HP Kayak XU 04xx Bedienungsanleitung

HP Kayak XU PC Workstation —

Setting Up and Using Your

HP PC Workstation

Cog-sett.fm Page 1 Thursday, February 4, 1999 11:48 AM

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Connecting the Mouse, Keyboard, Display and Printer

2English

Connecting the Mouse, Keyboard, Display and Printer

Connect the mouse, keyboard, display and printer to the back of the

PC workstation. The connectors are shaped to go in one way only.

Tighten the display cable attachment screws.

NOTE The Universal Serial Bus (USB) connectors can be used for USB

accessories. Most USB accessories are automatically configured as soon

as they are physically attached to the PC Workstation. USB accessories

are not supported by all operating systems.

Mouse

Connector

Keyboard

Connector

2 USB Connectors

(see note below)

Serial

Port A Serial

Port B

Parallel

Connector

Monitor

Connector

Cog-sett.fm Page 2 Thursday, February 4, 1999 11:48 AM

English 3

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Connecting to a Network

The LAN adapter supports both 10 Mbit/s and 100 Mbit/s operations

and automatically detects which network type is being used.

1Connect the RJ-45 plug on your network cable to the LAN connector

on the LAN Adapter. Push the plug into the connector until the plug

clicks into place.

2Attach the other end of the LAN cable to a hub (or into a wall socket

that is connected to a hub).

For further instructions on configuring your network connection,

refer to the Upgrade and Configuration Guide available on HP’s

Web site.

Refer also to the online Network Administrator’s Guide

(provided on an HP CD-ROM) for further instructions on setting up

your PC Workstation for a LAN connection.

The board shown here is

a combined SCSI/LAN

board.

Cog-sett.fm Page 3 Thursday, February 4, 1999 11:48 AM

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Connecting Audio Accessories

4English

Connecting Audio Accessories

WARNING To avoid discomfort from unexpected noise, always turn down the

volume before connecting headphones or speakers.

Listening to loud sounds for prolonged periods may permanently

damage your hearing.

Before putting on headphones, place them around your neck and turn

down the volume. When you put on the headphones, slowly increase

the volume until you find a comfortable listening level, then leave the

volume control in that position.

Dual MIDI/Joystick

connector

LINE IN jack

LINE OUT jack

Audio Front Panel

MIC IN jack

NOTE

The internal speaker and LINE OUT

jack on the rear panel of your

PC Workstation are deactivated

when you use the Headphones jack

on the Audio Front Panel.

The internal speaker is deactivated

when you use the LINE OUT jack.

External speakers you connect

should have a built-in power

supply.

The audio accessories shown here

(microphone, speakers, and audio

system) are not supplied with your

PC Workstation.

Volume can be controlled through

the HP enhanced keyboard, or the

software volume control.

Cog-sett.fm Page 4 Thursday, February 4, 1999 11:48 AM

English 5

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Connecting an External SCSI Accessory

An external SCSI device can be connected as follows:

1You should assign an unused SCSI ID to the device. SCSI IDs range

from 0 to 15 for wide 16-bit SCSI devices. Generally, the SCSI ID 0

is reserved for the first SCSI hard disk drive and SCSI ID 7 is

reserved for the SCSI controller (the default for narrow and wide

SCSI devices).

NOTE Depending on your operating system, you may need to set a SCSI ID for

Plug and Play SCSI devices (SCSI devices that support the SCAM

protocol).

2Make sure the SCSI device is terminated correctly—either

internally or by a terminating resistor (refer to the manual provided

with the SCSI device).

3Connect the SCSI device to your PC Workstation’s external 16-bit

SCSI connector with a shielded SCSI cable.

4Refer to the manual provided with the SCSI device to learn how to

install any software that may be necessary to use it.

NOTE The total length of the external SCSI cables should not exceed 3 meters

(approximately 10 feet).

Step 2: Make sure

the SCSI device is

terminated

Step 3: Connect SCSI

device to your PC

Workstation

Cog-sett.fm Page 5 Thursday, February 4, 1999 11:48 AM

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

The MaxiLife Control Panel

6English

The MaxiLife Control Panel

The MaxiLife panel is located on the front of your PC Workstation.

HP MaxiLife and its

Liquid Crystal Display

(LCD)

HP MaxiLife and its LCD screen helps you diagnose problems with your

PC Workstation and provides system information you may need to

obtain support. Press one of the LCD control buttons to display the

menu. Use to scroll through the menu items and to select the

item required.

PC Lock Button With the HP Lock installed, you can use this button to prevent

unauthorized access of your PC Workstation during your absence.

Your applications will remain active. To unlock the PC Workstation,

enter the Window’s login password (refer to Window’s Help in the Start

menu for more information on setting or changing this password).

Network Activity Light This light glows/flickers when your PC Workstation is accessing

the network.

Hard Disk Activity

Light

This light glows/flickers when your hard disk drive is being accessed.

Power On/Off

Button and

LED

Reset Button

PC Lock Button

and LED

Network Activity Light

Hard Disk Activity Light LCD Control Buttons

Cog-sett.fm Page 6 Thursday, February 4, 1999 11:48 AM

English 7

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Using Your HP Enhanced Keyboard

The HP enhanced keyboard includes soft keys you can use to:

•Display and configure the actions assigned to keys.

•Perform one-touch shortcuts to start applications, open files, or

open sites on the WWW.

•Launch the Internet browser supplied with your system.

•Lock or suspend your PC Workstation.

•Access HP TopTools and customer information.

•Mute or adjust the volume of the audio system.

Menu Key Pressing the “?” Menu soft key displays the soft key section of the HP

enhanced keyboard on your screen. Click any of the keys on the screen

to display the action assigned to an individual key or to change or assign

an action to a key. Shortcut keys are provided specifically for user-

defined actions.

Menu key

Lock/Suspend key

Internet key

HP TopTools

Shortcut key HP Customer

Information

Volume

control

keys

Shortcut keys

Mute key

Cog-sett.fm Page 7 Thursday, February 4, 1999 11:48 AM

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

The HP Summary Screen and Setup Program

8English

The HP Summary Screen and Setup Program

You can use the Summary Screen and the Setup program to configure

your PC Workstation and solve configuration problems with your PC

Workstation.

Starting the HP Setup Program

1Turn on the display and then the PC Workstation. If the PC

Workstation is already turned on, save your data and exit all

programs, then restart the PC Workstation. Consult your operating

system documentation for any special instructions concerning

turning off and then restarting your PC Workstation.

2Press while Setup is displayed at the bottom of the screen.

If you fail to press in time and the start-up process continues,

you will need to restart your PC Workstation to go through the

POST again so you can press .

The opening screen of the PC Workstation’s Setup program is

displayed.

Viewing the HP Summary Screen

Check your PC Workstation’s configuration each time after you install,

remove, or upgrade accessories. To check the configuration:

1Turn on the display and then the PC Workstation. If the PC

Workstation is already turned on, save your data and exit all

programs, then restart the PC Workstation. Consult your operating

system documentation for any special instructions concerning

turning off and then restarting your PC Workstation.

2While the start-up logo appears on your display, press . This

takes you to the HP Summary Screen. (To go immediately into the

Setup program, and bypass the Summary Screen, press instead

of ). The Summary Screen is displayed for only a short time. To

retain the screen (until you decide to leave it), press .

Cog-sett.fm Page 8 Thursday, February 4, 1999 11:48 AM

English 9

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Setting Hardware Passwords

You can set two passwords, the Hardware Administrator (or

Supervisor) password and the Hardware User password, to provide

two levels of protection for your PC Workstation. You set both

passwords using the Security menu in the Setup program.

Setting a Password

To set a Hardware Administrator or User password:

1Start the Setup program.

2Select the Security menu.

3Select the Administrator or User password submenu.

4Choose the Set Administrator or User password setup item. You will be

asked to enter your password twice.

5To save your changes and exit the Setup program press or

select Exit Menu, then Exit Saving Changes.

To remove the password, follow the same procedure as to set a

password. You will be asked to enter the existing password first. Then,

for the new password, leave the password field blank and press

. To confirm your choice, press a second time.

Cog-sett.fm Page 9 Thursday, February 4, 1999 11:48 AM

HP Kayak XU PC Workstation — Setting Up and Using Your HP PC Workstation

Configuring Your Network Connection

10 English

Configuring Your Network Connection

Use the information in this section if your PC Workstation comes with

an HP-supplied integrated network solution.

You must use the PC Workstation's Setup program to change the

integrated Ethernet interface settings.

The following table summarizes which network options you can set

using the Setup program.

Network Setup Items1

1. For full information on setting up your network, refer to the online Network Administrator’s

Guide preloaded onto your PC Workstation.

2. Disabling the LAN card will only disable certain features of the LAN card, such as remote

power-on or remote wakeup, not the card itself.

Where to find in Setup

Enable the integrated network interface.2In the Advanced menu, go to the Integrated

Network Interface submenu.

Enable your PC Workstation to be started (booted

and logged on) from the network.

In the Security menu, go to the Boot Devices

Security submenu (described below).

Enable remote power-on of your PC Workstation. In the Power menu, enable the Integrated

Network item.

From “Suspend Wakeup” mode, enable your PC

Workstation to return to full power when a

command is received by the integrated network

interface.

In the Power menu, enable the Integrated

Network item.

Determine boot device priority. In the Boot menu, select the Boot Device

Priority list item (described on the next page).

Cog-sett.fm Page 10 Thursday, February 4, 1999 11:48 AM

Andere Handbücher für Kayak XU 04xx

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Pavilion P21110 Bedienungsanleitung

HP Pavilion t500 - Desktop PC Gebrauchsanweisung

HP TouchSmart 9300 Bedienungs- und Wartungshandbuch

HP ENVY Phoenix 810 Betriebsanleitung

HP Vectra XM5 3 Handbuch

HP Omni 220-1200 Bedienungsanleitung

HP Media Center m400 - Desktop PC Technisches Datenblatt

HP Kayak XA Bedienungsanleitung

HP ProOne 600 G5 Montageanleitung

HP Compaq 6000 Pro SFF Bedienungsanleitung

HP Kayak XU Series 03 Bedienungsanleitung

HP Media Center,Pavilion Media Center m370 Bedienungsanleitung

HP Workstation Z600 Bedienungsanleitung

HP LaserJet 4300 series Bedienungsanleitung

HP Compaq dx6050 MT Bedienungs- und Wartungshandbuch

HP A524x - Pavilion - 512 MB RAM Montageanleitung

HP Presario All-in-One CQ1-3000 Bedienungsanleitung

HP Presario SR1100 - Desktop PC Technisches Datenblatt

HP Pavilion 400 - Desktop PC Montageanleitung

HP i2000 Bedienungsanleitung

HP Pavilion 403 Handbuch

HP Pavilion t3000 - Desktop PC Montageanleitung

HP Compaq dc5750 MT Bedienungs- und Wartungshandbuch

HP Z8 G4 Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung