE) and washer (FF)，Then
assemble the right door to the Bottom
plate (10) and cart frame (8) using door axle
(DD)。
Install the left door as above
5
5
5
8
ASSEMBLY INSTRUCTIONS
First Assemble the M6x12mm bolts (AA) to the body ,Reserve a distance of 5mm。Then fix
the side burner table (20) to the body using M6x12mm bolts (AA)
First Assemble the M6x12mm to the body ,Reserve distance of 5mm,Then fix the left side table
to the body using M6x12mm bolts (AA)
6
O
7
。
Assemble the M6x12mm to the the left front panel,Reserve a distance of 5mm,Then fix the left
front panel (3) to the body using M5x10 bolts (BB)
8
9
ASSEMBLY INSTRUCTIONS
First Assemble the M6x12mm bolt (AA) to the
right front panel (21) ,Keep a distance of 5mm。
Then assemble the rigth front panel (21) to the
control panel and side burner table using M5x10
mm bolts (BB)
9
10
Assemble the knob (23) to the side valve
Assemble the ingition pin to the side burner
table using M4x8mm bolts (GG)
Assemble the side valve and knob base (22) to
the right front panel using M4x8mm bolts (GG)。
First Align to the side valve and side burner (24)
then assemble it to the side burner table using
M4x8mm bolt (GG) 。
11
12
Correct
Incorrect
Incorrect
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 10.
FAILURE TO DO SO MAY RESULT IN FIRE OR
EXPLOSION, POSSIBLY CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
Remove the ignitor cap,insert AA battery(1.5V)
into the ignitor body with the positive “+” end fa-
cing out ,replace ignitor cap.
Assemble the side burner rack(19) to the side
burner table.put the warming rack(16) ,cooking
grills(17),flame tamer (18) into the body.
Assemble the “S” style hood (7) to the Left side
table.
ASSEMBLY INSTRUCTIONS
Attach the grease box (25) to the grease tray
Model:G410
10
13
Finish
Inhaltsverzeichnis
Andere Honeywell Grill Handbücher
