HP Z600 - Workstation - 6 GB RAM Bedienungsanleitung

PCI Express Sound Blaster X-Fi Titanium

audio card installation

Introduction

This document describes the hardware and software installation of the PCI Express (PCIe) Sound

Blaster X-Fi Titanium audio card. For more information, refer to the Installation and Application CD.

Kit contents

●PCIe Sound Blaster X-Fi Titanium audio card

●PCIe Sound Blaster X-Fi Titanium audio card installation guide (this document)

●Installation and Application CD

●Regulatory compliance notices

●Warranty information

System requirements

●Microsoft®, Windows® XP Service Pack 2 or Windows Vista® Service Pack 1 or better or Windows

7®

●Optical drive

●Empty PCIe slot

To view QuickSpecs and determine the compatibility of this product with your HP computer, see

http://www.hp.com/go/productbulletin.

Windows XP, and Windows Vista are U.S. registered trademarks of Microsoft

Corporation. Printed in the U.S.

ENWW Introduction 1

Warnings and cautions

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce

the risk of injury from a hot component, enable the surface to cool before touching.

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed

area marked with this symbol.

WARNING! To reduce the risk of electric shock or damage to your equipment:

— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.

— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.

WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper

computer setup, posture, health, and work habits for computer users, and provides important electrical

and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the

documentation CD (if one is included with the product).

WARNING! If a product is shipped in packaging marked with this symbol, , the product must always

be lifted by two persons to avoid personal injury due to product weight.

CAUTION: Static electricity can damage the electronic components of the computer. Before beginning

these procedures, be sure you discharge static electricity by briefly touching a grounded metal object.

CAUTION: To prevent damage to the computer, observe the following Electrostatic Discharge (ESD)

precautions while performing the system parts removal and replacement procedures:

— Work on a static-free mat.

— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body

to the ground.

— Create a common ground for the equipment you are working on by connecting the static-free mat,

static strap, and peripheral units to that piece of equipment.

NOTE: HP accessories are for use in HP computer products. They have been extensively tested for

reliability and are manufactured to high quality standards.

2 PCI Express Sound Blaster X-Fi Titanium audio card installation ENWW

Step 1—Preparing for component installation

NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and replacement

procedures in the service guide for your computer at http://www.hp.com/support/manuals.

2. Power down the computer, and then disconnect the power cord.

3. Power down all external devices, and then disconnect them from the computer.

4. Remove the side access panel.

Removing components

1. If present, remove the card support to enable access to the expansion slots and system board

connectors.

2. Select an appropriate PCIe expansion slot and remove the slot cover. The Sound Blaster card can

be installed in any PCIe expansion slot.

NOTE: To identify an available PCIe expansion slot, see the service label on the side access

panel.

Figure 1 Removing the expansion slot cover

ENWW Step 1—Preparing for component installation 3

Step 2—Installing the Sound Blaster audio card

1. Install the Sound Blaster audio card (1) in the selected PCIe expansion slot, and then secure the

expansion slot retention clamp (2).

Figure 2 Installing the audio card

2. Disconnect the front audio cable from the front audio header on the system board.

NOTE: To locate system board components, see the service label on the side access panel.

3. Connect the front audio cable from the system board to the front audio connector (1) on the Sound

Blaster audio card.

NOTE: The existing internal front audio cable in certain workstations may be incompatible with

the add-in audio card. In this case, use the audio connections on the card. The HP Z Workstation

series is fully compatible.

Figure 3 PCIe Sound Blaster X-Fi Titanium audio card

4 PCI Express Sound Blaster X-Fi Titanium audio card installation ENWW

Step 3—Reassembling the computer

1. Reinstall the card support, if applicable.

2. Reinstall the side access panel.

3. Reconnect power to the computer and all external devices.

4. Restore power to the computer and all external devices.

5. If the <New Hardware Found Wizard> appears, select Cancel.

Step 4—Installing the application software

The PCIe Sound Blaster X-Fi Titanium audio card supports application software running under

Microsoft® Windows® XP, Microsoft® Windows Vista Business®, and Microsoft® Windows 7®.

To install the Sound Blaster audio card application software, complete the following steps:

1. Insert the Installation and Application CD into the optical drive.

2. Follow the on-screen instructions to install the audio card driver and applications.

3. Restart the computer when prompted.

If the application does not start, double-click the setup.exe file in the Installation and

Application CD.

NOTE: At the time of component installation, look for device driver updates designated for your

computer model and operating system. Obtain updates from http://www.hp.com/#Support.

4. After installing the software, see the speaker manufacturer documentation for instructions on how

to connect the speaker to the computer.

NOTE: When the Sound Blaster audio card is installed, the computer internal chassis speaker

emits only diagnostic beeps. The rear audio connectors on the system board are also disabled

when the Sound Blaster audio card is installed. Use the audio output from the Sound Blaster audio

card for audio connection to the external audio device.

Japanese 日本語

This document is available in Japanese. See http://www.hp.com/support/manuals, then select your

product and select Japanese from the drop down Manual Language menu.

このドキュメントは日本語版が用意されています。http://www.hp.com/support/manuals にアクセス

し、ご使用のワークステーション製品を選択し、Manual Language ドロップダウンメニューから

Japanese を選択してください。

ENWW Step 3—Reassembling the computer 5

6 PCI Express Sound Blaster X-Fi Titanium audio card installation ENWW

Andere Handbücher für Z600 - Workstation - 6 GB RAM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Compaq d538 SFF Handbuch

HP 8000 - Elite Convertible Minitower PC Bedienungsanleitung

HP Pavilion v300 - Desktop PC Bedienungsanleitung

HP Brio 71xx Bedienungsanleitung

HP 742n - Pavilion - 512 MB RAM Montageanleitung

HP Compaq GX5000T CTO Bedienungsanleitung

HP Net PC 20 Handbuch

HP J282 Handbuch

HP Zhan 86 Pro G1 Montageanleitung

HP dx7400 - Microtower PC Bedienungsanleitung

HP Pavilion Elite m9280f Bedienungsanleitung

HP Elite 8300 Series Convertible Minitower Handbuch

HP Pro 3385 Bedienungsanleitung

HP Deskpro 4000 Technisches Dokument

HP TouchSmart IQ520 Bedienungsanleitung

HP Compaq Presario Bedienungsanleitung

HP Vectra XA 6 Series Bedienungsanleitung

HP t630 Thin Client Bedienungsanleitung

HP Pavilion t300 - Desktop PC Bedienungsanleitung

HP Compaq Presario Technisches Datenblatt

HP A524x - Pavilion - 512 MB RAM Bedienungsanleitung

HP TouchSmart 520-1050 Bedienungsanleitung

HP Pavilion p6000 - Desktop PC Bedienungsanleitung

HP TouchSmart IQ700 - Desktop PC Montageanleitung

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung