HP Enterprise OfficeConnect 1405 v3 Series Bedienungsanleitung

Dieses Handbuch passt für folgende Modelle

2

Inhaltsverzeichnis

Andere HP Schalten Handbücher

HP

HP ProCurve 6120G/XG Bedienungsanleitung

HP

HP ProCurve 2510G Series Bedienungsanleitung

HP

HP StorageWorks 8/24 Bedienungsanleitung

HP

HP HP 830 Series Bedienungsanleitung

HP

HP ProCurve 2510-24 Bedienungsanleitung

HP

HP 316095-B21 - StorageWorks Edge Switch 2/24 Bedienungsanleitung

HP

HP J3128A AdvanceStack 10Base-T Hub-8E Bedienungsanleitung

HP

HP V1905-24 Bedienungsanleitung

HP

HP FlexNetwork 5130 HI series Installationshandbuch

HP

HP Aruba Instant On 1830 Montageanleitung

HP

HP 316095-B21 - StorageWorks Edge Switch 2/24 Bedienungsanleitung

HP

HP 2530-24 Bedienungsanleitung

HP

HP A3100-8 v2 SI Installationshandbuch

HP

HP 6125XLG Bedienungsanleitung

HP

HP 1410 series Bedienungsanleitung

HP

HP ProCurve 6600-48G-4XG Montageanleitung

HP

HP ProCurve 6600-48G Montageanleitung

HP

HP 2615 series Bedienungsanleitung

HP

HP Aruba JL253A Bedienungsanleitung

HP

HP ProCurve 6200yl-24G Montageanleitung

HP

HP StorageWorks 2/8-EL - SAN Switch Bedienungsanleitung

HP

HP ProCurve 5400zl Series Bedienungsanleitung

HP

HP J4111A Bedienungsanleitung

HP

HP aruba 9300-32D Series Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch

HPE OfficeConnect 1405 v3 Switch

Series

Quick Setup Guide

The information in this document is subject to change without notice.

© Copyright 2016 Hewlett Packard Enterprise Development LP

Part number: 5200-0803

Hewlett Packard Enterprise 3000 Hanover Street Palo Alto, CA 94304

5200-0803

1

Product list

Table 1 Product list

Product

code Description Alias RMN

JH407A HPE OfficeConnect

1405 5G v3 Switch HPE 1405 5G

v3 Switch HNGZA-HA

0030

JH408A HPE OfficeConnect

1405 8G v3 Switch HPE 1405 8G

v3 Switch HNGZA-HA

0031

Installation tools and accessories

Figure 1 Installation tools (user supplied)

Figure 2 Installation accessories (provided)

Phillips

screwdriver ESD wrist strap

Wall mounting kit

2

Installing the switch

CAUTION:

Before installation, wear an ESD wrist strap, and make sure the

wrist trap has good skin contact and is reliably grounded.

The procedures for installing the HPE 1405 5G v3 Switch and the

HPE 1405 8G v3 Switch are the same. This section uses the HPE

1405 5G v3 Switch as an example.

Horizontal surface mounting

Place the switch upside up on the workbench.

Wall mounting

The HPE 1405 5G v3 Switch and HPE 1405 8G v3 Switch can be

installed on a wall. The installation hole spacing varies by switch

model, as shown in Table 2.

3

Table 2 Installation hole spacing for each model

Chassis Installation hole spacing

HPE 1405 5G v3 Switch 74 mm (2.91 in)

HPE 1405 8G v3 Switch 102 mm (4.02 in)

To install the switch on a wall:

1. Drill two holes at the same height.

2. Insert one wall anchor into each hole until the anchors are flush

with the wall surface. Drive one screw into each wall anchor,

and then tighten the screws just enough to keep it secure in the

wall anchor.

3. Align the two mounting holes in the switch chassis bottom with

the two screws on the wall and hang the switch.

4

NOTE:

For wall mounting, the network ports can face upwards or

downwards.

Under-table mounting

WARNING!

•Make sure the table is sturdy enough to support the weight

of the switch and attached cables.

•Ensure good ventilation to prevent overheating.

The HPE 1405 5G v3 Switch and HPE 1405 8G v3 Switch can be

installed under a table. The installation hole spacing varies by switch

model, as shown in Table 2.

5

After installation, install the securing screw (included in the kit) to

prevent switch movement.

Connecting the power adapter

WARNING!

To avoid bodily injury, first connect the power adapter to the

switch and then to the power supply system.

Mounting slots

74mm(2.91 in)

Wood table

Third securing screw

6

Connecting network cables

Documentation

To access documentation and support services, go to the Hewlett

Packard Enterprise Support Center website:

www.hpe.com/support/hpesc