HP XM600 - Kayak - 128 MB RAM Bedienungsanleitung

HP Kayak XM600 Minitower

Troubleshooting Guide

HP Kayak XM600 Series 2

and HP Kayak XM600

This User’s Guide covers the HP Kayak XM600

Series 2, equipped with socket-mounted processors.

These PCs carry the model number P2190N and higher.

A separate User’s Manual is available for the HP Kayak

XM600, equipped with slot-mounted processors.

Each PC has a Support Label on its outer case clearly

identifying the series to which it belongs. When looking

at the PC from the front, the label is located on the right-

hand side-panel, close to the bottom of the panel.

The Support Label states the Model, the Model Number

and the Serial Number. The label includes the following

information:

HP Kayak XM600

These PCs carry the model numbers Dxxxx (all) and

Pxxxx up to P2189N.

HP Kayak XM600 Series 2

These PC carry the model numbers P2190N and higher.

iii

Contents

Your PC Workstation does not start correctly,

or does not start at all. Refer to page 7.

For example, the monitor is blank, error messages during boot,

beep codes emitted.

Your PC Workstation starts normally, but you are

having problems configuring. Refer to page 19.

For example, hardware not detected, mouse doesn’t work properly,

no sound from speakers.

Troubleshooting your PC Workstation

using HP DiagTools. Refer to page 39.

You can diagnose hardware-related problems, test

individual hardware components and check hardware configuration.

Recovering hard disk drive contents with the

recovery CD-ROM. Refer to page 47.

You can restore the preloaded operating system,

drivers, utilities and software.

Other useful sources of information. Refer to page 49.

How to obtain the latest drivers, software utilities and BIOS updates.

Also details on how to download documentation

corresponding to your PC Workstation.

Contacting HP Support Services. Refer to page 50.

Details the type of information you should prepare before

contacting HP Support for assistance.

iv Francais

Notice

The information contained in this document is subject to change

without notice.

Hewlett-Packard makes no warranty of any kind with regard to this

material, including, but not limited to, the implied warranties of

merchantability and fitness for a particular purpose. Hewlett-Packard

shall not be liable for errors contained herein or for incidental or

consequential damages in connection with the furnishing, performance,

or use of this material.

This document contains proprietary information that is protected by

photocopied, reproduced, or translated to another language without the

prior written consent of Hewlett-Packard Company.

AdobeTM and AcrobatTM are trademarks of Adobe Systems Incorporated.

McAfee VirusScan®is a registered trademark of Network Associates,

Inc.

Microsoft®, MS®, MS-DOS®, Windows®, and Windows NT®are U.S.

registered trademarks of Microsoft Corporation.

Pentium®is a registered trademark of Intel Corporation.

Hewlett-Packard France

Business Desktop Division (BDD)

Outbound Marketing Communications

38053 Grenoble Cedex 9

France

2000 Hewlett-Packard Company

Introduction

This manual is for anyone who wants to:

•Troubleshoot problems on the PC Workstation

•Find out where to get more information and support.

For information about setting up and using your PC Workstation, refer

to the User’s Guide that came with your PC Workstation. It is also

available on HP’s web site at: www.hp.com/go/kayaksupport.

Important Warnings

Removing and Replacing the Cover

WARNING For your safety, never remove the PC Workstation’s cover without first

removing the power cord from the power outlet and any connection to a

telecommunications network. Always replace the cover before switching the

PC Workstation on again.

Safety Information

WARNING There is a danger of explosion if the battery is incorrectly installed. For your

safety, never attempt to recharge, disassemble, or burn an old battery. Only

replace the battery with the same or equivalent type, as recommended by the

manufacturer. The battery in this PC is a lithium battery which does not

contain any heavy metals. Nevertheless, in order to protect the environment,

do not dispose of batteries in household waste. Please return used batteries

either to the shop from which you bought them, to the dealer from whom you

purchased your PC, or to HP so that they can either be recycled or disposed

of in the correct way . Returned batteries will be accepted free of charge.

If you have a modem:

Do not attempt to connect this product to the phone line during a lightning

storm. Never install telephone jacks in wet locations unless the telephone line

has been disconnected at the network interface. Never touch uninsulated

telephone wires or terminals unless the telephone line has been disconnected

at the network interface. Use caution when installing or modifying telephone

Introduction

lines. Avoid using a telephone (other than a cordless type) during a lightning

storm. There may be a risk from lightning.

Do not use the telephone to report a gas leak in the vicinity of the leak.

Never touch or remove the communications board without first removing the

connection to the telephone network.

Your PC Workstation Does Not Start Correctly

Symptom Type of Problem

Case 1

When the power button is pressed, the PC

Workstation shows no sign of activity at all:

•PC Workstation may not be correctly connected to

the power supply.

Refer to page 9.

•Monitor is blank.

•No hard disk drive or fan noise.

•MaxiLife status panel does not light up.

Case 2

When the power button is pressed, the PC

Workstation appears to boot, but monitor remains

blank:

•Monitor may be badly connected or not switched

on.

Refer to page 11.

•Hard disk drive and fan can be heard.

•Status LED is GREEN.

•MaxiLife status panel displays a smiling face .

Case 3

When the power button is pressed, the PC

Workstation does not boot:

•HP MaxiLife has detected a hardware

configuration error. A component may be badly

connected inside the PC Workstation.

Refer to page 13.

•Monitor remains blank.

•Status LED is RED.

•Beep code emitted.

•MaxiLife status panel displays an error message

with a sad face .

Case 4

When the power button is pressed, the PC

Workstation starts to boot and there is activity on

the monitor:

•Configuration error has been detected by the

POST (Power-On Self Test).

Refer to page 15.

•Boot process fails with an error message.

•Status LED is RED.

•MaxiLife status panel displays a sad face and

a POST error message.

Case 5

When the power button is pressed, the PC

Workstation starts to boot and there is initially

some activity on the monitor, but then:

•Screen becomes blank.

•Image is corrupt.

•Video card may be improperly installed or

incorrectly configured.

•Hard disk drive failure or not accessible.

Refer to page 17.

Your PC Workstation Does Not Start Correctly

Helpful Information

Troubleshooting Pre-Boot Checks With HP MaxiLife Hardware Refer to page 13.

EMU (Error Message Utility) Description Refer to page 15.

Beep Code Table Refer to page 13.

Troubleshooting BIOS Problems:

•Updating the BIOS. Refer to page 30.

•Restoring BIOS Default Settings. Refer to page 30.

•Clearing the CMOS. Refer to page 31.

•Recovering the BIOS (Crisis Mode). Refer to page 32.

System Board Switches. Refer to page 33.

Using the HP Setup Program. Refer to page 34.

Troubleshooting Hardware With HP e-DiagTools. Refer to page 39.

Your PC Workstation Does Not Start Correctly

Case 1 — If There Is No Activity At All

When the power button is pressed, the PC Workstation appears to boot

(sound from the hard disk drive and fan, and status LED is red), but

the monitor is blank.

•Monitor is blank.

•No hard disk drive or fan noise.

•MaxiLife status panel does not light up or display any messages.

NOTE Before removing the cover, always switch off the display and PC Workstation.

Disconnect the power cord and any accessory cables. When checks have been

completed, close the PC Workstation and reconnect the power cord and accessory

cables. Verify that the PC Workstation boots correctly.

Symptom... Check that... How...

PC Workstation does not start –

the status LED indicator is not

illuminated.

You can access the MaxiLife status panel. Press one of the LCD control buttons to activate MaxiLife. If it

comes to life, the power cord is connected.

If it doesn’t, follow the troubleshooting steps below.

The power cord is correctly connected. Connect the power cord to a grounded power outlet and the

PC Workstation.

The power outlet is working. Plug a light into the grounded power outlet and check that it

comes on.

The voltage switch is correctly set (located

on the rear of the PC Workstation).

1Disconnect the power cord.

2Select the correct setting.

3Reconnect the power cord.

4Start the PC Workstation.

If the PC Workstation still does not start

Check that... How...

None of the internal devices are causing the

problem.

1Remove internal power connectors from all internal

devices (except for the system board).

2Reconnect the power cord.

3Reconnect the power connectors one by one to the internal

devices to see if a device is defective.

4If a device is found to be defective, contact HP Support or

your authorized dealer.

Case 1 — If There Is No Activity At All is continued on the next page ➩

Your PC Workstation Does Not Start Correctly

Case 1 — If There Is No Activity At All

If the PC Workstation still does not start

There is not a problem with the power

supply unit.

1Replace the power supply unit by a known working power

supply from the same model of PC.

2If the PC Workstation starts, contact HP Support or your

authorized dealer. The power supply unit might need

replacing.

If the problem persists, contact HP Support or your authorized dealer

Symptom... Check that... How...

Andere Handbücher für XM600 - Kayak - 128 MB RAM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP ZX2000 Technisches Datenblatt

HP Firebird 802 Bedienungsanleitung

HP Pavilion a400 - Desktop PC Bedienungsanleitung

HP Compaq Elite 8300 All-in-One Installationsanleitung

HP Media Center Installationshandbuch

HP Xw8400 - Workstation - 4 GB RAM Bedienungsanleitung

HP dx2310 - Microtower PC Bedienungsanleitung

HP Compaq t1010 Bedienungsanleitung

HP TouchSmart 520-1100 Bedienungsanleitung

HP ProDesk 600 G5 PCI MT Handbuch

HP Compaq dc7100 MT Bedienungs- und Wartungshandbuch

HP EG652AA Bedienungsanleitung

HP Pavilion t300 - Desktop PC Bedienungsanleitung

HP D530 - Compaq Business Desktop Handbuch

HP EliteDesk 880 G5 Handbuch

HP Compaq dx2200 MT Series Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

HP A524x - Pavilion - 512 MB RAM Montageanleitung

HP Compaq dc7100 MT Handbuch

HP s7600n - Pavilion Media Center Bedienungsanleitung

HP TouchSmart 610 PC Bedienungsanleitung

HP Pavilion a200 - Desktop PC Bedienungsanleitung

HP TouchSmart 520-1050 Bedienungsanleitung

HP Compaq Presario Handbuch

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung