HP D7171A - NetServer - LPr Bedienungsanleitung
HP NetServer LXr 8000
Installation Guide
for
Compaq®4000/7000 Racks
HP Part Number 5967-6631
Printed in October 1998
ii
Notice
The information contained in this document is subject to change without notice.
Hewlett-Packard makes no warranty of any kind with regard to this
material, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. Hewlett-Packard shall not
be liable for errors contained herein or for incidental or consequential damages in
connection with the furnishing, performance, or use of this material.
Hewlett-Packard assumes no responsibility for the use or reliability of its software
on equipment that is not furnished by Hewlett-Packard.
This document contains proprietary information that is protected by copyright. All
rights are reserved. No part of this document may be photocopied, reproduced, or
translated to another language without the prior written consent of Hewlett-
Packard Company.
Compaq®is a registered trademark of Compaq Computer Corporation.
APC®is a registered trademark of American Power Conversion Corporation.
Hewlett-Packard Company
Network Server Division
Technical Marketing / MS 45S-LE
10955 Tantau Avenue
Cupertino, CA 95014 USA
© Copyright 1998, Hewlett-Packard Company.
Audience Assumptions
The user guide is for the person who installs, administers, and troubleshoots
network servers. Hewlett-Packard Company assumes you are qualified in the
servicing of computer equipment and trained in recognizing hazards in products
with hazardous energy levels.
iii
Contents
1 Introduction.......................................................................................................1
HP NetServer LXr 8000 – Compaq Rack Precautions ......................................4
2 Overview............................................................................................................5
3 Installation.........................................................................................................7
Preparation.........................................................................................................7
Marking the Installation Holes........................................................................7
Installing the Rack Nuts.................................................................................8
Mounting the Slides........................................................................................9
Installing the NetServer....................................................................................11
4 Warranty and Support....................................................................................19
HP Repair and Telephone Support..................................................................19
Index ....................................................................................................................21
1
1 Introduction
This document describes how to mount an HP NetServer LXr 8000 into a
Compaq®model 4000- or 7000-series rack enclosure. Refer to the HP NetServer
LXr 8000 Installation Guide that came with the NetServer for instructions on
adding accessories to and configuring the NetServer. The HP NetServer LXr 8000
is shown in Figure 1-1.
Figure 1-1. HP NetServer LXr 8000
Chapter 1 Introduction
2
WARNING To prevent the rack from tipping over and causing equipment
damage or bodily injury, be sure that the stabilizing, anti-tip
feature is installed on this rack enclosure (see Figure 1-2).
To prevent the rack from tipping over and causing equipment
damage or bodily injury, do not extend more than one piece of
equipment at a time out of the front of the rack enclosure.
Be sure that the stabilizing, anti-tip feature is installed on the rack enclosure in
which you are installing the HP NetServer LXr 8000. This feature consists of two
"feet" at the front of the base of the enclosure and, if you are installing this
NetServer in a single rack enclosure, two "feet" each on the left and right sides of
the enclosure (see Figure 1-2).
Chapter 1 Introduction
3
Figure 1-2. Single Rack Enclosure With the Anti-Tip
Stabilizing Feature Installed
Chapter 1 Introduction
4
HP NetServer LXr 8000 – Compaq Rack
Precautions
CAUTION If this NetServer is not installed according to these
instructions, damage to the NetServer or accessories may
result. Damage due to improper installation is not covered by
the HP Warranty. Observe the precautions listed in this section
to maintain the NetServer’s reliability.
When the HP NetServer LXr 8000 is installed in a Compaq rack enclosure, certain
requirements must be addressed to assure that the needs of the NetServer are met.
These requirements are:
•The NetServer is installed in a Compaq model 4000- or 7000-series rack
enclosure. This NetServer is not supported in any other non-HP rack
enclosure.
•If you choose to use a door on this enclosure, only a Compaq model
4000- or 7000-series door may be used. No other door may be used. The
enclosure may be used with the door open, closed, or removed.
•Mass storage devices listed in the Tested Products List (located on the
HP NetServer Navigator CD-ROM) are used exclusively in the NetServer.
•Use HP rack accessories. (HP rack accessories are not optimized for
Compaq rack enclosures.)
Compaq rack accessories have not been tested with HP NetServer products,
but components such as monitors, keyboards, switchboxes, and PDUs often
work.
NOTE This NetServer will not work with Compaq PDUs; the power
connectors are incompatible. An appropriate PDU must be ordered.
•Use APC®uninterruptible power supplies (UPS) with HP NetServers.
APC offers mounting kits for Compaq rack enclosures.
This NetServer is not supported in a rack enclosure under circumstances other than
those listed above.
See the "Warranty and Support" section of this document for additional support
considerations.
5
2Overview
The steps required to install the NetServer in the rack are summarized below:
NOTE This is only a summary; detailed instructions are provided on the
following pages.
•Measure and mark the appropriate holes on all four rack columns.
•Install four rack nuts on each of the two front rack columns.
•Insert two rack nuts on each of the two rear rack columns.
•Attach the slides to the columns.
•Extend the slides.
•Remove power supply modules from the NetServer.
•Lift the NetServer onto the slides.
•Secure the NetServer to the slides.
•Remove the lifting handles from the NetServer.
•Install the power supply modules in the NetServer.
•Push the NetServer back into the rack enclosure.
•Secure the NetServer to the two front columns.
Chapter 2 Warranty and Support
6
Terms used in this document are defined in the table below.
Term Definition
Rack nut Single nut designed to clip behind the rack column and
accept a screw through the hole in the column.
Slide Extendible side bracket that is attached to the rack
enclosure columns, onto which the NetServer is mounted.
Consists of a stationary component, and an extendible
member (see Figure 3-3). Allows access to the NetServer
after it is installed in the rack chassis.
Slide mounting flange Mounting flange located at either end of the slide (see
Figure 3-3).
Rack (rack enclosure) The equipment enclosure into which the NetServer will be
installed.
EIA unit Industry standard measurement (1.75 inches / 44.45 mm),
consisting of four vertical mounting holes in a rack column.
Andere Handbücher für D7171A - NetServer - LPr
117
Dieses Handbuch passt für folgende Modelle
6
Inhaltsverzeichnis
Andere HP Server Handbücher
HP
HP DL360 - ProLiant - Photon Bedienungsanleitung
HP
HP t310 G2 Montageanleitung
HP
HP t5740 - Thin Client Gebrauchsanweisung
HP
HP 1850R - ProLiant - 128 MB RAM Bedienungsanleitung
HP
HP NetServer LH 3r Bedienungsanleitung
HP
HP ProLiant DL360p Bedienungsanleitung
HP
HP NetServer E60 Bedienungsanleitung
HP
HP D7171A - NetServer - LPr Bedienungsanleitung
HP
HP ProLiant DL170h G6 Bedienungsanleitung
HP
HP D7171A - NetServer - LPr Bedienungsanleitung
HP
HP t310 Bedienungs- und Wartungshandbuch
HP
HP ProLiant DL360e Bedienungsanleitung
HP
HP DL385 - ProLiant - G5 Bedienungsanleitung
HP
HP StorageWorks FC4-16 Bedienungsanleitung
HP
HP t5335 - Thin Client Bedienungsanleitung
HP
HP ProLiant ML310e Generation 8 (Gen8) Gebrauchsanweisung
HP
HP ConvergedSystem 300 Bedienungsanleitung
HP
HP 2533t - Compaq Mobile Thin Client Handbuch
HP
HP ProLiant ML310 G3 1TB Bedienungsanleitung
HP
HP 656395-006 Handbuch
