Hoshizaki F-330BAH Bedienungsanleitung

Hoshizaki

“A Superior Degree

of Reliability”

www.hoshizaki.com

Model

F-330BAH(-C)

Self-Contained Flaker

Hoshizaki America, Inc.

Issued: 5-4-2007

Revised: 1-15-2013

INSTRUCTION MANUAL

WARNING

Only qualied service technicians should install and service the appliance.

To obtain the name and phone number of your local Hoshizaki Certied Service

Representative, visit www.hoshizaki.com. No installation or service should be

undertaken until the technician has thoroughly read this Instruction Manual.

Likewise, the owner/manager should not proceed to operate the appliance

until the installer has instructed them on its proper operation. Failure to install,

operate, and maintain the appliance in accordance with this manual will

adversely affect safety, performance, component life, and warranty coverage

and may result in costly water damage. Proper installation is the responsibility

of the installer. Product failure or property damage due to improper installation

is not covered under warranty.

Hoshizaki provides this manual primarily to assist qualied service technicians in the

installation, maintenance, and service of the appliance.

Should the reader have any questions or concerns which have not been satisfactorily

addressed, please call, send an e-mail message, or write to the Hoshizaki Technical

Support Department for assistance.

Phone: 1-800-233-1940; (770) 487-2331

Fax: 1-800-843-1056; (770) 487-3360

E-mail: [email protected]

HOSHIZAKI AMERICA, INC.

618 Highway 74 South

Peachtree City, GA 30269

Attn: Hoshizaki Technical Support Department

NOTE: To expedite assistance, all correspondence/communication MUST include the

following information:

• Model Number

• Serial Number

• Complete and detailed explanation of the problem.

CONTENTS

I. Specications...................................................................................................................... 4

A. Nameplate Rating ......................................................................................................... 4

B. Dimensions/Connections .............................................................................................. 5

II. Installation and Operating Instructions .............................................................................. 6

A. Checks Before Installation............................................................................................. 6

B. How to Remove Panels ................................................................................................ 6

C. Location ........................................................................................................................ 7

D. Setup............................................................................................................................. 7

E. Electrical Connection .................................................................................................... 7

F. Water Supply and Drain Connections ............................................................................ 7

G. Final Checklist ............................................................................................................. 9

H. Startup ........................................................................................................................ 10

III. Cleaning and Maintenance ..............................................................................................11

A. Cleaning and Sanitizing Instructions ............................................................................11

1. Cleaning Solution....................................................................................................11

2. Cleaning Procedure ................................................................................................11

3. Sanitizing Solution ................................................................................................. 13

4. Sanitizing Procedure - Initial .................................................................................. 13

5. Sanitizing Procedure - Final................................................................................... 13

B. Maintenance ............................................................................................................... 15

C. Preparing the Icemaker for Long Storage .................................................................. 16

IV. Disposal .......................................................................................................................... 17

IMPORTANT

This manual should be read carefully before the appliance is installed and

operated. Read the warnings and guidelines contained in this manual

carefully as they provide essential information for the continued safe use and

maintenance of the appliance. Retain this manual for any further reference that

may be necessary.

I. Specications

A. Nameplate Rating

1. F-330BAH, F-330BAH-C

See the nameplate for electrical and refrigeration specications. This nameplate is located

on the rear panel.

We reserve the right to make changes in specications and design without prior notice.

HOSHIZAKI ICE MAKER

MOTOR-COMPRESSOR THERMALLY PROTECTED,

NOT INTENDED FOR OUTDOOR USE!

Hoshizaki America, Inc.

Peachtree City, GA

www.hoshizaki.com

For certification marks, see the nameplate

on the rear panel.

MODEL NUMBER F-330BAH

SERIAL NUMBER

AC SUPPLY VOLTAGE 115/60/1

AMPERES 6.7 AMPS

DESIGN PRESSURE HI-470PSI LO-230PSI

REFRIGERANT 404A 7.1 OZ.

Note: Only the "MODEL NUMBER" is replaced for F-330BAH-C.

B. Dimensions/Connections

1. F-330BAH, F-330BAH-C

Unit = inches (mm)

II. Installation and Operating Instructions

A. Checks Before Installation

IMPORTANT

1. Install in accordance with all applicable national, state, and local regulations.

2. Remove shipping carton, tape, and packing. If any are left in the icemaker, it

will not work properly.

3. Ensure all components, fasteners, and thumbscrews are securely in place

after installation.

•

Remove the top panel and front panel to prevent damage when installing the

icemaker.

•

Remove the package containing the accessories.

•

Remove the protective plastic lm from the panels. If the icemaker is exposed

to the sun or to heat, remove the lm after the icemaker cools.

•

Check that the refrigerant lines do not rub or touch lines or other surfaces, and

that the fan blade turns freely.

•

Check that the compressor is snug on all mounting pads.

•

See the nameplate on the rear panel, and check that your voltage supplied

corresponds with the voltage specied on the nameplate.

B. How to Remove Panels

See Fig. 1

•Front Panel: Remove the screw. Lift up

and towards you.

•Top Panel: Open the door. Remove the

screws. Lift up at the front slightly, push

rearward, and lift off.

Fig. 1

Top Panel

Screw

Front Panel

Screw

Door

C. Location

CAUTION

This icemaker is not intended for outdoor use. Normal operating ambient

temperature should be within +45°F to +100°F (+7°C to +38°C); Normal

operating water temperature should be within +45°F to +90°F (+7°C to +32°C).

Operation of the icemaker, for extended periods, outside of these normal

temperature ranges may affect icemaker performance.

For best operating results:

• Icemaker should not be located next to ovens, grills or other high heat producing

equipment.

• Location should

provide a rm and level foundation for the equipment.

• Allow 24" (61 cm) clearance at top to allow for removal of the auger and for ease of

maintenance and/or service should they be required.

D. Setup

1) Attach the four adjustable legs provided to the bottom of the icemaker.

2) Position the icemaker in the selected permanent location.

3) Level the icemaker from side-to-side and front-to-rear by adjusting the legs.

E. Electrical Connection

WARNING

The GREEN ground wire in the factory-installed power cord is connected

to a screw on the bracket where the cord enters the machine. If it becomes

necessary to remove or replace the power cord, be sure to connect the power

cord's ground wire to this screw upon reattachment.

• Electrical connections must be installed in accordance with applicable national, state

and local regulations.

• The unit requires an independent power supply. See the nameplate for proper voltage

and breaker/fuse size.

• Usually an electrical permit and services of a licensed electrician are required.

F. Water Supply and Drain Connections

• This icemaker must be installed in accordance with applicable national, state, and local

regulations.

• A plumbing permit and services of a licensed plumber may be required in some areas.

• External lters, strainers, or softeners may be required depending on water quality.

Contact your local Hoshizaki Certied Service Representative for recommendations.

• Water supply pressure should be a minimum of 10 PSIG and a maximum of 113 PSIG.

If the pressure exceeds 113 PSIG, the use of a pressure reducing valve is required.

• Water supply inlet is 1/2" female pipe thread (FPT).

• A minimum of 1/4" nominal ID copper water tubing or equivalent is required for the

icemaker water supply line. An icemaker water supply line shut-off valve and drain valve

must be installed. Be sure there is sufficient extra water supply line for the unit to be

pulled out for service.

• Icemaker drain outlet is 3/4" FPT. A minimum of 3/4" nominal ID hard pipe or equivalent

is required for the icemaker drain line. Be sure there is sufficient extra drain line for the

unit to be pulled out for service.

• Drain line must have 1/4" fall per foot (2 cm per 1 m) on horizontal runs to get good ow.

A vented tee connection is also required for proper ow.

• Drain line should not be piped directly to the sewer system. An air gap of a minimum of

2 vertical inches (5 cm) should be between the end of the drain pipe from the unit and

the oor drain.

Floor

Drain

Fig. 2

Shut-Off

Valve

Drain Valve

Drain Outlet

3/4" FPT

Piping to

approved

drain.

Two-inch

(5 cm) air gap

Water Supply Inlet

1/2" FPT

G. Final Checklist

1) Is the icemaker level?

2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F

(+7°C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +32°C) all

year around?

3) Is there at least 24" (61 cm) clearance at top for maintenance or service?

4) Have the shipping carton and all tape and packing been removed from the icemaker?

5) Are all components, fasteners, and thumbscrews securely in place?

6) Have all electrical and piping connections been made?

7) Has the power supply voltage been checked or tested against the nameplate rating?

And has a proper ground been installed to the icemaker?

8) Are the water supply line shut-off valve and drain valve installed? Has the water

supply pressure been checked to ensure a minimum of 10 PSIG and a maximum of

113 PSIG?

Note: The icemaker may stop running when the water supply is OFF, or if the pressure

is below 10 PSIG. When the proper water pressure is reached, the icemaker will

automatically start running again.

9) Are the compressor hold-down bolts snug? Have the refrigerant lines been checked to

make sure they do not rub or touch other lines or surfaces?

10) Has the bin control switch been checked for correct operation? Move the actuator

located on the inside of the bin top panel. The compressor should stop within

90 seconds, and the gear motor within 150 seconds.

11) Has the end user been given the instruction manual, and instructed on how to operate

the icemaker and the importance of the recommended periodic maintenance?

12) Has the end user been given the name and telephone number of an authorized service

agent?

13) Has the warranty tag been lled out and forwarded to the factory for warranty

registration?

H. Startup

CAUTION

1. All parts are factory-adjusted. Improper adjustments may result in failure.

2. If the unit is turned off, wait for at least 3 minutes before restarting the

icemaker to

prevent damage to the compressor.

1) Clean the storage bin.

2) Open the water supply line shut-off valve.

3) Make sure the power switch on the control box is in the "OFF" position. Plug the unit

into the electrical outlet.

4) Move the control switch

to the "ICE" position and move

the

power switch to the

"ON" position to start the

automatic icemaking process

5) Replace the panels in their correct positions.

Andere Handbücher für F-330BAH

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hoshizaki Eiswürfelbereiter Handbücher

Hoshizaki

Hoshizaki DCM-500BAH Bedienungsanleitung

Hoshizaki

Hoshizaki Serenity Series KMS-2000MLH Bedienungsanleitung

Hoshizaki

Hoshizaki KM-250BAB Bedienungsanleitung

Hoshizaki

Hoshizaki F-801MAJ-C Bedienungsanleitung

Hoshizaki

Hoshizaki F-801MAJ Bedienungsanleitung

Hoshizaki

Hoshizaki KM-150BWF Bedienungsanleitung

Hoshizaki

Hoshizaki FM-170EE-HC Bedienungsanleitung

Hoshizaki

Hoshizaki F-2000MRH Bedienungsanleitung

Hoshizaki

Hoshizaki FM-481ALGE Bedienungsanleitung

Hoshizaki

Hoshizaki KML-450MAF Bedienungsanleitung

Hoshizaki

Hoshizaki KM-255BAH Bedienungsanleitung

Hoshizaki

Hoshizaki KMS-1400MLH Bedienungsanleitung

Hoshizaki

Hoshizaki FM-120KE-HC Bedienungsanleitung

Hoshizaki

Hoshizaki DIM-30DE-1 Bedienungsanleitung

Hoshizaki

Hoshizaki IM-30CWNE Bedienungsanleitung

Hoshizaki

Hoshizaki KM-1201DSU Bedienungsanleitung

Hoshizaki

Hoshizaki KM-630MWF Bedienungsanleitung

Hoshizaki

Hoshizaki FM-170 Bedienungsanleitung

Hoshizaki

Hoshizaki KM-1300MAF Bedienungsanleitung

Hoshizaki

Hoshizaki IM-240DSME Bedienungsanleitung

Hoshizaki

Hoshizaki IM-200BAC Bedienungsanleitung

Hoshizaki

Hoshizaki F-2000MLF-22 Bedienungsanleitung

Hoshizaki

Hoshizaki IM-21 Bedienungsanleitung

Hoshizaki

Hoshizaki FM-750AKE-N Bedienungsanleitung

Beliebte Eiswürfelbereiter Handbücher anderer Marken

Sub-Zero

Sub-Zero 315I Gebrauchsanweisung

Kenmore

Kenmore 2217402A Bedienungsanleitung

Cornelius

Cornelius WM600 Betriebsanleitung

GE XPIO43SCSS Bedienungsanleitung

Whynter

Whynter FIM-450HA Bedienungsanleitung

U-Line

U-Line UMCR014-SC01A Installationshandbuch

Andrew James

Andrew James AJ000522 Bedienungsanleitung

Scotsman

Scotsman CME1356 Bedienungsanleitung

Scotsman

Scotsman ACM 25 Bedienungsanleitung

Kärcher

Kärcher IP 120 Bedienungsanleitung

U-Line

U-Line SS1095 Bedienungsanleitung

Maytag

Maytag MIM1554WRS - Ice Maker Bedienungsanleitung

Princess

Princess Yonanas Bedienungsanleitung

Unold

Unold 48946 Bedienungsanleitung

Electrolux

Electrolux E15IM60GP Bedienungsanleitung

Cornelius

Cornelius UC150 ICE ONLY Bedienungsanleitung

Wessamat

Wessamat CombiLine W80 EL Bedienungsanleitung

Summit

Summit BIM68OSGDR Bedienungsanleitung