HP Z600 - Workstation - 6 GB RAM Bedienungsanleitung

IEEE-1394b PCI Express Card installation

Introduction

This document describes how to install an IEEE-1394 PCI Express (PCIe) card in HP series, xw9400,

and xw4600 Workstations.

Kit contents

●IEEE-1394b PCIe card

●Y-adapter power cable

●Warranty information

●Installation instructions

Before you begin

To view QuickSpecs and determine the compatibility of this product with your HP workstation, see

http://www.hp.com/go/productbulletin.

ENWW Introduction 1

Warnings and cautions

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed

area marked with this symbol.

WARNING! To reduce the risk of electric shock or damage to your equipment:

— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.

— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce

the risk of injury from a hot component, enable the surface to cool before touching.

WARNING! If a product is shipped in packaging marked with this symbol, , the product must always

be lifted by two persons to avoid personal injury due to product weight.

WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper

workstation setup, posture, health, and work habits for computer users, and provides important electrical

and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the

documentation CD (if one is included with the product).

CAUTION: Static electricity can damage the electronic components of the workstation. Before

beginning these procedures, be sure you discharge static electricity by briefly touching a grounded metal

object.

CAUTION: To prevent damage to the workstation, observe the following Electrostatic Discharge

(ESD) precautions while performing the system parts removal and replacement procedures:

— Work on a static-free mat.

— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body

to the ground.

— Create a common ground for the equipment you are working on by connecting the static-free mat,

static strap, and peripheral units to that piece of equipment.

NOTE: HP accessories are for use in HP Workstation products. They have been extensively tested

for reliability and are manufactured to high quality standards.

2 IEEE-1394b PCI Express Card installation ENWW

Step 1—Preparing for component installation

NOTE: Workstation models vary. All illustrations are examples only.

Download and install updates

1. Check for available system BIOS updates specified for your HP workstation model and operating

system at http://www.hp.com/go/workstationsupport.

2. Install the system BIOS updates, if available.

Accessing the internal components of the workstation

1. If you need help preparing the workstation for this installation, consult the removal and replacement

procedures in the service guide for your workstation at http://www.hp.com/support/

workstation_manuals.

NOTE: For the HP Workstation series, these procedures are also available in the User

Guide on the Documentation and Diagnostics CD that shipped with your workstation.

2. Power down the workstation, and then disconnect the power cord.

3. Power down all external devices, and then disconnect them from the workstation.

4. Remove the side access panel.

Removing components

1. If present, remove the card support to enable access to the expansion slots and system board

connectors.

2. On HP xw4600, 400, and 600 Workstations, there is a plastic plug or adhesive label over the

1394 port on the front of the workstation.

a. Remove the front bezel.

b. Remove the plastic cover or adhesive label over the port on the front of the workstation.

ENWW Step 1—Preparing for component installation 3

3. Select an appropriate PCIe expansion slot and remove the slot cover. The IEEE-1394 card may

be installed in any unused PCIe expansion slot.

NOTE: To identify an available PCIe expansion slot, see the service label on the side access

panel.

Figure 1 Removing the expansion slot cover

Step 2—Installing the IEEE-1394 card

1. Install the IEEE-1394 card in the selected PCIe expansion slot.

2. Lower the expansion slot retention clamp and close the retention clamp lever

Figure 2 Installing the IEEE-1394 card

4 IEEE-1394b PCI Express Card installation ENWW

Step 3—Configuring the cabling

NOTE: To locate the appropriate connectors on the system board, see the service label on the

workstation access panel.

Table 1 Power and data configuration information

HP 400 Workstations

HP xw4600 Workstations

HP 600 Workstations HP 800 Workstations

HP xw9400 Workstations

1394B ●Power direct from power supply

●Front IEEE 1394 I/O connects to

card

●Requires Y-adapter cable

●Front IEEE 1394 I/O

connects to card

●Requires Y-adapter cable

●Front IEEE 1394 I/O remains

connected to system board. Do

not disconnect.

HP 400 and xw4600 Workstations power and data cabling

1. Connect a mini-plug power connector from the workstation power supply to the power connector

on the IEEE-1394 card .

2. Connect the front IEEE-1394 I/O cable to the I/O connector on the IEEE-1394 card

Figure 3 Connecting the IEEE 1394 cables

ENWW Step 3—Configuring the cabling 5

HP 600, 800 and xw9400 Workstations power and data cabling

1. Connect the center connector of the Y-adapter power cable to the workstation optical drive power

supply .

2. Connect one end of the Y-adapter power cable to the optical drive power connector

3. Connect the other end of the Y-adapter power cable to the power connector on the IEEE-1394 card

NOTE: For HP 800 Workstations and HP xw9400 Workstations, do not unplug the front I/O

connector from the system board.

4. For the HP 600 Workstation, connect the front IEEE1394 I/O cable to the I/O connector on the

IEEE 1394 card. (Shown above in Figure 3Connecting the IEEE 1394 cables on page 5,

)

Figure 4 Connecting the power cable

Step 4—Reassembling the workstation

1. Reinstall the card support, if applicable.

2. Reinstall the side access panel.

3. Reconnect power to the workstation and all external devices.

4. Restore power to the workstation and all external devices.

Japanese 日本語

This document is available in Japanese. See http://www.hp.com/support/workstation_manuals, then

select your workstation product and select Japanese from the drop down Manual Language menu.

このドキュメントは日本語版が用意されています。http://www.hp.com/support/workstation_manuals

にアクセスし、ご使用のワークステーション製品を選択し、Manual Language ドロップダウンメニ

ューから Japanese を選択してください。

6 IEEE-1394b PCI Express Card installation ENWW

Andere Handbücher für Z600 - Workstation - 6 GB RAM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Brio BA Handbuch

HP Compaq 6000 Bedienungsanleitung

HP 742n - Pavilion - 512 MB RAM Bedienungsanleitung

HP M8200n - Pavilion Media Center Technisches Datenblatt

HP Omni Pro 110 Bedienungsanleitung

HP OMNI100 Bedienungsanleitung

HP Pavilion t100 - Desktop PC Anleitung zur Verwendung

HP Vectra XE310 Installations- und Betriebshandbuch

HP RG581AW Bedienungsanleitung

HP Presario S7000 - Desktop PC Allgemeine Anweisungen

HP e-PC c10/s10 Bedienungsanleitung

HP Thin Client Bedienungsanleitung

HP Compaq Presario Bedienungsanleitung

HP Presario SR1200 - Desktop PC Bedienungsanleitung

HP dc7700 - Convertible Minitower PC Bedienungsanleitung

HP A6600f - Pavilion - 3 GB RAM Gebrauchsanweisung

HP 175753-002 - iPAQ - 64 MB RAM Kurzanleitung

HP 300-1020 - TouchSmart - Desktop PC Leitfaden

HP Vectra VT6 Handbuch

HP Vectra VL5 3 Bedienungsanleitung

HP dx2250 - Microtower PC Bedienungs- und Wartungshandbuch

HP Pavilion a200 - Desktop PC Bedienungsanleitung

HP Pavilion a600 - Desktop PC Bedienungsanleitung

HP m9350f - Pavilion - Elite Technisches Datenblatt

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung