HP D Series Installations- und Betriebshandbuch

System Memory Upgrade Guide

D Class and R Class

HP 9000 Enterprise Servers

Part No. A3262-90003

Edition 6

October 1998

E1098

Printed in: USA

Legal Notices

The information in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this manual,

including, but not limited to, the implied warranties of merchantability and fitness

for a particular purpose. Hewlett-Packard shall not be held liable for errors

contained herein or direct, indirect, special, incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

Restricted Rights Legend. Use, duplication or disclosure by the U.S. Government

is subject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in

Technical Data and Computer Software clause at DFARS 252.227-7013 for DOD

agencies, and subparagraphs (c) (1) and (c) (2) of the Commercial Computer

Software Restricted Rights clause at FAR 52.227-19 for other agencies.

HEWLETT-PACKARD COMPANY 3000 Hanover Street Palo Alto, California

94304 U.S.A.

reserved.

Reproduction, adaptation, or translation of this document without prior written

permission is prohibited, except as allowed under the copyright laws.

Trademark Notices. UNIX is a registered trademark in the United States and other

countries, licensed exclusively through X/Open Company Limited.

Contents

iii

Who Should Use this Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vi

1. D Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-24

Memory Upgrade Verification Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-25

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 1-30

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-32

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 1-33

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 1-34

2. R Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 2-24

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-25

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 2-26

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 2-27

Contents

Printing History

The manual printing date and part number indicate its current edition. The printing

date will change when a new edition is printed. Minor changes may be made at

reprint without changing the printing date. the manual part number will change

when extensive changes are made.

Manual updates may be issued between editions to correct errors or document

product changes. To ensure that you receive the updated or new editions, you should

subscribe to the appropriate product support service. See your HP sales

representative for details.

First Edition: December, 1995

Second Edition: May, 1996

Third Edition: November, 1996

Fourth Edition: August, 1997

Fifth Edition: August 1998

Sixth Edition: October 1998

NOTE Reader Comments. We welcome your comments about our documentation. If you

have editorial suggestions or recommended improvements for this document, please

write to us. You can reach us through e-mail at: hardwaredocs@cup.hp.com or by

sending your letter to: Documentation Manager, M/S 5657, Hewlett-Packard

Company, 8000 Foothills Blvd., Roseville, CA 95747-6588 USA. Please include the

following information in your message:

• Title of the manual you are referencing.

• Manual part number (from the title page).

• Edition number or publication date (from the title page)..

• Your name.

• Your company’s name.

SERIOUS ERRORS, such as technical inaccuracies that may render a program or a

hardware device inoperative, should be reported to your HP Response Center or

directly to a Support Engineer.

Who Should Use this Guide

The procedures in this guide are intended to be performed by a person who is

qualified in the installation and servicing of computer equipment, and is trained to

recognize the hazards involved. Memory is installed in an area of the product where

energy levels considered hazardous may be produced.

1-1

D Class System Memory Upgrade

Overview of Memory Installation

The memory installation procedures are organized as follows:

A. Check existing system memory.

B. Turn off power to the system.

C. Remove the front bezel.

D. Remove the side panel.

E. Remove the EMI cover.

F. Remove the Processor/Memory card.

G. Plan the memory configuration.

H. Install memory modules.

I. Replace the Processor/Memory card.

J. Replace the EMI cover.

K. Replace the side panel.

L. Replace the front bezel.

After completing all installation procedures, proceed to the Memory Upgrade

Verification procedure (located after the installation procedures) for instructions on

how to verify correct installation. If the memory verification is not successful, refer

to the section titled Troubleshooting Memory Configuration Error Symptoms at

the end of this manual.

1-2

D Class System Memory Upgrade

Overview of Memory Installation

Required Tools To perform the procedures in this upgrade guide, the following tools are required:

• Small flat-bladed screwdriver

• Torx driver, #15

• Phillips screwdriver.

Safety

Considerations

WARNING The installation procedures in this guide require opening the system cabinet,

which may expose you to high-energy (high-amperage) circuits, possible

ejection of molten metal, and exposed sharp edges in equipment chassis. Be

sure to remove all rings, watches, and other jewelry from fingers, wrists, and

arms before opening the system cabinet.

Electrostatic

Discharge

Precautions

Electrostatic discharge can damage the integrated circuits on printed-circuit boards.

To prevent such damage from occurring, be sure to observe the following

precautions when handling and installing boards:

1. Use a grounding mat and an anti-static wrist strap, such as those included in the

ESD Field Service Kit (HP P/N A3024-80004).

2. Wear the anti-static wrist strap to ensure that any accumulated electrostatic

charge is discharged from you body to ground.

3. Keep uninstalled printed-circuit boards in their protective anti-static bags until

you are ready to install them.

4. Handle printed-circuit boards by their edges after you have removed them from

their protective anti-static bags.

1-3

D Class System Memory Upgrade

Memory Installation Procedure

A. Check Existing

System Memory To check the memory configuration on your system:

Reboot the system by typing /etc/shutdown -r at the HP-UX system prompt:

/etc/shutdown -r

When prompted, halt the boot process by pressing any key on the keyboard:

Processor is booting from first available device.

To discontinue, press any key within 10 seconds.

Boot terminated.

Main Menu ----------------------------------------------------

Command Description

------- -----------

BOot [PRI|ALT|<path>] Boot from specified path

PAth [PRI|ALT|CON|KEY] [<path>] Display or modify a path

SEArch [DIsplay|IPL] [<path>] Search for boot devices

TOC Soft boot the system

COnfiguration [<command>] Access Configurationmenu/commands

INformation [<command>] Access Information menu/commands

SERvice [<command>] Access Service menu/commands

DIsplay Redisplay the current menu

HElp [<menu>|<command>] Display help for menu or command

RESET Restart the system

-------

Main Menu: Enter command >

1-4

D Class System Memory Upgrade

Memory Installation Procedure

At the Main menu of the Boot Console Handler, type “in me” to display memory

information.

Note the amount of memory listed in the memory information display. After

installing additional memory, you will check this memory information display again

to verify that the system recognizes the newly installed memory

Example Memory Information Display (Models D200/D210/D310)

Main Menu: Enter command > in me

MEMORY INFORMATION

Slot Card Size Amount Enabled

---- --------- --------------

0 16 MB 16 MB

1 16 MB 16 MB

Physical Memory: 32 MB (0x02000000)

Configured Memory: 32 MB (0x02000000)

Main Menu: Enter command >

Example Memory Information Display (all other D2xx and D3xx Models)

Main Menu: Enter command > in me

MEMORY INFORMATION

MEMORY STATUS TABLE

Slot Size(a+b) Status

---- -------- ------

0a/b 128MB Configured

1a/b 32MB Configured

2a/b 32MB Configured

--------

TOTAL 192MB

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Server Handbücher

HP Compaq t1010 Bedienungsanleitung

HP BladeSystem bc2200 - Blade PC Montageanleitung

HP Cluster Platform Express v2010 Bedienungsanleitung

HP ML570 - ProLiant - G2 Gebrauchsanweisung

HP Cluster Platform Hardware Kits v2010 Bedienungsanleitung

HP mt22 Handbuch

HP Blade bc1000 Handbuch

HP D5970A - NetServer - LCII Bedienungsanleitung

HP Integrity rx2600 Bedienungsanleitung

HP t310 G2 Montageanleitung

HP ProLiant DL140 - G2 Server Bedienungsanleitung

HP BL2x220c - ProLiant - G5 Server A Bedienungsanleitung

HP D7171A - NetServer - LPr Bedienungsanleitung

HP t5710 - Thin Client Bedienungsanleitung

HP LX195 - MediaSmart Server - 1 GB RAM Bedienungsanleitung

HP DL760 - ProLiant - G2 Bedienungsanleitung

HP Cluster Platform Introduction v2010 Referenzhandbuch

HP rp8420 Installationsanleitung

HP L1000 - 9000 - 0 MB RAM Betriebsanleitung

HP T5700 - compaq thin client Kurzanleitung

HP PROLIANT BL45P Bedienungsanleitung

HP Integrity rx2800 - i2 Kurzanleitung

HP NetServer LH 3r Bedienungsanleitung

HP ProLiant DL140 - G2 Server Bedienungsanleitung

Beliebte Server Handbücher anderer Marken

Dell

Dell PowerEdge R410 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

MSI

MSI P1-109N-L70 Bedienungsanleitung

Dell

Dell PowerEdge XE9640 Handbuch

Dell

Dell PS4100 Montageanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

NEC

NEC Express5800/T110j Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

Dell

Dell PowerEdge 3YPMN Bedienungsanleitung

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung

Lenovo

Lenovo ThinkSystem SR635 V3 Bedienungsanleitung

Dell

Dell PowerEdge HS5610 Handbuch