Honeywell FA-300 Alarm Bar Bedienungsanleitung

FA-300 Alarm Bar

User’s Guide

Rev. A

September 2018

P/N F05-4032-000

FA-300 Alarm Bar User’s Guide

Contents

1Standard Contents 4

2General Information 4

2.1 Key Features 4

3Physical Description 5

4Installation 6

4.1 Mounting the FA-300 Alarm Bar 6

4.2 Drilling Chart 7

4.3 Electrical/Control Connections 8

4.4 Connecting to An FMC2000 Controller 9

5Maintenance 10

6Specifications 11

7Troubleshooting 13

7.1 Checking FMC2000 Relay Continuity 14

FA-300 Alarm Bar User’s Guide

Read Before Operating

This manual must be carefully read by all individuals who

have or will have the responsibility of using, maintaining,

or servicing this product. The product will perform as

designed only if it is used, maintained, and serviced in

accordance with the manufacturer’s instructions. The user

should understand how to set the correct parameters and

interpret the obtained results.

CAUTION!

To reduce the risk of electric shock, turn the power off

before opening this instrument or performing service.

Never operate the instrument when the instrument is

open. Use and service this product only in an area known

to be non-hazardous.

Proper Product Disposal At End Of Life

EU Directive 2012/19/EU: Waste Electrical

and Electronic Equipment (WEEE)

This symbol indicates that the product must

not be disposed of as general industrial or

domestic waste. This product should be

disposed of through suitable WEEE disposal facilities. For

more information about disposal of this product, contact

your local authority, distributor, or the manufacturer.

FA-300 Alarm Bar User’s Guide

WARNINGS

Use only in non-hazardous locations.

For safety reasons, this equipment must be operated and

serviced by qualified personnel only. Read and

understand instruction manual completely before

operating or servicing.

AVERTISSEMENT

Utiliser uniquement en zone non-dangereuse.

Pour des raisons de sécurité, cet équipment doit être

utilisé, entretenu et réparé uniquement par un personnel

qualifié. Étudier le manuel d’instructions en entier avant

d’utiliser, d’entretenir ou de réparer l’équipement.

FA-300 Alarm Bar User’s Guide

1 Standard Contents

•FA-300 Alarm Bar

•Integral 10-meter (33-foot) connection cable

•User’s Guide

2 General Information

The FA-300 Alarm Bar works with RAE Systems

FMC2000 controller and other compatible devices. It

provides bright visible and loud audible notification when a

controller is in alarm.

2.1 Key Features

• Loud siren: 117dB @ 3 m (10′)

• Four bright strobe lights with impact-resistant

polycarbonate lenses (red, white, blue, amber)

• Second port for interconnection with second controller

• Low maintenance

FA-300 Alarm Bar User’s Guide

3 Physical Description

The FA-300 Alarm Bar comes pre-assembled and

requires only connection via its integrated cord to a

controller with relays. It has mounting flanges at the top

and bottom with four holes that accept screws for

attaching the FA-300 Alarm Bar to a wall or other flat

surface. It receives all power from the controller that it is

attached to, simplifying installation and maintenance.

Front View

Side View

FA-300 Alarm Bar User’s Guide

4 Installation

4.1 Mounting the FA-300 Alarm Bar

The FA-300 Alarm Bar is designed to be wall-mounted

and has four holes for anchoring the FA-300 Alarm Bar,

using screws or bolts.

Before mounting the FA-300 Alarm Bar, make sure that its

cord can reach the controller that it will be electrically

connected to.

Make sure that there is approximately 12" (30 cm) of

clearance on all sides of the FA-300 Alarm Bar so that the

siren’s sound is not attenuated and to ensure clear view of

the four visible alarm lights.

Follow these steps:

1. Locate the FA-300 Alarm Bar on a wall or other flat

surface and mark the four holes’ locations.

2. Remove the FA-300 Alarm Bar.

3. Drill the four holes.

4. Hold the FA-300 Alarm Bar firmly against the wall and

insert and tighten the screws.

The FA-300 Alarm Bar is now ready to be connected to

the controller.

FA-300 Alarm Bar User’s Guide

4.2 Drilling Chart

When mounting the FA-300 on a wall, make sure to use

heavy-duty steel screws spaced as indicated below.

FA-300 Alarm Bar User’s Guide

4.3 Electrical/Control Connections

The FA-300 Alarm Bar has a 33’ (10 m) cable with a

screw-type multi-pin connector. It is designed to mate with

the connector on a RAE Systems FMC2000 controller and

some similar controllers that use the same connector type

and relay configuration.

Inhaltsverzeichnis

Andere Honeywell Sicherheitssystem Handbücher

Honeywell

Honeywell LYNX Touch Series Montageanleitung

Honeywell

Honeywell ADEMCO 5809 Montageanleitung

Honeywell

Honeywell nfs2-3030 Bedienungsanleitung

Honeywell

Honeywell Optiflex Interactive Bedienungsanleitung

Honeywell

Honeywell ADEMCO LYNXR-ENSIA Bedienungsanleitung

Honeywell

Honeywell Lynx Plus Series Bedienungsanleitung

Honeywell

Honeywell Ademco VISTA-20P Bedienungsanleitung

Honeywell

Honeywell VISTA-128BP Montageanleitung

Honeywell

Honeywell LXL-1000 Bedienungsanleitung

Honeywell

Honeywell VISTA-32FBPT Bedienungsanleitung

Honeywell

Honeywell Lynx Plus Series Montageanleitung

Honeywell

Honeywell Fire-Lite Alarms MS-9200UDLSC Bedienungsanleitung

Honeywell

Honeywell XC70 Bedienungsanleitung

Honeywell

Honeywell Manning GM-JR Handbuch

Honeywell

Honeywell S-Quad Gebrauchsanweisung

Honeywell

Honeywell Fire-Lite Alarms W-BG12LX(A) Bedienungsanleitung

Honeywell

Honeywell DTPI8M Bedienungsanleitung

Honeywell

Honeywell Domonial Bedienungsanleitung

Honeywell

Honeywell LYNX TOUCH L5200 Betriebsanleitung

Honeywell

Honeywell proX1 Bedienungsanleitung

Honeywell

Honeywell ADEMCO VISTA-10P Betriebsanleitung

Honeywell

Honeywell 6272CV Bedienungsanleitung

Honeywell

Honeywell Code Encryptor II Bedienungsanleitung

Honeywell

Honeywell NOTIFIER DSE3-23 Series Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung