Honeywell IS-215T Bedienungsanleitung

❶Select the mounting location.

❹Wire the unit.

❸Mount the unit.

Mounting Location Guidelines

• 2.3 m (7’6”) mounting height

• Avoid direct or reflected sunlight

• Aim sensor away from windows or heating/

cooling devices

• Sensor must have a clear line-of-sight to

protected area

• Push outward on the

PCB latch and lift the

PCB out of the hous-

ing.

• Slide the wire through the wire channel and wire

access in the back housing.

• Mount the back housing flat against a wall or in a

corner.

• Replace the PCB.

• Connect wires as shown using 0.64 - 1.63 mm2

(14 to 22 AWG) wire size. Observe proper

polarity.

Corner

Mount

Wire Channel

Wall Mount

IS-215T Passive Infrared Motion Sensor Installation Instructions

❷Separate the sensor housings and re-

move the printed circuit board (PCB).

Corner

Mount

Wiring Knockouts

POWER

12VDC

10mA

ALARM

16VDC

90mA

TAMPER

30VDC

0.5A

❺Configure the sensor sensitivity.

• Configure the IS-215T for the sensitivity best

suited to the application.

OFF

SENSITIVITY SWITCH SW2 POSITION

High (pulse count 1)

Low [Normal] (pulse count 2)

❻Walk-test the sensor.

High Sensitivity: 2-4 Steps

(Pulse Count 1)

Switch

• Use a small screwdriver to

push in the housing latch

at the bottom of the sensor,

and gently pull apart the

housings.

Alarm

LED

Low [Normal] Sensitivity: 3-5 Steps

(Pulse Count 2)

IS-215T Passive Infrared Motion Sensor Product Information

ALARM LED DISABLE

After walk-testing the sensor, disable the alarm

LED by turning Switch S1 to the OFF position.

SPECIFICATIONS

Range:

12 m x 12 m

40' x 40'

Power requirements:

10 - 14 VDC, w/LED - Alarm:

10mA max.; w/o LED - Alarm:

7mA max.; 12 VDC

3V peak-to-peak at nominal

12 VDC

Alarm relay:

Form A SPST,

90 mA, 16 VDC,

15 Ohm protective resistor

Tamper switch

Closed with cover in place

0.5 A, 30 VDC

RFI immunity:

30 V/m

10 MHz - 1000 MHz

PIR White light immunity:

6,500 Lux

PIR sensitivity:

Switch selectable

low [normal] (pulse count 2)

3-5 steps

high (pulse count 1) 2-4 steps

PIR fields of view:

dual element,

44 long range zones

14 intermediate, 8 lower,

4 look-down

Operating temperature:

-10oC to +55oC (14° F to 131° F)

Relative humidity:

5% to 95% noncondensing

Dimensions:

8.57 cm x 6.03 cm x 3.81 cm

(3-3/8" H x 2-3/8" W x 1-1/2" D)

Weight:

66.62 g (2.35 oz)

Packaged Product is 92.14 g

(3.25 oz)

Approvals/listings:

cULus

C-Tick

EN 50131-1

Security Grade 2

Environmental Class II

Important: For UL Certificated installations, the IS215T must

be connected to a UL listed power supply or UL listed control

unit capable of providing a minimum of four hours of standby

power.

Suitable for connection to an EN 60950 Class II Limited Power

Source.

TOP VIEW

Wide Angle Lens

DETECTION PATTERNS

SIDE VIEW

Wide Angle Lens

5-051-680-40 Rev C

Andere Honeywell Sicherheitssensor Handbücher

Honeywell

Honeywell C7061A1020 Bedienungsanleitung

Honeywell

Honeywell Miller EN 358 Bedienungsanleitung

Honeywell

Honeywell Ex-Or MR1500P Installations- und Betriebshandbuch

Honeywell

Honeywell Fire Sentry FS7-2173-2RP Bedienungsanleitung

Honeywell

Honeywell Eclipse Bedienungsanleitung

Honeywell

Honeywell One FireLite Alarms SD355 Bedienungsanleitung

Honeywell

Honeywell Viewguard DUAL AM BUS-2/BUS-1 Gebrauchsanweisung

Honeywell

Honeywell MDA Scientific MIDAS Bedienungsanleitung

Honeywell

Honeywell SC105 Bedienungsanleitung

Honeywell

Honeywell DT7235T Bedienungsanleitung

Honeywell

Honeywell 5800PIR Bedienungsanleitung

Honeywell

Honeywell 5800CO Montageanleitung

Honeywell

Honeywell IS312B Bedienungsanleitung

Honeywell

Honeywell 5898 Bedienungsanleitung

Honeywell

Honeywell C7007A Bedienungsanleitung

Honeywell

Honeywell 5800COMBO-CN Bedienungsanleitung

Honeywell

Honeywell EC-P2 Bedienungsanleitung

Honeywell

Honeywell HAQSPA-R Bedienungsanleitung

Honeywell

Honeywell Fire-Lite Alarms SD365T Bedienungsanleitung

Honeywell

Honeywell Lyric Bedienungsanleitung

Honeywell

Honeywell Miller Titan TR50 Bedienungsanleitung

Honeywell

Honeywell SIXCO Bedienungsanleitung

Honeywell

Honeywell SC100 Bedienungsanleitung

Honeywell

Honeywell IQ Force Installationshandbuch

Beliebte Sicherheitssensor Handbücher anderer Marken

THORLABS

THORLABS PDA10JT Bedienungsanleitung

Waeco

Waeco UV-DETECT Bedienungsanleitung

Intermatic

Intermatic IOS-DSIMF Bedienungsanleitung

urmet domus

urmet domus 1083 Bedienungsanleitung

Siemens

Siemens AZL66 Series Bedienungsanleitung

BTI

BTI Profiline Multi Finder Bedienungsanleitung

Challenger

Challenger SL01 Bedienungsanleitung

DMP Electronics

DMP Electronics 1122INT Bedienungsanleitung

Rielta

Rielta Ladoga MK-RK Bedienungsanleitung

Mirion Technologies

Mirion Technologies ACCURAD PRD Bedienungsanleitung

Bosch

Bosch DS835 Bedienungsanleitung

DBI SALA

DBI SALA EZ Stop Bedienerhandbuch

Lamptime

Lamptime ST05C Bedienungsanleitung

Ubiquiti

Ubiquiti MFI-MSC Bedienungsanleitung

Subsite

Subsite 910R Montageanleitung

Satel

Satel OPAL Pro Bedienungsanleitung

Aleph

Aleph XC-1XTEU Bedienungsanleitung

Pima

Pima LARIS QUAD Bedienungsanleitung