Hunter PRO-C Hydrawise Bedienungsanleitung

Table of Contents

HCC - Quick Start Guide

HCC - Connecting AC Power

HCC - Power Module Wiring Diagram

HCC - Valve Wiring

HCC - Installing ICM Station Modules

HCC - Wire Distance to Valves

HCC - Installing Wi-Fi Antenna Extension Kit

Can Two Zones Run Simultaneously with a HCC controller?

HCC - Configure Controller Offline

HCC - Quick Start Guide

HCC - Connecting AC Power

Connecting the controller to primary AC power should be done by a licensed electrician following all

local codes. Install in approved conduit and fittings. The controller can operate with either 120VAC

or 230VAC power. Supply wires must be 14AWG/ 2 mm2 or larger.

IMPORTANT: If you are using the plug-in method, the wiring is exactly the same but you will require

an outlet. The plug referred to as a Pigtail (three wires including neutral, hot, and ground) can be

purchased at most hardware outlets or a Hunter Authorized Dealer [1] (P/N: PIGTAIL).

REMOVE FACEPACK

1. Turn AC power off at the source, and verify that it is off.

2. Disconnect the facepack ribbon cable

3. Remove the facepack.

4. Remove the cover from the junction box.

WIRING

1. Strip about 0.5” (13 mm) of insulation from the end of each AC power wire.

2. Route the wires through the conduit opening inside the junction box.

3. Connect the incoming black power wire (HOT) with the black wire lead from the

transformer.

4. Connect the incoming white wire (NEUTRAL) with the blue lead from the

transformer.

5. Connect the incoming green wire (GROUND) with the green and yellow wire from

the transformer.

6. Cap the unused brown wire coming from the transformer. Replace the cover of

the junction box and screw it into place.

7. Replace cover, turn on the power, and test.

EARTH GROUND CONNECTION (LIGHTNING PROTECTION)

1. Insert the copper wire from earth ground hardware, and tighten the screw in front.

2. Minimum 10 AWG/5mm2 wire to earth ground hardware.

3. Add copper-clad steel ground rods and/or plates sufficient to achieve 10Ω or less resistance at a

minimum 8’/2.5 m away from the controller.

HCC - Power Module Wiring Diagram

Power Module Terminals

1. Green Ground

2. Yellow 24 VAC Transformer

3. Yellow 24 VAC Transformer

4. White Sensor Common

5. Red Rain Sensor

6. Black Flow Meter

7. C Common

8. P/MV Pump or Master Valve

9. REM Remote Control Input

10. White Sensor Common

8. Red Rain Sensor

9. Black Flow Meter

HCC - Valve Wiring

1. Route valve wires between control valve location and controller.

2. At valves, attach a common wire to either solenoid wire of all valves. The most commonly used

color for the common wire is white. Attach a separate control wire to the remaining wire of each

valve. All wire splice connections should be done using waterproof connectors.

3. Open hinged faceplate on the controller to access the terminal strip area.

4. Route valve wires through the conduit and attach conduit to the controller at the large conduit

opening on the right side of the bottom of the cabinet. The conduit opening has a triple knockout

to accommodate 1", 1¼", or 1½" (25, 32, or 40 mm) conduit. Each section can be easily

removed using a knife.

5. Strip ½" (13 mm) of insulation from ends of all wires. Secure valve common wire to C (Common)

terminal on any of the valve modules or power module. Then attach all individual valve control

wires to appropriate station terminals.

HCC CONTROLLER

HCC - Installing ICM Station Modules

The base model of HCC is supplied with an ICM-800 station output module. The capacity of the

controller is increased when new station modules are installed and recognized.

Standard ICM station modules are available in 4, 8, and 22 station sizes (ICM-400, ICM-800, ICM-

2200). These may be added at any time after initial installation.

Note: The ICM-2200 (22 Station module) must always be installed in the last two module slots to

make it compatible.

Model Max Station Count Total ICM 800 Modules Total ICM 2200 Modules

HCC-800-PL 38 Qty:2 - ICM-800 Qty:1 - ICM-2200

HCC-800-M 54 Qty:4 - ICM-800 Qty:1 - ICM-2200

HCC-800-SS 54 Qty:4 - ICM-800 Qty:1 - ICM-2200

HCC-800-PP 54 Qty:4 - ICM-800 Qty:1 - ICM-2200

STEP 1 STEP 2 STEP 3

Open the controller inner panel, and

choose the next available open slot in

the controller. Slots are numbered,

down the first column and up the

second.

Flip the blue locking lever into the

vertical unlocked position.

Tip the two tabs on one end of the

module into the mating holes in one end

of the slot, and tip the module firmly into

place.

STEP 4 STEP 5 STEP 6

Flip the locking lever into the horizontal

locked position.

Press the Reset button on the back of

the controller control panel. This is

required for the controller to recognize

the new module.

Connect field and common wiring as

needed and test.

HCC - Wire Distance to Valves

Below is a chart indicating the maximum wire run between the controller and the Hunter AC solenoid

valves.

Valve Wire Sizing (Feet)

Ground Control Wire

18 16 14 12 10 8 6

18 850 1040 1210 1350 1460 1540 1590

16 1040 1340 1650 1920 2150 2330 2440

14 1210 1650 2150 2630 3080 3450 3700

12 1350 1920 2630 3390 4170 4880 5400

10 1460 2150 3080 4170 5400 6670 7650

81540 2330 3450 4880 6670 8700 10530

61590 2440 3700 54000 7690 10530 13330

Notes:

Maximum one-way distance in feet between controller and valve heavy-duty solenoid: 24 VAC, 350

mA inrush current, 190 mA holding current, 60 Hz; 370 mA inrush current, 210 mA holding current,

50 Hz

Valve Wire Sizing (Metric)

Ground Control Wire

0.5 1 1.5 2.5 4 6

0.5 140 190 210 235 250 260

1.0 190 290 335 415 465 495

1.5 208 335 397 515 595 647

2.5 235 415 515 730 900 1030

4.0 250 465 595 900 1175 1405

6.0 260 495 647 1030 1405 1745

Notes:

Maximum one-way distance in meters between controller and valve Heavy-duty solenoid: 24 VAC,

350 mA inrush current, 190 mA holding current, 60 Hz; 370 mA inrush current, 210 mA holding

current, 50 Hz

Andere Handbücher für PRO-C Hydrawise

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hunter Bewässerungssystem Handbücher

Hunter

Hunter Hydrawise Ready Bedienungsanleitung

Hunter

Hunter EC-401-A Betriebsanleitung

Hunter

Hunter ST Series Bedienungsanleitung

Hunter

Hunter I-80 Bedienungsanleitung

Hunter

Hunter Sprinkler System Leitfaden

Hunter

Hunter SRC Plus 600i Bedienungsanleitung

Hunter

Hunter Hydrawire Bedienungsanleitung

Hunter

Hunter Institutional Series Bedienungsanleitung

Hunter

Hunter Professional Series Bedienungsanleitung

Hunter

Hunter Professional Series Leitfaden

Hunter

Hunter Institutional Series Bedienungsanleitung

Hunter

Hunter PGP Ultra Series Bedienungsanleitung

Hunter

Hunter Professional Series Bedienungsanleitung

Hunter

Hunter Institutional Series I-35 Bedienungsanleitung

Hunter

Hunter I-25 Bedienungsanleitung

Hunter

Hunter PGP Series Bedienungsanleitung

Hunter

Hunter I-80 Bedienungsanleitung

Hunter

Hunter Professional Series PGP Bedienungsanleitung

Hunter

Hunter Professional PGP Ultra Series Bedienungsanleitung

Hunter

Hunter Institutional Series Bedienungsanleitung

Hunter

Hunter Professional PGP Ultra Series Bedienungsanleitung

Hunter

Hunter Institutional Series I-90 Bedienungsanleitung

Hunter

Hunter Professional PGP Bedienungsanleitung

Hunter

Hunter I-25 Ultra Bedienungsanleitung

Beliebte Bewässerungssystem Handbücher anderer Marken

Cellfast

Cellfast 52-305 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star Galaxy SGQR Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL A Bedienungsanleitung

Oral Care Technologies

Oral Care Technologies Hydro Floss Bedienungsanleitung

Reliable

Reliable F1-300 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem F892 Bedienungsanleitung

Netafim

Netafim NETBEAT Bedienungsanleitung

Irrigation-Mart

Irrigation-Mart KIT-GK100-RV-B Bedienungsanleitung

Tyco

Tyco CC3 Bedienungsanleitung

Reliable

Reliable F4FR Bedienungsanleitung

OpenSprinkler

OpenSprinkler OSPi Bedienungsanleitung

EINHELL

EINHELL GE-WW 5537 E Bedienungsanleitung

Valley

Valley Bender160 Bedienungsanleitung

Reliable

Reliable F1FR42 Series Bedienungsanleitung

Reliable

Reliable F1FR-300 Bedienungsanleitung

Toro

Toro 730 Series Kurzanleitung

Eden

Eden 97063-EDAMZ Bedienungsanleitung

Tyco

Tyco TY-L Series Bedienungsanleitung