Husqvarna Viking Viking E20 Bedienungsanleitung
E20
USER’S GUIDE
This houshold sewing machine is designed to comply with IEC/EN 60335-2-28 and UL1594
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be followed,
including the following:
Read all instructions before using this household sewing machine.
DANGER -To reduce the risk of electric shock:
• A sewing machine should never be left unattended when plugged in. Always unplug this
sewing machine from the electric outlet immediately after using and before cleaning.
• Always unplug before relamping. Replace bulb with same type rated 10 Watt (110-120V),
15 Watt (220-240V).
WARNING - To reduce the risk of burns, fire,
electric shock, or injury to persons:
• Do not allow to be used as a toy. Close attention is necessary when this sewing machine is
used by or near children and infirm persons.
• Use this sewing machine only for its intended use as described in this manual. Use only
attachments recommended by the manufacturer as contained in this manual.
• Never operate this sewing machine if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. Return the sewing
machine to the nearest authorized dealer or service center for examination, repair,
electrical or mechanical adjustment.
• Never operate the sewing machine with any air openings blocked. Keep ventilation
openings of the sewing machine and foot controller free from the accumulation of lint, dust,
and loose cloth.
• Keep fingers away from all moving parts. Special care is required around the sewing
machine needle.
• Always use the proper needle plate. The wrong plate can cause the needle to break.
• Do not use bent needles.
• Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
• Switch the sewing machine off (“0”) when making any adjustment in the needle area, such
as threading needle, changing needle, threading bobbin, or changing presser foot, etc.
• Always unplug sewing machine from the electrical outlet when removing covers,
lubricating, or when making any other user servicing adjustments mentioned in the
instruction manual.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being used or where oxygen is being
administrated.
• To disconnect, turn all controls to the off (“0”) position, then remove plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
SAVE THESE INSTRUCTIONS
3
CONTENTS
PRINCIPAL PARTS............................................................................................................. 4
ACCESSORIES .................................................................................................................. 6
SLIDE ON THE SNAP-IN ACCESSORY BOX.................................................................... 7
CONNECTING THE MACHINE TO POWER SOURCE...................................................... 8
CHANGING THE BULB....................................................................................................... 9
TWO-STEP PRESSER FOOT LEVER.............................................................................. 10
ADJUSTING THE PRESSER FOOT PRESSURE............................................................ 10
PRESSER FOOT SHANK..................................................................................................11
WINDING THE BOBBIN.................................................................................................... 12
INSERTING THE BOBBIN................................................................................................ 13
CHANGING THE NEEDLE (SYSTEM 130/705H)............................................................ 14
THREADING THE UPPER THREAD................................................................................ 15
BRINGING UP THE BOBBIN THREAD ............................................................................ 16
THREAD TENSION........................................................................................................... 17
RAISE OR LOWER THE FEED DOG............................................................................... 18
REVERSE SEWING.......................................................................................................... 19
CHANGING SEWING DIRECTIONS ................................................................................ 19
REMOVING THE FABRIC................................................................................................. 19
CUTTING THE THREAD................................................................................................... 19
HOW TO CHOOSE YOUR PATTERN............................................................................... 20
MATCHING NEEDLE / FABRIC / THREAD ...................................................................... 21
ZIG ZAG SEWING............................................................................................................. 22
STRAIGHT STITCHINGAND NEEDLE POSITION.......................................................... 23
OVERLOCK STITCHES.................................................................................................... 24
BLIND HEM....................................................................................................................... 25
ONE STEP BUTTONHOLES ........................................................................................... 26
LEFTAND RIGHT SIDE BALANCE FOR BUTTONHOLE................................................ 27
ZIPPERS AND PIPING ..................................................................................................... 28
3-STEP ZIG-ZAG .............................................................................................................. 29
STRETCH STITCH SELECTION...................................................................................... 30
FREE MOTION DARNING................................................................................................ 31
DARNING.......................................................................................................................... 32
QUILTING.......................................................................................................................... 33
MAINTENANCE ................................................................................................................ 34
TROUBLESHOOTING GUIDE.......................................................................................... 35
4
PRINCIPAL PARTS
1. Thread tension dial
2. Presser foot pressure
3. Thread take-up lever
4. Thread cutter
5. Presser foot
6. Needle plate
7. Accessory box
8. Bobbin stopper
9. Stitch length dial
10. Stitch width dial
11. Stitch display
12. Reverse sewing lever
13. Feed dog adjustment lever
14. One step buttonhole lever
5
15. Handle
16. Bobbin winder
17. Spool pin
18. Handwheel
19. Pattern selector dial
20. Power switch
21. Main plug socket
22. Bobbin thread guide
23. Upper thread guide
24. Presser foot lever
25. Buttonhole stitch balance adjustment slot
6
1234
56 7
89 10
11 12 13 14
ACCESSORIES
1. All purpose foot
2. Zipper foot
3. Satin stitch foot
4. Buttonhole foot
5. Quilting foot
6. Free-Motion/Darning foot
7. Blind hem foot
8. L-screwdriver
9. Seam ripper/ brush
10. Oil bottle
11. Pack of needles
12. Bobbins
13. Seam guide
14. Spool pin felt (2x)
7
SLIDE ON THE SNAP-IN ACCESSORY BOX
Hold the snap-in accessory box horizontal, and push it
in the direction of the arrow. (1)
To open, lift up at the point of the arrow. (2)
8
CONNECTING THE MACHINE TO POWER SOURCE
- Connect the machine to a power source as illustrated (1/2).
- The power switch is located above the socket. Your machine will
not operate unless this switch is on “ I “. (1)
- Sewing light turns on automatically when the main switch is on “I“.
- To start the machine, press on the foot control (3). The speed of
the machine is regulated by the amount of pressure put on the foot
control.
Caution: Always make sure that the machine is unplugged from
power source and the main switch is on “O”. when the machine is
not in use and before inserting or removing parts.
Attention: Consult a qualified electrician if in doubt as to connect
machine to power source. Unplug power cord when machine is not
in use.
The appliance must be used with the foot controller:
- For USA and Canada, 110-120V: 4C-316B
- For Australia, 240V: 4C-326G
- For Europe, 220-240V: 4C-316C or 4C-326C
For the USA and Canada
This appliance has a polarized plug (one blade wider than the
other), to reduce the risk of electrical shock; this plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not modify the plug in any way.
9
CHANGING THE BULB
Caution: Make sure to disconnect the electrical
supply plug from wall outlet before changing light
bulb.
Replace bulb with same type rated:
10 watts (110-120V)
15 watts (220-240V)
- Loosen screw (A) as illustrated. (1)
- Remove the cover (B).
- Unscrew the bulb and put in a new one (C).
(2)
- Replace the cover and tighten screw.
10
TWO-STEP PRESSER FOOT LEVER
ADJUSTING THE PRESSER FOOT PRESSURE
When sewing several layers or thick fabrics, the
presser foot can be raised a second stage for easy
positioning of the work. (A)
The presser foot pressure of the machine has been
pre-set and usually requires no readjustment for most
fabrics (light-or-heavy weight).
However, if you need to adjust the presser foot
pressure, turn the presser adjusting screw with a coin.
For sewing very thin fabric, loosen the pressure by
turning the screw counter clockwise for less pressure
on the fabric, and for heavy fabric, tighten by turning it
clockwise for more pressure on the fabric.
Andere Handbücher für Viking E20
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Husqvarna Viking Nähmaschine Handbücher
Husqvarna Viking
Husqvarna Viking Designer II Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Scandinavia 400 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking ER10 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking 160 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking H Class E10 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking SAPPHIRE 9650Q Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Platinum 995E Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Designer SE Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Designer I Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Huskylock 901 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Sarah Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Huskylock s21 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Huskylock 936 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Viking Topaz 40 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Prelude 350 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking H Class E10 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Viking H Class 100Q Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Huskystar EM10 Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Viking Angelica Bedienungsanleitung
Husqvarna Viking
Husqvarna Viking Eden Rose 250C Bedienungsanleitung
