HP Visualize c100 Anleitung zur Verwendung
HEWLETT
PACKARD
Service Handbook
C Class
Model C100/110
HP Part No. A4200-90039
Edition E0995
Printed in U.S.A.
ii
Hewlett-Packard Co. 1995
Printing History
First Printing: September 1995
UNIX is a registered trademark in the United States and other
countries, licensed exclusively through X/Open Company Lim-
ited.
NOTICE
The information contained in this document is subject to change
without notice.
HEWLETT-PACKARD MAKES NO WARRANTY OF ANY
KIND WITH REGARD TO THIS MATERIAL INCLUDING
BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. Hewlett-Packard shall not be liable for errors con-
tained herein or for incidental or consequential damages in con-
nection with the furnishing, performance or use of this material.
Hewlett-Packard assumes no responsibility for the use or reliabil-
ity of its software on equipment that is not furnished by Hewlett-
Packard.
This document contains proprietary information that is protected
by copyright. All rights reserved. No part of this document may be
photocopied, reproduced or translated to another language without
the prior written consent of Hewlett-Packard Company.
RESTRICTED RIGHTS LEGEND. Use, duplication, or disclo-
sure by government is subject to restrictions as set forth in subdivi-
sion (c) (1) (ii) of the Rights in Technical Data and Computer
Software Clause at DFARS 252.227.7013. Hewlett-Packard Co.,
3000 Hanover St., Palo Alto, CA 94304.
10 9 8 7 6 5 4 3 2 1
Safety and Regulatory Statements
iii
Safety and Regulatory Statements
This section contains safety and regulatory statements
pertaining to your C100/C110 workstation. It provides
information on the followingtopics:
• Emissions regulations
• Emissions regulations compliance
• Datacom users statement
• Acoustics
• Electrostatic discharge (ESD) precautions
• Safety statement
• Laser safety statements
• Warnings and cautions
Emissions Regulations
iv
Emissions Regulations
Federal Communications Commission (FCC)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules and the Canadian Depart-
ment of Communications. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gen-
erates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception (determined by turning
the equipment off and on), you can correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Ask the dealer or an experienced radio/television techni-
cian for help.
Hewlett-Packard’s system certification tests were con-
ducted with HP-supported peripheral devices and HP
shielded cables, such as those you receive with your
computer. Changes or modifications not expressly
approved by Hewlett-Packard could void the user’s
authority to operate the equipment.
Emissions Regulations Compliance
v
Operation of this device is subject to the following
conditions:
• This device may not cause harmful interference.
• This device must accept interference received, including
interference that may cause undesired operation.
• Cablesusedwiththisdevicemustbeproperlyshieldedto
comply with the requirements of the FCC.
VCCI Class 2 ITE
Emissions Regulations Compliance
Any third-party I/O device installed in HP system(s)
must be in accordance with the requirements set forth
in the preceding Emissions Regulations statements. In
the event that a third-party noncompliant I/O device is
installed, the customer assumes all responsibility and
liability arising therefrom.
Acoustics
vi
Acoustics
RegulationOnNoiseDeclarationForMachines
-3. GSGV
Lpa <70dB Lpa<70dB
operator position am Arbeitsplatz
normal operation normaler Betrieb
per ISO 7779 nach DIN 45635 T.19
Electrostatic Discharge (ESD)
Precautions
Electrostatic charges can damage the integrated cir-
cuits on printed circuit boards. To prevent such dam-
age from occurring, observe the following precautions
during board unpacking and installation:
• Stand on a static-free mat.
• Wear a static strap to ensure that any accumulated elec-
trostatic charge is discharged from your body to ground.
• Connect all equipment together, including the static-free
mat, static strap, routing nodes, and peripheral units.
• Keepuninstalledprintedcircuitboardsintheirprotective
antistatic bags.
• Handle printed circuit boards by their edges, once you
have removed them from their protective antistatic bags.
Safety Statement
vii
Safety Statement
This equipment conforms to the following safety stan-
dards:
• UL 1950
• CSA 950
• IEC 950
• EN 60950
Laser Safety Statement (U.S.A. Only)
The CD ROM mass-storage system is certified as a
Class-1 laser product under the U.S. Department of
Health and Human Services (DHHS) Radiation Per-
formance Standard according to the Radiation Control
for Health and Safety Act of 1968.
This means that the mass-storage system does not pro-
duce hazardous laser radiation. Because laser light
emitted inside the mass-storage system is completely
confined within protective housings and external cov-
ers, the laser beam cannot escape from the machine
during any phase of user operation.
Warnings and Cautions
viii
Warnings and Cautions
Contents
ix
Safety and Regulatory Statements iii
Emissions Regulations iv
Emissions Regulations Compliance v
Acoustics vi
GSGV vi
Electrostatic Discharge (ESD) Precautions vi
Safety Statement vii
Laser Safety Statement (U.S.A. Only) vii
Warnings and Cautions viii
1 Product Information
Product Description 3
System Unit Front Panel Controls 6
System Power Switch 6
Power LED 7
System LEDs 7
Audio Controls 8
Storage Device Controls and Features 8
CD-ROM Drive 9
DDS Tape Drive 11
Floppy Disk Drive 13
System Unit Rear Panel Connectors 14
Security Loop 15
Contents
x
Audio Connectors 15
Keyboard and Mouse Connectors 18
PS/2 Keyboard and Mouse Connectors 18
ITF Keyboard Connector 18
HP Parallel I/O Connector 18
802.3 Network Connectors 18
Serial Input/Output Connectors 19
SCSI Connectors 20
TOC Button 20
Power Cord Connector 20
Monitors 21
Keyboards 22
Keyboard Differences 22
Pointing Devices 25
Operating System Overview 26
2 Environmental/Installation/PM
Environmental Specifications 29
Installation 31
Preventive Maintenance 31
Andere Handbücher für Visualize c100
6
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere HP Desktop Handbücher
HP
HP Pro 3000 SFF Bedienungs- und Wartungshandbuch
HP
HP Evo d520 Montageanleitung
HP
HP EliteDesk 705 G3 Handbuch
HP
HP AlphaServer DS25 Gebrauchsanweisung
HP
HP Pavilion v300 - Desktop PC Montageanleitung
HP
HP Compaq dx7200 MT Handbuch
HP
HP 743 Series Gebrauchs- und Pflegehandbuch
HP
HP Compaq Presario Bedienungsanleitung
HP
HP Compaq dc7800 Small Form Factor Business Montageanleitung
HP
HP Vectra VL410 Installations- und Betriebshandbuch
HP
HP Kayak XA 05xx Bedienungsanleitung
HP
HP Xw6400 - Workstation - 4 GB RAM Gebrauchsanweisung
HP
HP Vectra XU6 Bedienungsanleitung
HP
HP Compaq Presario Bedienungsanleitung
HP
HP Vectra VE5 2 Produkthandbuch
HP
HP VH677UA#ABA - Pavilion Dv6-1244sb... Bedienungsanleitung
HP
HP Compaq 6000 Gebrauchsanweisung
HP
HP d325 Series Gebrauchsanweisung
HP
HP SignagePlayer mp8200 Gebrauchsanweisung
HP
HP Presario All-in-One CQ1-2100 Bedienungsanleitung
