HP Kayak XA 05xx Bedienungsanleitung

HP Kayak XA 05xx PC Workstation—

Installing Accessories

In Your HP Minitower PC Workstation

Explains in detail how to install accessories, such as extra memory,

accessory boards, and additional disk drives.

Asmt-in.fm Page 1 Friday, March 26, 1999 10:22 AM

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC

Workstation

Supported HP Accessories

2English

Supported HP Accessories

Contact your dealer for an up-to-date list of supported devices.

Up to six accessory boards

can be installed:

- One AGP slot (graphics)

- Three 32-bit PCI slots (one used by SCSI/LAN board on some models)

- One combination PCI or ISA slot

- One 16-bit ISA slot (used by audio board)

Front Access Drives, for example:

- 3.5-inch 1.44 MB flexible disk drive

(one third height)

- 5.25-inch DDS tape drive (half height)

Pack of five pairs of rails for

Front Access Devices:

- 3.5-inch disk drives (D3566A)

- 5.25-inch disk drives (D2880A)

Main Memory Upgrades

DIMM slots for 100 MHz SDRAM:

- 32 MB SDRAM (D6521A)

- 64 MB SDRAM (D6522A)

- 128 MB SDRAM (D6523A)

- 256 MB SDRAM (D6743A)

Asmt-in.fm Page 2 Friday, March 26, 1999 10:22 AM

English 3

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC Workstation

Removing and Replacing the Cover

WARNING For your safety, never remove the PC Workstation’s cover without first

removing the power cord from the power outlet, and any connection to

a telecommunications network. Always replace the cover on the

PC Workstation before switching it on again.

Removing the Cover

1Switch off the display and computer.

2Disconnect all power cables and any LAN or telecommunications

cables.

3If necessary, unlock the cover using the key on the back panel.

4Lift the two latches on the front sides of the computer upwards.

5Grasp the cover on the sides at the back of the computer and slide

it forwards and off the computer.

Asmt-in.fm Page 3 Friday, March 26, 1999 10:22 AM

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC

Workstation

Removing and Replacing the Cover

4English

Replacing the Cover

1Ensure that you have installed all your accessories and that all

internal cables are properly connected and safely routed.

2Ensure that the two latches on the front sides of the cover are lifted

up, and that the lock is unlocked.

3Slide the cover onto the computer, making sure that the two guides

at the bottom of the case slide into the two rails at the base of the

computer. Firmly slide the cover backwards into position.

4Lower the latches on the front sides of the cover.

5If required, lock the cover using the key provided.

6Reconnect all the power and telecommunications cables.

Step 3. Press here on both

sides of the PC’s cover.

Step 4. Lower these two

latches to secure the cover.

Asmt-in.fm Page 4 Friday, March 26, 1999 10:22 AM

English 5

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC Workstation

Moving the Power Supply

1Disconnect the computer’s power cord and any LAN cable.

2Remove the computer’s cover (see page 3).

3Remove the fan connection to the system board.

4Press the retaining buttons on each side of the HP UltraFlow airflow

guide and lift it out of the PC Workstation’s case.

5Unscrew the four self-retaining screws at the back of the power

supply.

HP UltraFlow

Airflow Guide

Retaining button

Fan connection to

system board

Unscrew the

self-retaining screws

Asmt-in.fm Page 5 Friday, March 26, 1999 10:22 AM

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC

Workstation

Moving the Power Supply

6English

WARNING To avoid electrical shock, do not open the power supply.

6Slide the power supply out of the computer until it stops—the

power supply unit remains connected to the computer.

Replacing the Power

Supply after Installing

Accessories

1Check that all internal cables are safely routed.

2Slide the power supply back into the computer.

3Tighten the four self-retaining screws.

4Replace the HP UltraFlow airflow guide.

5Reconnect the fan to the system board.

Slide the power

supply unit clear of

the computer

Power Supply

Asmt-in.fm Page 6 Friday, March 26, 1999 10:22 AM

English 7

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC Workstation

Installing Memory

Main Memory Modules

If you need more main memory, you can install up to 768 MB of

memory in three 100 MHz DIMM slots.

Main memory upgrades are available in single unbuffered 32 MB,

64 MB, 128 MB or 256 MB SDRAM memory modules.

CAUTION Static electricity can damage electronic components. Turn off all

equipment. Do not let your clothes touch the accessory.

To equalize the static electricity, rest the accessory bag on top of the

power supply while you are removing the accessory from the bag.

Handle the accessory as little as possible and with car

To install a main memory module:

1Disconnect the computer’s power cord and any LAN or

telecommunications cable.

2Remove the computer’s cover (see page 3).

3Remove the fan connection to the system board (see the illustration

on page 5).

4Press the retaining buttons on each side of the HP UltraFlow airflow

guide and lift it out of the PC Workstation’s case.

5Remove the airflow guide covering the processor sockets (if

needed).

6Remove the transparent SCSI holder to provide easy access to the

memory module slots.

Asmt-in.fm Page 7 Friday, March 26, 1999 10:22 AM

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC

Workstation

Installing Memory

8English

7The location of the memory module slots is shown here.

8Slide the memory module into the slot at 90° to the system board

(with the cutouts furthest away from the processor).

9Firmly press the memory module completely into the connector

until the retaining clips click into position.

10 Repeat this procedure for each additional memory module you want

to install.

Slide the memory module

into the slot at 90oto the

system board

Push the module until

the retaining clips click

into position

Memory module

cutouts

Asmt-in.fm Page 8 Friday, March 26, 1999 10:22 AM

English 9

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC Workstation

Installing Memory

11 Install any other accessories if necessary, then replace all units and

reconnect all cables and power cords. Replace the cover (see page

4).

12 Check the HP Summary Screen to verify the new configuration.

Video Adapter

Accessories Available

from Other Sources

Additional accessories, including a video MPEG module, are available

for your video adapter. However, these accessories cannot be ordered

from HP. Contact your dealer for more details about these accessories.

NOTE A video MPEG module is only available if your PC is equipped with the

Matrox Millennium G200 graphics accelerator.

Asmt-in.fm Page 9 Friday, March 26, 1999 10:22 AM

HP Kayak XA 05xx PC Workstation — Installing Accessories In Your HP Minitower PC

Workstation

Installing Mass Storage Devices

10 English

Installing Mass Storage Devices

Connecting Devices

If you add an IDE Zip drive, hard disk drive, CD-ROM drive, CD-RW

drive, or tape drive, you need to connect it to power and data cables.

The data cables and connectors provided are shown below:

Cable with two 40-pin connectors for

IDE Drives, such as CD-ROM Drives,

Zip Drives or Hard Disk Drives.

34-pin connector

Cable with one

connector for

3.5-inch Flexible

Disk Drive

On selected models, a 16-bit SCSI with

five 68-pin SCSI connectors

On selected models, a

16-bit External 68-pin

SCSI connector

40-pin connectors

Power Cables for Hard Disk

Drives, Zip Drives, Tape Drives,

CD-RW, and CD-ROM Drives

Power Cable for 3.5-inch

Flexible Disk Drive

Asmt-in.fm Page 10 Friday, March 26, 1999 10:22 AM

Andere Handbücher für Kayak XA 05xx

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Visualize j6000 Referenzhandbuch

HP Visualize c100 Handbuch

HP Pavilion t450 Bedienungsanleitung

HP Vectra VL800 Bedienungsanleitung

HP EliteDesk 705 G1 Bedienungsanleitung

HP Pavilion t400 - Desktop PC Bedienungsanleitung

HP 744 Bedienungsanleitung

HP dx2250 - Microtower PC Bedienungsanleitung

HP Compaq Presario Technisches Datenblatt

HP Compaq Presario Bedienungsanleitung

HP EliteDesk 800 G3 Montageanleitung

HP Pavilion 300 - Desktop PC Bedienungsanleitung

HP 9000 Series 360 Anleitung zur Verwendung

HP Compaq t1010 Bedienungsanleitung

HP Compaq dx6050 MT Bedienungsanleitung

HP DesignJet T610 Bedienungsanleitung

HP Evo D300 MT Handbuch

HP Compaq dc5000 MT Technisches Datenblatt

HP Pavilion 590 Montageanleitung

HP Pavilion t449 Bedienungsanleitung

HP EX470 - MediaSmart Server - 512 MB RAM Anleitung zur Verwendung

HP Vectra XM5 4 Montage- und Wartungsanleitung

HP Xw4200 - Workstation - 1 GB RAM Bedienungsanleitung

HP 280 G4 Montageanleitung

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Lenovo

Lenovo ThinkCentre Edge 72 Handbuch

Lenovo

Lenovo ThinkStation D20 Handbuch

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung