HP Z800 - Workstation - 6 GB RAM Bedienungsanleitung

NVIDIA Tesla C1060 Compute Processor

card installation

Introduction

This document describes how to install an NVIDIA Tesla C1060 Compute Processor card with an

auxiliary power adapter cable in an HP 800 Workstation.

Kit contents

●NVIDIA Tesla C1060 Compute Processor card

●6-to-8 pin auxiliary power adapter cable

●Installation instructions (this document)

●Warranty information

Before you begin

To determine the compatibility of this product with your HP workstation, see QuickSpecs online at

http://www.hp.com/go/productbulletin.

Before installing an NVIDIA Tesla C1060 compute processor card, ensure the following criteria are met:

●HP 800 Workstations must contain an 1110 Watt power supply.

●The NVIDIA Tesla C1060 Compute Processor card is a dedicated computational unit, and must

be used in conjunction with a compatible graphics card.

ENWW Introduction 1

Warnings and cautions

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed

area marked with this symbol.

WARNING! To reduce the risk of electric shock or damage to your equipment:

— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.

— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.

WARNING! Any surface or area of the equipment marked with this symbol indicates the presence

of a hot surface or hot component. If this surface is contacted, the potential for injury exists. To reduce

the risk of injury from a hot component, enable the surface to cool before touching.

WARNING! If a product is shipped in packaging marked with this symbol, , the product must always

be lifted by two persons to avoid personal injury due to product weight.

WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper

workstation setup, posture, health, and work habits for computer users, and provides important electrical

and mechanical safety information. This guide is located at http://www.hp.com/ergo and on the

documentation CD (if one is included with the product).

CAUTION: Static electricity can damage the electronic components of the workstation. Before

beginning these procedures, be sure you discharge static electricity by briefly touching a grounded metal

object.

CAUTION: To prevent damage to the workstation, observe the following Electrostatic Discharge

(ESD) precautions while performing the system parts removal and replacement procedures:

— Work on a static-free mat.

— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your body

to the ground.

— Create a common ground for the equipment you are working on by connecting the static-free mat,

static strap, and peripheral units to that piece of equipment.

NOTE: HP accessories are for use in HP Workstation products. They have been extensively tested

for reliability and are manufactured to high quality standards.

2 NVIDIA Tesla C1060 Compute Processor card installation ENWW

Step 1—Preparing for component installation

NOTE: Workstation models vary. All illustrations are examples only.

Accessing the internal components of the workstation

1. If you need help preparing the workstation for this installation, consult the removal and replacement

procedures in the service guide for your workstation at http://www.hp.com/support/

workstation_manuals.

NOTE: For the HP Workstation series, these procedures are also available in the User

Guide on the Documentation and Diagnostics CD that shipped with your workstation.

2. Power down the workstation, and then disconnect the power cord.

3. Power down all external devices, and then disconnect them from the workstation.

4. Remove the side access panel.

Removing components

1. Remove the expansion card support to enable access to the expansion slots and system board

connectors.

2. Select a PCI Express (PCIe)2-x16 expansion slot.

NOTE: To identify a PCIe2-x16 expansion slot, see the service label on the workstation side

access panel.

NOTE: For optimal cooling, keep the expansion slot adjacent to the fan free or filled with an

expansion card that does not obstruct the fan inlet of the Tesla C1060 card.

a. Open the expansion slot retention clamp .

b. Remove the applicable expansion slot covers

Figure 1 Opening the retainer and removing the slot covers

ENWW Step 1—Preparing for component installation 3

Step 2—Installing the graphics card

1. While lowering the card into the chassis, rotate the graphics card bulkhead under the rear chassis

lip .

2. Align the card in a groove of the card guide

and pivot the card until level.

3. Press securely into the PCIe expansion slot .

Figure 2 Installing the card

4 NVIDIA Tesla C1060 Compute Processor card installation ENWW

Step 3—Connecting the power

1. Close the expansion card retention clamp by rotating it downward . The retention clamp is

secured by the expansion card support.

NOTE: It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle

when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly

seated and all the brackets are mated to the chassis, then re-close the clamp.

2. Connect the 6-to-8 pin auxiliary power adapter cable, supplied with this kit, to one of the auxiliary

power cables

, and then to the Tesla C1060 card .

NOTE: No connection is made at point . If a label covers the outlet at , do not remove it.

TIP: The auxiliary power cable connectors are typically stored (attached) to the front expansion

card guide.

Figure 3 Installing the 6-to-8 pin auxiliary power adapter cable

Step 4—Reassembling the workstation

1. Reinstall the expansion card support.

2. Reinstall the side access panel.

3. Reconnect power to the workstation and all external devices.

4. Restore power to the workstation and all external devices.

Step 7—Configuring the software

For instructions on loading and setting up the graphics drivers, see the manufacturer’s documentation

shipped with the NVIDIA Tesla graphics card.

At the time of component installation, look for device firmware and driver updates, designated for your

workstation model and operating system from http://www.hp.com/go/workstationsupport.

ENWW Step 3—Connecting the power 5

Japanese 日本語

This document is available in Japanese. See http://www.hp.com/support/workstation_manuals, then

select your workstation product and select Japanese from the drop down Manual Language menu.

このドキュメントは日本語版が用意されています。http://www.hp.com/support/workstation_manuals

にアクセスし、ご使用のワークステーション製品を選択し、Manual Language ドロップダウンメニ

ューから Japanese を選択してください。

6 NVIDIA Tesla C1060 Compute Processor card installation ENWW

Andere Handbücher für Z800 - Workstation - 6 GB RAM

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Pavilion t600 - Desktop PC Bedienungsanleitung

HP Elite 7100 Gebrauchsanweisung

HP Presario 6500 - Desktop PC Leitfaden

HP Pavilion t490 Montageanleitung

HP Pavilion a230 Bedienungsanleitung

HP Vectra VE5 4 Bedienungsanleitung

HP Pro 6000 Montageanleitung

HP A320m - Pavilion - 256 MB RAM Bedienungsanleitung

HP TouchSmart 310-1125 Bedienungsanleitung

HP Pavilion Slimline s7200 - Desktop PC Bedienungsanleitung

HP Model 712/100 - Workstation Bedienungsanleitung

HP Compaq GX5000T CTO Technisches Datenblatt

HP dx2355 - Microtower PC Bedienungs- und Wartungshandbuch

HP Vectra VLi 8 Bedienungsanleitung

HP ProDesk 400 G1 Handbuch

HP ZX2000 Bedienungsanleitung

HP Pro 3100 Series Gebrauchsanweisung

HP TouchSmart IQ830 Bedienungsanleitung

HP Brio 8200 Bedienungsanleitung

HP Pavilion 403 Handbuch

HP HP700196 Bedienungsanleitung

HP dx2480 - Microtower PC Bedienungs- und Wartungshandbuch

HP Pavilion p6210f Technisches Datenblatt

HP Pavilion a700 - Desktop PC Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung