iVAC Pro Remote User Guide P3 and 4
General Description.
The ‘iVAC Pro Remote’ has been added to the ‘iVAC Pro
System’ to operate in conjunction with an ‘iVAC Pro Switch’
and enable a dust collector to be controlled remotely, by
means of a manual operation.
The ‘iVAC Pro Remote’ can be programmed by means of
an internal DIP program switch to operate on one of four
System Addresses and one of eight Tool Addresses, similar
to an ‘iVAC Pro Tool’. (Refer to iVAC Pro System User Guide.)
The ‘iVAC Pro Remote’ is intended for indoor use in dry
locations only.
When the ON button is pressed, a radio frequency transmission
is sent to the ‘iVAC Pro Switch’ instructing it to turn on and
provide power to the dust collector. When the OFF button
is pressed, the power will be removed from the dust collector.
The Turn On Delay and Turn Off Time for the dust collector
will be as programmed in the ‘iVAC Pro Switch’.
To ensure consistent operation, it is recommended that the
buttons are operated for one to two seconds.
The Remote is housed in a plastic case
90mm x 70mm x 25mm.
An easily attached belt clip is also provided.
The rear cover is attached by three screws. Removing the
cover allows access to the batteries and the DIP program switch.
This allows the batteries to be changed and also to program
address functions of the ‘iVAC Pro Remote’ by means of
the six position DIP program switch.
There are two address functions, System Address and Tool
Address.
iVAC Pro Remote User Guide P5 and 6
System Address
A System consists of an’ iVAC Pro Switch’ and from one to
eight iVAC Pro Tools or iVAC Pro Remotes. There can be
any mix of Tools or Remotes.
By means of positions S1 and S2 of the Program Switch,
the Remote can be assigned to work on one of four System
Addresses, A, B, C or D.
The System Address enables up to four Systems to operate
independently while within communication range of each
other.
System Address
* factory setting S1 S2
* A Off Off
B On Off
C Off On
D On On
