IBASE Technology MB991AF Bedienungsanleitung

MB991AF

Intel®Xeon®/ 7th/6th Core™ /

Pentium®/ Celeron®

Micro-ATX Motherboard

User’s Manual

Version 1.0

(July 2017)

MB991AF User’s Manual

No part of this publication may be reproduced, copied, stored in a retrieval

system, translated into any language or transmitted in any form or by any

means, electronic, mechanical, photocopying, or otherwise, without the prior

written consent of IBASE Technology, Inc. (hereinafter referred to as

“IBASE”).

Disclaimer

IBASE reserves the right to make changes and improvements to the

products described in this document without prior notice. Every effort has

been made to ensure the information in the document is correct; however,

IBASE does not guarantee this document is error-free.

IBASE assumes no liability for incidental or consequential damages arising

from misapplication or inability to use the product or the information

contained herein, nor for any infringements of rights of third parties, which

may result from its use.

Trademarks

All the trademarks, registrations and brands mentioned herein are used for

identification purposes only and may be trademarks and/or registered

trademarks of their respective owners.

MB991AF User’s Manual

iii

Compliance

This is a class B product. In a domestic environment, this product may cause

radio interference in which case users may be required to take adequate

measures.

This product has been tested and found to comply with the limits for a Class

B device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with manufacturer’s

instructions, may cause harmful interference to radio communications.

WEEE

This product must not be disposed of as normal household

waste, in accordance with the EU directive of for waste

electrical and electronic equipment (WEEE - 2012/19/EU).

Instead, it should be disposed of by returning it to a

municipal recycling collection point. Check local

regulations for disposal of electronic products.

Green IBASE

This product is compliant with the current RoHS

restrictions and prohibits use of the following substances

in concentrations exceeding 0.1% by weight (1000 ppm)

except for cadmium, limited to 0.01% by weight (100 ppm).

•Lead (Pb)

•Mercury (Hg)

•Cadmium (Cd)

•Hexavalent chromium (Cr6+)

•Polybrominated biphenyls (PBB)

•Polybrominated diphenyl ether (PBDE)

MB991AF User’s Manual

Important Safety Information

Carefully read the precautions before using the board.

Environmental conditions:

•Use this product in environments with ambient temperatures between

0˚C and 60˚C.

•Do not leave this product in an environment where the storage

temperature may be below -20°C or above 80°C. To prevent from

damages, the product must be used in a controlled environment.

Care for your IBASE products:

•Before cleaning the PCB, unplug all cables and remove the battery.

•Clean the PCB with a circuit board cleaner or degreaser, or use cotton

swabs and alcohol.

•Vacuum the dust with a computer vacuum cleaner to prevent the fan

from being clogged.

WARNING

Attention during use:

•Do not use this product near water.

•Do not spill water or any other liquids on this product.

•Do not place heavy objects on the top of this product.

Anti-static precautions

•Wear an anti-static wrist strap to avoid electrostatic discharge.

•Place the PCB on an anti-static kit or mat.

•Hold the edges of PCB when handling.

•Touch the edges of non-metallic components of the product instead of

the surface of the PCB.

•Ground yourself by touching a grounded conductor or a grounded bit of

metal frequently to discharge any static.

CAUTION

Danger of explosion if the internal lithium-ion battery is replaced by an

incorrect type. Replace only with the same or equivalent type recommended

by the manufacturer. Dispose of used batteries according to the

manufacturer’s instructions or recycle them at a local recycling facility or

battery collection point.

MB991AF User’s Manual

Warranty Policy

•IBASE standard products:

24-month (2-year) warranty from the date of shipment. If the date of

shipment cannot be ascertained, the product serial numbers can be

used to determine the approximate shipping date.

•3rd-party parts:

12-month (1-year) warranty from delivery for the 3rd-party parts that are

not manufactured by IBASE, such as CPU, CPU cooler, memory,

storage devices, power adapter, panel and touchscreen.

＊PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,

IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR SHALL BE

TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL BE

BILLED FOR REPAIR AND SHIPPING CHARGES.

Technical Support & Services

1. Visit the IBASE website at www.ibase.com.tw to find the latest

information about the product.

2. If you need any further assistance from your distributor or sales

representative, prepare the following information of your product and

elaborate upon the problem.

•Product model name

•Product serial number

•Detailed description of the problem

•The error messages in text or in screenshots if there is any

•The arrangement of the peripherals

•Software in use (such as OS and application software, including the

version numbers)

3. If repair service is required, you can download the RMA form at

http://www.ibase.com.tw/english/Supports/RMAService/. Fill out the

form and contact your distributor or sales representative.

MB991AF User’s Manual

Table of Contents

Compliance.....................................................................................iii

Important Safety Information........................................................iv

Warranty Policy ...............................................................................v

Technical Support & Services .......................................................v

Chapter 1 General Information.............................................1

1.1 Introduction .........................................................................................2

1.2 Features..............................................................................................2

1.3 Packing List.........................................................................................3

1.4 Optional Accessories...........................................................................3

1.5 Specifications......................................................................................4

1.6 Block Diagram.....................................................................................6

1.7 Overview.............................................................................................7

1.8 Dimensions .........................................................................................8

Chapter 2 HardwareConfiguration..........................................9

2.1 Essential Installations Before You Begin...........................................10

2.1.1 Installing the Memory...........................................................10

2.2 Setting the Jumpers ..........................................................................11

2.2.1 How to Set Jumpers.............................................................11

2.3 Jumper & Connector Locations on MB991AF....................................12

2.4 Jumpers Quick Reference.................................................................13

2.4.1 CMOS Data Clearance (JP3)..............................................13

2.4.2 RTC Data Clearance (JP4)..................................................14

2.4.3 LVDS Power Selection (JP5)...............................................15

2.4.4 LVDS Backlight Power Selection (JP6) ...............................16

2.4.5 PCIe (x16) Bifurcation (JP8)................................................17

2.5 Connectors Quick Reference.............................................................18

2.5.1 COM1 & COM2 RS-232/422/485 Ports (CN3).....................19

2.5.2 COM3 & COM4 Ports (CN2) ...............................................20

2.5.3 Digital I/O Connector (J3)....................................................21

2.5.4 COM7 ~ COM10 Ports (J7, J8) ...........................................22

2.5.5 LVDS Connector (J9, J15) ..................................................23

2.5.6 USB 2.0 Ports (J14, J16).....................................................24

MB991AF User’s Manual

vii

2.5.7 LVDS Backlight Connector (J17) .........................................25

2.5.8 Front Panel Setting Connector (J21)....................................26

2.5.9 ATX Power Connector (J24)................................................27

2.5.10 AT 12V Power Connector (ATX_12V_2X1)..........................28

2.5.11 CPU Fan Power Connector (CPU_FAN1)............................29

2.5.12 System Fan Power Connector (SYS_FAN1, SYS_FAN2)....29

Chapter 3 Drivers Installation.............................................31

3.1 Introduction........................................................................................32

3.2 Intel®Chipset Software Installation Utility ..........................................32

3.3 HD Graphics Driver Installation..........................................................34

3.4 HD Audio Driver Installation...............................................................36

3.5 LAN Driver Installation.......................................................................37

3.6 Intel®Management Engine Drivers Installation ..................................39

3.7 Fintek 8150x Serial Port Drivers Installation.......................................41

Chapter 4 BIOS Setup..........................................................43

4.1 Introduction........................................................................................44

4.2 BIOS Setup........................................................................................44

4.3 Main Settings.....................................................................................45

4.4 Advanced Settings.............................................................................46

4.4.1 CPU Configuration................................................................47

4.4.2 Power & Performance...........................................................48

4.4.3 PCH-FW Configuration.........................................................49

4.4.4 Trusted Computing...............................................................50

4.4.5 ACPI Settings.......................................................................51

4.4.6 LVDS (eDP/DP) Configuration..............................................52

4.4.7 iSmart Controller...................................................................53

4.4.8 Fintek Super IO Configuration ..............................................54

4.4.9 Fintek Super IO Hardware Monitor........................................59

4.4.10 CSM Configuration ...............................................................60

4.4.11 NVMe Configuration .............................................................61

4.4.12 USB Configuration................................................................62

4.5 Chipset Settings ................................................................................64

4.5.1 System Agent (SA) Configuration.........................................65

4.5.2 PCH-IO Configuration...........................................................68

4.6 Security Settings................................................................................70

4.7 Boot Settings.....................................................................................71

4.8 Save & Exit Settings ..........................................................................72

viii

MB991AF User’s Manual

Appendix........................................................................................73

A. I/O Port Address Map........................................................................74

B. Interrupt Request Lines (IRQ)............................................................77

C. Watchdog Timer Configuration..........................................................79

D. On-Board Connector Types...............................................................83

Chapter 1

General Information

The information provided in this chapter includes:

•Features

•Packing List

•Specifications

•Block Diagram

•Board Overview

•Board Dimensions

MB991AF User’s Manual

1.1 Introduction

MB991AF is a Micro ATXmotherboard based on the platform of Intel®Xeon®

/ 7th/6th Gen. Core™ / Pentium®/ Celeron® QC or DC processor. It offers

high-definition visual experience and high performance on graphics

processing. It can also be well utilized for designs of low power consumption

in a board range of markets, including industrial control & automation, digital

signage, thin client, electronic gaming machines, and SMB storage

appliances.

Photo of MB991AF

1.2 Features

•Intel®Xeon®/ 7th/6th Gen. Core™i7/i5/i3 / Pentium®/ Celeron®QC /

DC processor, up to 4.2 GHz

•4 x DDR4 DIMM, expandable up to 64 GB

•Intel®processor integrated graphics device for HDMI (1.4) and LVDS

•2 x GbE LAN, 4 x USB 2.0, 6 x USB 3.0, 8 x COM, 5 x SATA III

•1 x PCIe (x16) [(x8) Link], 1x PCIe (x8), 1x PCIe (x4)

•1 x mini-PCIe, 1 x M.2 (M-key)

•Configurable watchdog timer and digital I/O

•iAMT (11.6), iSmart

Inhaltsverzeichnis

Andere IBASE Technology Hauptplatine Handbücher

IBASE Technology

IBASE Technology MI808 Bedienungsanleitung

IBASE Technology

IBASE Technology IB891 Bedienungsanleitung

IBASE Technology

IBASE Technology MB894 Bedienungsanleitung

IBASE Technology

IBASE Technology MBN800-8L Bedienungsanleitung

IBASE Technology

IBASE Technology MI992 Bedienungsanleitung

IBASE Technology

IBASE Technology RM-F6 Series Bedienungsanleitung

IBASE Technology

IBASE Technology IB945 Bedienungsanleitung

IBASE Technology

IBASE Technology IB811 Bedienungsanleitung

IBASE Technology

IBASE Technology MI941 Bedienungsanleitung

IBASE Technology

IBASE Technology MB899 Bedienungsanleitung

IBASE Technology

IBASE Technology MI930 Bedienungsanleitung

IBASE Technology

IBASE Technology MB770 Bedienungsanleitung

IBASE Technology

IBASE Technology MI933 Bedienungsanleitung

IBASE Technology

IBASE Technology MB898 Bedienungsanleitung

IBASE Technology

IBASE Technology IB915F Bedienungsanleitung

IBASE Technology

IBASE Technology MB950 Bedienungsanleitung

IBASE Technology

IBASE Technology BISD3-QM77 Bedienungsanleitung

IBASE Technology

IBASE Technology LV-67H Bedienungsanleitung

IBASE Technology

IBASE Technology MB980 Bedienungsanleitung

IBASE Technology

IBASE Technology MB995 Bedienungsanleitung

IBASE Technology

IBASE Technology MI920 Bedienungsanleitung

IBASE Technology

IBASE Technology MI991 Bedienungsanleitung

IBASE Technology

IBASE Technology MI958 Bedienungsanleitung

IBASE Technology

IBASE Technology IP400 Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung