Honeywell HRO-50 Bedienungsanleitung

HRO-50 Water Puriﬁer

Product Installation & Operation Manual

Honeywell Environmental & Combustion Controls

(Tianjin) Co., Ltd.

Important Notes P2

Installation Instructions

Instructions for Commissioning

and Operation

Care & Maintenance

Warranty Provisions

Packing List

P6-P9

P10

P11

P12

P13

Product Functions P3-P5

Content

• The water purifier is floor-mounted, and should not be mounted on the wall or hung up

after assembly.

•Do not disassemble or modify the water purifier without approval, or else it may cause

malfunction or leakage and consequential property damage.

•Check the water purifier and pipe fittings regularly to see whether there is any leakage,

and avoid property damage caused by leakage.

•Check the power supply and electric wires regularly to see whether they are loose or

damaged, and avoid major accidents caused by electric leakage.

•Prior to use, make sure the rated voltage of the water purifier is consistent with the

actual voltage.

• Do not tug the power cord when you disconnect the plug.

• Do not use this product in case of the following situations:

- The water purifier has been damaged

- Plug or power cord is damaged

- Water is flowing out of the water purifier

•If the power cord or plug is damaged, the water purifier is not working properly or there

are other damages, please do not continue to use the water purifier, you should immedi-

ately contact the service personnel for testing, maintenance and adjustment.

•Do not disassemble the water purifier without approval or hand over the water purifier

to unauthorized service personnel for repair. Improper repairs may cause danger!

• Any malfunction caused by improper use is not covered in the warranty.

•This water purifier is only designed for household use, and may not necessarily apply

to other purposes.

•For the water purifier maintenance and filter cartridge replacement, use the replace-

ment parts approved by Honeywell Environmental & Combustion Controls (Tianjin)

Company Limited. All the quality problems, degradation of operational performance or

consequential property damage caused by using unauthorized parts or accessories are

not covered in the guarantee.

• Water purifier maintenance and filter cartridge replacement are paid services.

Important Notes

Users must install the water purifier with the help of professionals by strictly following the

installation specification set out in the "Product Installation & Operation Manual"

(hereinafter referred to as manual), and use the water purifier according to the instruc-

tions in the manual. Otherwise, the company does not assume any economic or legal

responsibility for the water purifier damage or leakage and consequential property

damage, or even personal injury due to improper installation and usage of water purifier.

Figure 1

Brief Introduction

Dimensions (Figure 1)

The water purifier is designed to work under the table near the sink in the kitchen. The

supply pipe connects to your existing water pipe with a tee joint. This water purifier is

designed to purify the drinking water.

Two water purification functions can be achieved by adjusting the water mixing valve

(See Figure 12 for details):

2) Mixed water purification: It meets the needs of different users and effectively increases

the TDS value of water production.

The water purifier filter cartridges need to be changed regularly. Replacement cycle will

be indicated at the faucet (separate package) base. The green light indicates it is within

the safe range, the yellow light indicates it needs to be replaced (close to safe range),

and the red light indicates it exceeds the safety range, and must be replaced.

341mm

416mm

222mm

Ø240 MM

350 MM

Product Functions

1) Reverse osmosis purification: After 100% purified by RO membrane filter, which has

pore size of 0.0001 micron, almost all the dissolved solids in the water can be removed.

Figure 2

Parts of Water Puriﬁer

* The rated maximum capacity is the effective treatment capacity continuously tested after

adding the standard solution according to the inspection rules required by Ministry of Health.

Technical Parameters (Table 1)

Model HRO-50

Water Inlet Requirement

Water Inlet Pressure

Water Inlet Temperature

Water Purification Flow Rate

Rated Maximum Capacity

Power Specifications

0.1MPa～0.35MPa

5–38 °C

0.26 L / Min

3 tons

Input: 220V AC

Outlet: 24V DC

Municipal tap water, conforming to local standard

Table 1

Filter adapter

Front PP cotton

filter cartridge

Front activated

carbon filter cartridge

Rear PP cotton

filter cartridge

Reverse osmosis

membrane filter cartridge

Rear activated carbon

filter cartridge (sterilization)

Transformer

To faucet

To storage

tank

Storage

tank

1/2’’ tee joint with

a gasket

1/4’’ ball valve

1/4” PE white

pipe (3.0m)

1/2” L adapter

Drain outlet

Product Functions

The actual water treatment capacity may vary depending on local water quality and

operating environment.

Filter Performance (Table 2)

Filter components Filter function

Front PP cotton

filter cartridge

Front activated carbon

filter cartridge

Rear PP cotton

filter cartridge

Reverse osmosis

membrane filter cartridge

Rear activated carbon

filter cartridge (sterilization)

Table 2

Note:

Do not let water to freeze inside the drain line or water purifier.

If the water temperature or the ambient temperature drops below 5 °C, turn off the water

purifier, water supply pipeline and discharge the water inside the water purifier. The

freezing of water pipes or water purifier can cause the failure of the shell or water supply

pipeline damaged and possible injury.

Do not touch the power cord plug with wet hands, which may cause electric shock.

Effectively remove suspended solids, sediment, rust

and other impurities

Effectively remove residual chlorine, humus,

disinfection byproducts, odor, color etc.in the water

Further improve water taste, kill bacteria and prevent

bacteria reverse breeding

Product Functions

Further remove particles in the water, suspended

solids and colloids

pore size of 0.0001 micron; effectively remove

almost all the dissolved solids in the water

Installation Instructions

Figure 3 Figure 4

Installation Precautions

Pre-installation Preparation

• Do not install the water purifier in the water supply pipe, whose pressure exceeds

0.35MPa. If the water inlet pressure exceeds 0.35Mpa, the pressure reduce valve

(purchased separately) must be installed.

• The water inlet temperature range of the water purifier is 5～38 °C, and the water

temperature exceeding 38℃may damage the seals and cause leakage; Water tempera-

ture below 5 °C may cause water to freeze and lead to the pipe rupture and leakage.

• Install the filter cartridge in a correct order; otherwise the water purifier cannot perform

its intended function.

• Do not install the water purifier reversely, and connect the water inlet pipe to the outlet.

• Do not install the water purifier in direct sunlight or at places where it is exposed to

hazardous chemicals or may be damaged by falling or collision.

• Do not install the water purifier near any source of heat.

• Do not install the water purifier upside down.

• Only use the 220VAC power for the water purifier! The receptacle withstand current

must be greater than 5.0A, or else it may cause overheat or fire accident.

• Disconnect the power before the installation! Do not touch the power plug with wet

hands, or else it may cause electric shock.

• Disconnect the power before installation!

• Before installation, please turn off the water inlet valve.

• Confirm the location where the water purifier will be installed (depending on the actual

situation).

• Confirm that all the accessories required in the installation are complete (see the

packing list).

Installation Steps

Step 1:

Pull out two rubber plugs at the top (Figure 3) and one red rubber stick at the bottom

(Figure 4) of the reverse osmosis membrane filter cartridge at the 4th stage. It is normal

that a little protection fluids flow out after pulling out the red rubber stick; Pull out two

rubber plugs at the top of the rear activated carbon filter cartridge at the 5th stage.

Step 2:

Install front PP cotton filter cartridge at the first stage of the filter adapter, the front

activated carbon filter cartridge at the second stage of the filter adapter, the rear PP cotton

filter cartridge at the third stage of the filter adapter, the reverse osmosis membrane

Step 3:

Cut the 1/4’’ PE pipe into three sections. The incision must be flat. Connect them with tee

joint ball valve connector (Figure 6,7), storage bucket and drinking water faucet

separately (Figure 8,9).

Installation Instructions

Figure 5

2 3 4

L adapter

Lock nut1/4” PE pipe

Gasket

Threaded nipple

Figure 6 Figure 7

Figure 8 Figure 9

Cold water pipe

connection nut

Gasket

Three-way

Gasket

Cold water

valve

Ball valve

Nut

1/4" PE pipe

PTFE tape

Nut

Ring

Plug

filter cartridge at the fourth stage of the filter adapter, and rear activated carbon filter

cartridge at the fifth stage of the filter adapter.

Align the 2 connection pipe of the filter cartridge to the connection holes of the filter

adapter, and rotate counter-clockwise to the end. (Figure 5).

Installation Instructions

Step 4:

Cut the 1/4 "PE pipe at appropriate length. Insert the threaded flow-limiting plug supplied

with the reverse osmosis membrane filter cartridge into the 1/4”PE pipe (Figure 10), then

insert the 1/4”PE pipe with flow-limiting plug into the quick connection hole at the

bottom of the reverse osmosis membrane filter cartridge at the 4th stage (Figure 11), and

finally put the other end into the sewer or recycling container.

Figure 10 Figure 11

To the sewer

or recycling

container

Step 5:

Open the cover and rotate the control valve according to the water purification require-

ments. Align it with Rto produce reverse osmosis water; and rotate clockwise to M to

produce mixed water (Figure 12).

Step 6:

Connect the PE pipe connected in Step 4 to the water purifier (Figure 13).

Place the water purifier in the appropriate position (Figure 14).

Figure 13 Figure 14

Figure 12

Water

inlet To faucet

To storage

tank

Flush and Start Water Puriﬁer

The water purifier must be flushed manually and automatically at the first installation and

replacement.

1) Manual flush:

Pull out the threaded flow-limiting plug in the wastewater outlet (clean the groove if it is

dirty). Plug in the power, turn on the water inlet valve and small ball valve, and flush for

about 2-5 minutes. Turn off the small ball valve.

2) Automatic flush:

Check whether all the water pipes are installed correctly and completely.

4) Confirm that the flushing is complete, turn off the water faucet and complete the

commissioning.

Installation Instructions

Install the threaded flow-limiting plug into the wastewater pipe. Open the small ball valve

to produce water. Meanwhile, open the water faucet to exhaust the air. Wait until the

water faucet is exhausted completely, and close the faucet after the water flow is steady.

After the storage tank is full in about 45~60 minutes, open the water faucet to discharge

all the water in the storage tank.

3) Check the tightness at various each part of the product carefully when flushing. Wipe

all the connections with tissue paper to see whether it is wet.

Inhaltsverzeichnis

Andere Honeywell Wasserfiltersystem Handbücher

Honeywell

Honeywell HM600XROF1/U Betriebsanleitung

Honeywell

Honeywell F74CS Bedienungsanleitung

Honeywell

Honeywell FF60 Bedienungsanleitung

Honeywell

Honeywell FF40 Bedienungsanleitung

Honeywell

Honeywell NK300SE-VE Bedienungsanleitung

Honeywell

Honeywell miniplus FK06 Bedienungsanleitung

Honeywell

Honeywell kaltecpro PW 12-A Bedienungsanleitung

Honeywell

Honeywell FK09S Bedienungsanleitung

Honeywell

Honeywell FF60 Bedienungsanleitung

Honeywell

Honeywell 50045947 Bedienungsanleitung

Honeywell

Honeywell WTE-G-D-3.6-PT01 Bedienungsanleitung

Honeywell

Honeywell Braukmann kaltecCool PW52-A Bedienungsanleitung

Honeywell

Honeywell BRAUKMANN F74C Bedienungsanleitung

Honeywell

Honeywell FF40 Bedienungsanleitung

Honeywell

Honeywell MHF49 Bedienungsanleitung

Honeywell

Honeywell DialSet FK06 Bedienungsanleitung

Honeywell

Honeywell MiniPlus FF06 Bedienungsanleitung

Honeywell

Honeywell 50045947-001/011 Bedienungsanleitung

Honeywell

Honeywell kaltecSoft PW52-AS Bedienungsanleitung

Honeywell

Honeywell BRAUKMANN F74C Bedienungsanleitung

Honeywell

Honeywell F74CS Bedienungsanleitung

Honeywell

Honeywell HF49 Bedienungsanleitung

Honeywell

Honeywell HU-20 Bedienungsanleitung

Honeywell

Honeywell F76CS Series Bedienungsanleitung

Beliebte Wasserfiltersystem Handbücher anderer Marken

Wisy

Wisy LineAir 100 Bedienungsanleitung

Schaffner

Schaffner Ecosine FN3446 Series Betriebsanleitung

Pentair

Pentair FLECK 4600 SXT Benutzerhandbuch

H2O International

H2O International H20-500 Bedienungsanleitung

Renkforce

Renkforce 2306241 Bedienungsanleitung

Neo-Pure

Neo-Pure TL3-A502 Bedienungsanleitung

FLTR

FLTR OBF Bedienungsanleitung

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Bedienungsanleitung

Applied Membranes

Applied Membranes W-G844EM Bedienungsanleitung

BEGA

BEGA 116 Bedienungsanleitung

WATA

WATA Standard Bedienungsanleitung

Price

Price FFU series Handbuch

Gaggenau

Gaggenau BRITA INTENZA 467873 Bedienungsanleitung

Brita

Brita SAFF-100 Bedienungsanleitung

HEISSNER

HEISSNER FPU24000-00 Bedienungsanleitung

BGS technic

BGS technic 1518 Bedienungsanleitung

Reverse Osmosis

Reverse Osmosis RF Series Bedienungsanleitung

ubbink

ubbink Filtramax Series Bedienungsanleitung