IBASE Technology MB995 Bedienungsanleitung

MB995

8th Gen. Intel®Core™ i7/i5/i3

/ Xeon®E

ATX Motherboard

User’s Manual

Version 1.0

(July 2018)

MB995 User’s Manual

No part of this publication may be reproduced, copied, stored in a retrieval

system, translated into any language or transmitted in any form or by any

means, electronic, mechanical, photocopying, or otherwise, without the

prior written consent of IBASE Technology, Inc. (hereinafter referred to as

“IBASE”).

Disclaimer

IBASE reserves the right to make changes and improvements to the

products described in this document without prior notice. Every effort has

been made to ensure the information in the document is correct; however,

IBASE does not guarantee this document is error-free.

IBASE assumes no liability for incidental or consequential damages arising

from misapplication or inability to use the product or the information

contained herein, nor for any infringements of rights of third parties, which

may result from its use.

Trademarks

All the trademarks, registrations and brands mentioned herein are used for

identification purposes only and may be trademarks and/or registered

trademarks of their respective owners.

MB995 User’s Manual

iii

Compliance

In a domestic environment, this product may cause radio interference in

which case users may be required to take adequate measures.

This product has been tested and found to comply with the limits for a Class

B device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

manufacturer’s instructions, may cause harmful interference to radio

communications.

WEEE

This product must not be disposed of as normal

household waste, in accordance with the EU directive of

for waste electrical and electronic equipment (WEEE -

2012/19/EU). Instead, it should be disposed of by

returning it to a municipal recycling collection point. Check

local regulations for disposal of electronic products.

Green IBASE

This product is compliant with the current RoHS

restrictions and prohibits use of the following substances

in concentrations exceeding 0.1% by weight (1000 ppm)

except for cadmium, limited to 0.01% by weight (100

ppm).

•Lead (Pb)

•Mercury (Hg)

•Cadmium (Cd)

•Hexavalent chromium (Cr6+)

•Polybrominated biphenyls (PBB)

•Polybrominated diphenyl ether (PBDE)

MB995 User’s Manual

Important Safety Information

Carefully read the precautions before using the board.

Environmental conditions:

•Use this product in environments with ambient temperatures between

0˚C and 60˚C.

•Do not leave this product in an environment where the storage

temperature may be below -20°C or above 80°C. To prevent from

damages, the product must be used in a controlled environment.

Care for your IBASE products:

•Before cleaning the PCB, unplug all cables and remove the battery.

•Clean the PCB with a circuit board cleaner, degreaser, or use cotton

swabs and alcohol.

•Vacuum the dust with a computer vacuum cleaner to prevent the fan

from being clogged.

WARNING

Attention during use:

•Do not use this product near water.

•Do not spill water or any other liquids on this product.

•Do not place heavy objects on the top of this product.

Anti-static precautions

•Wear an anti-static wrist strap to avoid electrostatic discharge.

•Place the PCB on an anti-static kit or mat.

•Hold the edges of PCB when handling.

•Touch the edges of non-metallic components of the product instead of

the surface of the PCB.

•Ground yourself by touching a grounded conductor or a grounded bit

of metal frequently to discharge any static.

CAUTION

Replace only with the same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer’s

instructions or recycle them at a local recycling facility or battery collection

point.

MB995 User’s Manual

Warranty Policy

•IBASE standard products:

24-month (2-year) warranty from the date of shipment. If the date of

shipment cannot be ascertained, the product serial numbers can be

used to determine the approximate shipping date.

•3rd-party parts:

12-month (1-year) warranty from delivery for the 3rd-party parts that

are not manufactured by IBASE, such as CPU, CPU cooler, memory,

storage devices, power adapter, panel and touchscreen.

＊PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,

IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR SHALL

BE TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL

BE BILLED FOR REPAIR AND SHIPPING CHARGES.

Technical Support & Services

1. Visit the IBASE website at www.ibase.com.tw to find the latest

information about the product.

2. If you need any further assistance from your distributor or sales

representative concerning problems that you may have encountered,

please prepare the following information:

•Product model name

•Product serial number

•Detailed description of the problem

•The error messages in text or in screenshots if there is any

•The arrangement of the peripherals

•Software in use (such as OS and application software, including

the version numbers)

3. If repair service is required, you can download the RMA form at

http://www.ibase.com.tw/english/Supports/RMAService/.

Fill out the form and contact your distributor or sales representative.

MB995 User’s Manual

Table of Contents

Compliance.....................................................................................iii

Important Safety Information........................................................iv

Warranty Policy...............................................................................v

Technical Support & Services .......................................................v

Chapter 1 General Information.............................................1

1.1 Introduction .........................................................................................2

1.2 Features..............................................................................................2

1.3 Packing List.........................................................................................3

1.4 Optional Accessories...........................................................................3

1.5 Specifications......................................................................................4

1.6 Block Diagram.....................................................................................6

1.7 Overview.............................................................................................7

1.8 Dimensions .........................................................................................9

Chapter 2 HardwareConfiguration........................................11

2.1 Installations.......................................................................................12

2.1.1 Installing the Memory...........................................................12

2.2 Setting the Jumpers...........................................................................13

2.2.1 How to Set Jumpers.............................................................13

2.3 Jumper & Connector Locations on MB995.........................................14

2.4 Jumpers Quick Reference.................................................................15

2.4.1 Clearing CMOS Data (JP6) .................................................15

2.4.2 PCIe (x16) Bifurcation Selection (JP2 & JP3) ......................16

2.5 Connectors Quick Reference.............................................................17

2.5.1 COM1 & COM2 RS-232/422/485 Ports (CN3).....................18

2.5.2 Front Panel Audio Connector (J1) .......................................19

2.5.3 Digital I/O Connector (J2)....................................................20

2.5.4 COM3, COM4, COM5, COM6RS-232 Ports (J8, J7, J5, J3)....21

2.5.5 PS/2 Keyboard & Mouse Ports (J10)...................................22

2.5.6 USB 2.0 Ports (J15) ............................................................22

2.5.7 USB 3.1 Ports (J16) ............................................................23

2.5.8 Front Panel Settings Connector (J18)..................................24

2.5.9 S3 Status Connector (J22) ..................................................25

MB995 User’s Manual

vii

2.5.10 ATX Power Connector (J23)................................................26

2.5.11 ATX 12V Power Connector (ATX_12V_2X1) .......................27

2.5.12 CPU Fan Power Connector (CPU_FAN1)............................28

2.5.13 System Fan Power Connector (SYS_FAN1, SYS_FAN2)....29

Chapter 3 Drivers Installation.............................................31

3.1 Introduction........................................................................................32

3.2 Intel®Chipset Software Installation Utility...........................................32

3.3 HD Graphics Driver Installation..........................................................33

3.4 HD Audio Driver Installation...............................................................35

3.5 LAN Driver Installation .......................................................................36

3.6 Intel®Management Engine Drivers Installation...................................37

Chapter 4 BIOS Setup..........................................................39

4.1 Introduction........................................................................................40

4.2 BIOS Setup........................................................................................40

4.3 Main Settings.....................................................................................41

4.4 Advanced Settings.............................................................................42

4.4.1 Connectivity Configuration....................................................43

4.4.2 CPU Configuration................................................................44

4.4.3 Power & Performance...........................................................45

4.4.4 PCH-FW Configuration.........................................................45

4.4.5 Trusted Computing...............................................................46

4.4.6 ACPI Settings.......................................................................47

4.4.7 iSmart Controller...................................................................48

4.4.8 F81966 Super IO Configuration ............................................49

4.4.9 Hardware Monitor.................................................................50

4.4.10 AMI Graphic Output Protocol Policy......................................50

4.4.11 USB Configuration................................................................51

4.4.12 Network Stack Configuration.................................................53

4.4.13 CSM Configuration ...............................................................53

4.4.14 NVMe Configuration .............................................................53

4.5 Chipset Settings.................................................................................54

4.5.1 System Agent (SA) Configuration .........................................54

4.5.2 PCH-IO Configuration...........................................................56

4.6 Security Settings................................................................................57

4.7 Boot Settings .....................................................................................58

4.8 Save & Exit Settings ..........................................................................59

Appendix........................................................................................61

viii

MB995 User’s Manual

A. I/O Port Address Map........................................................................62

B. Interrupt Request Lines (IRQ)............................................................65

C. Watchdog Timer Configuration..........................................................67

D. On-Board Connector Types...............................................................71

Chapter 1

General Information

The information provided in this chapter includes:

•Features

•Packing List

•Specifications

•Block Diagram

•Board Overview

•Board Dimensions

MB995 User’s Manual

1.1 Introduction

MB995 is an ATX motherboard based on the Intel®8th Gen. Processor that

features four DDR memory sockets and supports up to 64 GB and high-

performance graphics processing to create media-rich content and brilliant

HD entertainment with DVI-D, HDMI (2.0a) and DisplayPort display

interface. Other advanced and innovative features on board include

watchdog timer, Digital I/O, iAMT (11.6), TPM (2.0), vPro, and IBASE

iSMART green technology.

Photo of MB995

1.2 Features

•8th Gen. Intel®Xeon®E / Core™i7/i5/i3 processor

•4 x DDR4 UDIMM, expandable up to 64 GB, ECC supported per CPU

SKUs

•Intel®processor integrated graphics device for DVI-D, HDMI (2.0a)

and DisplayPort

•2 x GbE LAN, 9 x USB 3.1, 6 x COM, 4 or 6 x SATA III

•1 x PCIe (x16), 1 x PCIe (x4), 1 x PCIe (x1), 3 x PCI, 1 x Mini-PCIe,

2 x M.2 (M2280 & E2230)

•Configurable watchdog timer and digital I/O

•iAMT (11.6), TPM (2.0), vPro and iSMART

Note: vPro is supported by Intel®Xeon®E / Core™i7/i5 processors.

Inhaltsverzeichnis

Andere IBASE Technology Hauptplatine Handbücher

IBASE Technology

IBASE Technology MB820 Bedienungsanleitung

IBASE Technology

IBASE Technology MI991AF Bedienungsanleitung

IBASE Technology

IBASE Technology IBR115 Bedienungsanleitung

IBASE Technology

IBASE Technology AFW-3000 Bedienungsanleitung

IBASE Technology

IBASE Technology MB990 Bedienungsanleitung

IBASE Technology

IBASE Technology MBN806 Bedienungsanleitung

IBASE Technology

IBASE Technology IB905 Bedienungsanleitung

IBASE Technology

IBASE Technology MI900 Bedienungsanleitung

IBASE Technology

IBASE Technology MI957 Bedienungsanleitung

IBASE Technology

IBASE Technology MI945X Bedienungsanleitung

IBASE Technology

IBASE Technology MB870 Bedienungsanleitung

IBASE Technology

IBASE Technology MI959 Bedienungsanleitung

IBASE Technology

IBASE Technology IB981AF-C226 Bedienungsanleitung

IBASE Technology

IBASE Technology IB704 Bedienungsanleitung

IBASE Technology

IBASE Technology IB100 Bedienungsanleitung

IBASE Technology

IBASE Technology MB930-R Bedienungsanleitung

IBASE Technology

IBASE Technology MI970VF Bedienungsanleitung

IBASE Technology

IBASE Technology IB897 Bedienungsanleitung

IBASE Technology

IBASE Technology IB730 Bedienungsanleitung

IBASE Technology

IBASE Technology MI985 Bedienungsanleitung

IBASE Technology

IBASE Technology MI910E Bedienungsanleitung

IBASE Technology

IBASE Technology MB991AF Bedienungsanleitung

IBASE Technology

IBASE Technology MI805 Bedienungsanleitung

IBASE Technology

IBASE Technology IB908F Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung