Hunter Professional Series Leitfaden

Fig. 1

ARC ADJUSTMENTS

Adjustable heads are preset to approximately 180°.

Sprinklers may be adjusted with water on or off. It is

recommended that initial adjustment be made

before installation.

1. Using the palm of your hand, rotate the

nozzle turret counterclockwise to the left stop

to complete any interrupted rotation cycle

(Fig. 1).

2. Rotate the nozzle turret clockwise to the right

stop. This is the fixed side of the arc. The

nozzle turret must be held in this position for

all arc adjustments.

To Increase the Arc:

1. Insert the key end of the Hunter wrench into

the adjustment socket (Figs. 2 & 3).

Insert the key end of the Hunter wrench

into the lifting socket of the sprinkler. Pull the

riser up to gain access to the nozzle socket.

Using the Hunter wrench, loosen the

nozzle/range-adjustment screw. If a nozzle

is already installed in the sprinkler, it can be

removed by briefly turning on the water, or

by pulling on one of the nozzle “ears” with

needle-nose pliers.

Slip the desired nozzle into the nozzle

socket. Note that the socket is angled up

25°. Also note that the “ears” should be

located at the top (Fig. 4). Tighten the

nozzle/range-adjustment screw.

NOZZLE INSTALLATIONRADIUS ADJUSTMENT

Insert the hex end of the Hunter wrench into

the nozzle/range-adjustment screw (Figs. 2 &

3). Turn the screw clockwise (into the stream

of water) to decrease the radius, or

counterclockwise to increase the radius.

PRECIPITATION RATE ADJUSTMENT

For excessively wet or dry areas, the

precipitation rate can be adjusted—simply

replace the existing nozzle with a larger one to

increase, or a smaller one to decrease, the rate

of precipitation.

Note: It is not necessary to disassemble

the sprinkler to make adjustments.

Professional Series

PGP, PGS, PGH

Gear-Driven Sprinklers

2. While holding the nozzle turret at the right stop,

turn the wrench clockwise. Each full turn of the

wrench increases the arc 90°.

3. Adjust to any arc between 40°and 360°.

4. Wrench will stop turning or there will be a

ratcheting noise, when the maximum arc (360°)

is reached.

To Decrease the Arc:

1. Insert the key end of the Hunter wrench into the

adjustment socket (Figs. 2 & 3).

2. While holding the nozzle turret at the right stop,

turn the wrench counterclockwise. Each full

turn of the wrench decreases the arc 90°.

3. Adjust to any arc between 40°and 360°.

4. Wrench will stop turning, or there will be a

ratcheting noise, when the minimum arc (40°)

is reached.

Fig. 4

Fig. 2

Fig. 3

Nozzle/Range-

Adjustment

Screw

Lifting

Socket

Adjustment

Socket

Nozzle

Turret Nozzle

Socket

ID Button

U.S.A.: 1940 Diamond Street • San Marcos, California 92069 • TEL: (1) 760-744-5240 • FAX: (1) 760-744-7461 • www.HunterIndustries.com P/N 700026

Australia: 8 The Parade West • Kent Town, S. Australia 5067 • TEL: (61) 8-8363-3599 • FAX: (61) 8-8363-3687 INT-026.PDF

Europe: Europarc, Bât. B14 • 1330, rue G. de la Lauzières • 13855 Aix-en-Provence, France • TEL: (33) 4-42-93-03-68 • FAX: (33) 4-42-93-03-84 7/01

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,8

3,4

4,1

4,8

2,8

3,4

4,1

4,8

2,8

3,4

4,1

4,8

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

275

344

413

482

275

344

413

482

275

344

413

482

0,11

0,14

0,16

0,18

0,16

0,18

0,20

0,23

0,20

0,23

0,27

0,30

0,27

0,32

0,36

0,41

0,36

0,41

0,45

0,50

0,45

0,55

0,61

0,66

0,59

0,68

0,77

0,84

0,73

0,84

0,95

1,04

0,95

1,11

1,25

1,36

1,54

1,73

1,86

1,82

2,02

2,23

2,39

2,59

2,77

3,00

3,27

1,9

2,3

2,7

3,0

2,6

3,0

3,4

3,8

3,4

3,8

4,5

4,9

4,5

5,3

6,1

6,8

6,1

6,8

7,6

8,3

7,6

9,1

10,2

11,0

9,8

11,4

12,9

14,0

12,1

14,0

15,9

17,4

15,9

18,5

20,8

22,7

25,7

28,8

31,0

30,3

33,7

37,1

39,7

43,2

46,2

50,0

54,5

8,5

8,8

9,1

8,8

9,1

9,4

9,1

9,4

9,8

10,1

10,4

11,0

11,6

11,0

11,6

12,2

11,0

12,2

12,8

11,3

12,2

13,1

13,4

11,6

13,1

14,0

14,3

13,7

14,6

14,9

15,5

14,0

14,6

15,2

15,5

14,0

14,6

15,2

15,9

Nozzle

/hr.

kPaBars l/min

Radius

Pressure

Flow

Performance Data

Matched Precipitation

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

206

275

344

413

275

344

413

482

0,32

0,39

0,41

0,45

0,36

0,43

0,48

0,52

0,48

0,57

0,64

0,68

0,64

0,70

0,80

0,86

0,77

0,89

1,00

1,07

0,98

1,14

1,27

1,39

1,48

1,66

1,82

1,95

5,3

6,4

6,8

7,6

6,1

7,2

7,9

8,7

7,9

9,5

10,6

11,4

10,6

11,7

13,2

14,4

12,9

14,8

16,7

17,8

16,3

18,9

21,2

23,1

24,6

27,6

30,3

32,6

6,7

7,3

7,9

8,5

7,6

8,2

8,5

9,1

8,2

9,1

10,1

10,7

8,8

9,8

10,7

11,3

9,4

10,4

11,3

11,6

10,1

11,3

12,2

12,8

11,6

12,2

12,8

13,4

Blank nozzle plug for turning off

selected sprinklers during repairs,

maintenance, etc.

m3/hr.

kPaBars l/min

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,1

2,8

3,4

4,1

2,8

3,4

4,1

4,8

/hr. l/min

Flow m

/hr. l/min

Flow

90°

Nozzle #

180°

Nozzle # 360°

Nozzle #

/hr. l/min

Flow

PGS, PGP, PGH Performance Chart PGS, PGP, PGH Low Angle Chart

Nozzle

Radius

Pressure Flow

Square

Spacing

When the spacing/arc/nozzle pressure combinations are spaced as indicated, the precipitation rate

will be approximately 10 mm/hr. at 3,4 bars/344 kPa.

0 mm/hr at 3,4 bars/344 kPa

0,16

0,20

0,27

0,36

0,45

2,7

3,4

4,5

6,1

7,6

7,6 m

9,1 m

10,7 m

12,2 m

13,7 m

0,77

0,95

1,25

1,73

2,23

12,9

15,9

20,8

28,8

37,1

0,36

0,45

0,61

0,77

0,95

6,1

7,6

10,2

12,9

15,9

Dieses Handbuch passt für folgende Modelle

Andere Hunter Bewässerungssystem Handbücher

Hunter

Hunter Professional Series PGP Bedienungsanleitung

Hunter

Hunter Institutional Series I-35 Bedienungsanleitung

Hunter

Hunter Hydrawire Bedienungsanleitung

Hunter

Hunter I-25 Bedienungsanleitung

Hunter

Hunter INSTITUTIONAL SERIES I-90 Bedienungsanleitung

Hunter

Hunter I-20 ULTRA Bedienungsanleitung

Hunter

Hunter Hydrawise HC-1200M Bedienungsanleitung

Hunter

Hunter Institutional Series Bedienungsanleitung

Hunter

Hunter G835 Bedienungsanleitung

Hunter

Hunter I-25 Ultra Bedienungsanleitung

Hunter

Hunter Professional PGP Bedienungsanleitung

Hunter

Hunter I-80 Bedienungsanleitung

Hunter

Hunter Institutional I-20 Bedienungsanleitung

Hunter

Hunter TTS-800 Series Bedienungsanleitung

Hunter

Hunter Hydrawise Ready Bedienungsanleitung

Hunter

Hunter Professional PGP Ultra Series Bedienungsanleitung

Hunter

Hunter Institutional Series Bedienungsanleitung

Hunter

Hunter PGP Ultra Series Bedienungsanleitung

Hunter

Hunter PGP Series Bedienungsanleitung

Hunter

Hunter Professional PGP Ultra Series Bedienungsanleitung

Hunter

Hunter XC Hybrid Bedienungsanleitung

Hunter

Hunter I-80 Bedienungsanleitung

Hunter

Hunter i-core IC-600PL Bedienungsanleitung

Hunter

Hunter Institutional Series Bedienungsanleitung

Beliebte Bewässerungssystem Handbücher anderer Marken

Cellfast

Cellfast 52-305 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Star Galaxy SGQR Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product CENTRAL A Bedienungsanleitung

Oral Care Technologies

Oral Care Technologies Hydro Floss Bedienungsanleitung

Reliable

Reliable F1-300 Bedienungsanleitung

Tyco Fire Product

Tyco Fire Product Gem F892 Bedienungsanleitung

Netafim

Netafim NETBEAT Bedienungsanleitung

Irrigation-Mart

Irrigation-Mart KIT-GK100-RV-B Bedienungsanleitung

Tyco

Tyco CC3 Bedienungsanleitung

Reliable

Reliable F4FR Bedienungsanleitung

OpenSprinkler

OpenSprinkler OSPi Bedienungsanleitung

EINHELL

EINHELL GE-WW 5537 E Bedienungsanleitung

Valley

Valley Bender160 Bedienungsanleitung

Reliable

Reliable F1FR42 Series Bedienungsanleitung

Reliable

Reliable F1FR-300 Bedienungsanleitung

Toro

Toro 730 Series Kurzanleitung

Eden

Eden 97063-EDAMZ Bedienungsanleitung

Tyco

Tyco TY-L Series Bedienungsanleitung