Honeywell Notifier SKBR3N Bedienungsanleitung

S-885.1-SKBR3N-ITA Rev. A.1 06/2017

SKBR3N

Scheda relè per rilevatori Smart 3 e Smart S

CARATTERISTICHE TECNICHE

PORTATA CONTATTI RELE’:

24Vdc-1A

TENSIONE DI FUNZIONAMENTO:

da 10,2Vdc a 28Vdc

All’accensione verificare che l’alimentazione del

rivelatore sia compresa fra i valori precedentemente

citati.

NOTA IMPORTANTE: per i rivelatori della serie

SMART3G, per il corretto funzionamento della scheda

ST.S3REL+, è necessario aprire il jumper JP5-6

posizionato sulla scheda base del rivelatore (vedi

manuale SMART3G).

INTRODUZIONE

La scheda a 3 relè per rilevatori della serie

SMART3/SMARTS permette di ottenere delle uscite

con contatti puliti liberi da tensione.

-La prima uscita è associata alla segnalazione di Fault e

di Watch-dog

-La seconda uscita è associabile all’allarme 1 o

all’allarme 2 del rilevatore

-La terza uscita è associabile all’allarme 2 o all'allarme

3 del rilevatore

La scheda è dotata di un cavo flat con connettore per

l’inserimento nell’apposito connettore presente sulla

scheda base del rilevatore.

Nota: quando utilizzata con rilevatori serie Smart S la

funzione associata ai 3 relè può essere modificata nel

rilevatore.

MONTAGGIO

Il montaggio della ST.S/3REL+ deve essere effettuato

con il rilevatore spento.

Inserire le colonnine nei fori presenti sul circuito base del

rilevatore dove indicato.

Inserire il connettore posto all’ estremità del cavo

flat della scheda 3 relè nel connettore apposito presente

sulla base dello SMART 3; rivolgere la sporgenza

presente sul connettore verso l’ interno del circuito.

Avvitare le viti sulle colonnine in modo da fissare la

scheda relè.

Ultimato il montaggio si noterà che la morsettiera è

rivolta verso l’alto, ossia verso la morsettiera del

rilevatore

Effettuare i cablaggi.

Accendere il rilevatore

MONTAGGIO SU RILEVATORE SMART “S

MONTAGGIO SU RILEVATORE SMART3G

SCHEDA SMART3G

SCHEDA SMART “S”

S-885.1-SKBR3N-ENG Rev. A.1 06/2017

SKBR3N

Relay card for Smart 3 and Smart S detectors

INTRODUCTION

The three-relay card for SMART3/SMARTS gas

detectors allows the detector to be provided with tension

free changeover contacts.

-The first output is to be associated to the Fault and

Watch-dog alarm

-The second output can be associated to the first or

second alarm threshold

-The third output can be associated to the second or third

alarm threshold.

The card comes complete with a flat cable and

connector to be easily plugged on the detector's mother

board.

Note: once used with the Smart S detector, the function

of the relays can be modified by the detectors operating

TECHNICAL SPECIFICATIONS

CONTACTS RATING:

24Vdc-1A

OPERATION VOLTAGE:

from 10,2Vdc to 28Vdc

Before connecting the relay card, please make sure the

detector's operation voltage is within the values here

above.

MOUNTING

Verify the detector has been disconnected before

mounting the ST.S/3REL+

Insert the supports into the holes on the PCB, as per the

drawing on page 2.

Insert the female connector at the edge of the flat cable

into the male connector on the PCB of the detector.

Beware that the black triangle on the female connector

(corresponding to pin one) is facing towards the internal

part of the PCB.

Tighten the card to the supports with the screws the

relay-card kit is equipped with.

Once the card has been properly mounted the terminal

block shall be faced towards the upper part of the

detector, i.e. towards the detector terminal block.

The detector can now be wired, connected and powered

on.

IMPORTANT NOTICE: for the SMART3G’s series

detectors, in order to properly activate the ST.S3REL+

relays card it is mandatory to open the jumper JP5-6 on

the detector’s main PCB (refer to the SMART3G's

detector manual).

SCHEDA SMART3G

MONTAGGIO SU RILEVATORE SMART3G

SCHEDA SMART “S”

MONTAGGIO SU RILEVATORE SMART “S

Inhaltsverzeichnis

Sprachen:

Andere Honeywell Relais Handbücher

Honeywell

Honeywell Aquastat L8124B Bedienungsanleitung

Honeywell

Honeywell TRADELINE R8184G Bedienungsanleitung

Honeywell

Honeywell R4343D Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell ADEMCO 5800RL Montageanleitung

Honeywell

Honeywell R841C-E Bedienungsanleitung

Honeywell

Honeywell Silent Knight WSK-RELAY Bedienungsanleitung

Honeywell

Honeywell SeqLED E SET-30 Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell Farenhyt Series Bedienungsanleitung

Honeywell

Honeywell HPSR103 Bedienungsanleitung

Honeywell

Honeywell AQUASTAT L8124A Bedienungsanleitung

Honeywell

Honeywell EC7895A Bedienungsanleitung

Honeywell

Honeywell R182J Bedienungsanleitung

Honeywell

Honeywell Aquastat L8148A Bedienungsanleitung

Honeywell

Honeywell R132A Kurzanleitung

Honeywell

Honeywell NOTIFIER FW-RM Bedienungsanleitung

Honeywell

Honeywell X47 Bedienungsanleitung

Honeywell

Honeywell 301RW Bedienungsanleitung

Honeywell

Honeywell TRADELINE R182J Bedienungsanleitung

Honeywell

Honeywell Aquastat L8148A Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell HPSR101 Bedienungsanleitung

Honeywell

Honeywell SILENT KNIGHT IDP-Relay Bedienungsanleitung

Beliebte Relais Handbücher anderer Marken

Shelly

Shelly Pro Series Bedienungsanleitung

GE MVAX 11 Bedienungsanleitung

ABB

ABB RELION REF615R Bedienungsanleitung

Pilz

Pilz PNOZ X10 Betriebsanleitung

Kemo Electronic

Kemo Electronic B197 Bedienungsanleitung

Seg

Seg MRM3 Bedienungsanleitung

Basler

Basler BE1-700C Bedienungsanleitung

CD Automation

CD Automation REVEX 2PH 280A Bedienungsanleitung

ABB

ABB SPAJ 142 C Stücklistenhandbuch

Ruelco

Ruelco 1S04 Bedienungsanleitung

Basler

Basler V3E Z1P B2C1F Bedienungsanleitung

Doepke

Doepke Dupline DSM 2 Bedienungsanleitung

Siemens

Siemens SIRIUS 3RT1966-4D Bedienungsanleitung

GE DGP Bedienungsanleitung

Kyongbo Electronics

Kyongbo Electronics GDR-D01 Bedienungsanleitung

Siemens

Siemens SIPROTEC 4 Bedienungsanleitung

Siemens

Siemens BD2-AK03X/FS Series Bedienungsanleitung

Leuze

Leuze MSI-SR5B Bedienungsanleitung