ICHRoboter iCleaner-200 Bedienungsanleitung
200
1 Safety Warnings
Please read this manual carefully before using the iCleaner-200.
Before performing maintenance or service on the iCleaner-200 please
ensure the power is disconnected to avoid personal injury or property loss.
The iCleaner-200 is designed for use in swimming pools only. Any other
use is prohibited and will void manufacturers' warranty.
Do not swim in the pool whilst the iCleaner-200 is in use in order to avoid
personal injury.
Do not allow the Power Box to come in contact with water, and it is
recommended to be placed in a shady, dry and ventilated area.
When in use, the Power Supply and Caddy Cart must remain 3 meters
away from the edge of the pool.
Do not use the iCleaner-200 if there is a chance of thunder storm to avoid
personal injury.
Users are only permitted to perform maintenance described in this manual.
Any tampering with the Motor Box or Power Supply will void the
warranty.
Ensure the iCleaner-200 is fully submerged before turning the power box
on.
If the iCleaner-200 is not going be used for a long time, make sure to
disconnect the power, keep it clean and put it in a safe, dry and
well- ventilated area.
If the iCleaner-200 stops working, please refer to
t local distributor.
The optimum working temperature for the iCleaner-200 is between10℃
and 32℃, avoid direct sunlight when not in use.
The iCleaner-200 is suitable for the swimming pools no deeper than 3
meters.
Lift the iCleaner-200 out of the water using the robot handles, do not lift
the iCleaner using the floating cable. Lifting via the cable voids warranty.
section 6
“Troubleshooting”. If you cannot find the root cause, please contact
your
- 1 -
2 Product Overview
2.1 Functions
◇ Automatic cleaning: the default mode is automatic, however, this can be overridden using the
Remote Control. When the Remote Control is not being used, the iCleaner-200 will return to
automatic mode.
◇ Overall cleaning: the iCleaner-200 not only cleans the floor of your pool, it also cleans the
wall, at the same time, the iCleaner-200 will filter water, and the dirt will be collected into
Filter Bag.
◇ Timing cleaning: you can select one of three cleaning time with Remote Control (0.5h, 1h or
2 h). The iCleaner-200 will shut down automatically when the selected cycle time is over.
The power box must be turned of manually.
◇ Manual cleaning: the Remote Control can be used to clean specific areas immediately.
◇ Self protection (out of water): Impeller decelerates to a stop in twenty five seconds if the
iCleaner-200 senses it is no longer in water, to prevent personal injury and to protect the
water pump.
◇ Stop protection: the iCleaner-200 will stop if foreign matter retards the Impeller.
2.2 Product Parameters
iCleaner-200
100-240VAC, 50-60Hz
200W
0.5Hr/1Hr/2Hrs
15m
3
20m /h
15m/min
Host: IP68
Model
Input Voltage
Rated Power
Cycle Time
Floating Cable Standard Length
Filter Bag
Water Pump Capacity
Moving speed
Optimum Storage Temperature
Optimum Working Temperature
Dimension（L*W*H）
Grade of Waterproof
- 2 -
Standard:70um
10~32℃
0~40℃
452.5*487.8*292mm
Gross Weight
574*574*413mm
Packing Measurement(L*W*H)
20.6kg
2.3 Parts List
Main Body Parts Guide Vane
（Pic.2.3.2）
- 3 -
Drive Belt
Water Joint
Filter Net
water retaining board
Base Plate
Support Frame
Filter Bag
Base Plate Latch
Motor Box
※ Power Box Parts
- 4 -
1
1
1
9
10
11
Floating Cable
Impeller
Filter Bag
（Pic.3.2.1）
- 5 -
1
1
1
1
1
1
1
1
1
2
3
4
5
6
7
8
3 Packing List
Part Name
Unit Body
Power Box
Remote Control
Battery
Guide Vane
User Manual
Warranty Card
Certificate of Quality
Serial
Number Remarks
Host
Quantity
I
1 0
1 1
Spare Parts
4 Product Operation
4.1 Power Connection
※ Please connect the Floating Cable to the Cable Socket of Power Box (see Pic.
4.1.1), then connect the Power Box to an outside AC power of 100v/240v
50/60Hz (see Pic.4.1.2). For the complete connection guide please refer
Pic.4.1.3
Notices: Do not allow the Power Box to come in contact with water.
Please ensure the Power Box is Kept in a shady, dry & ventilated area.(Refer Page 1.Safety Warning)
(Pic.4.1.1) (Pic.4.1.2)
- 6 -
Unit Body
4.2 Start Up Procedure
(1) When placing the iCleaner-
200 in the pool: you must
wobble the iCleaner-200
according Pic.4.2.1 to make
sure the air inside is released
when you put the iCleaner-
200 in the water,
So it will automatically sink
to the bottom of pool.
(2) Start: Press the “ON” button,
LED “POWER” indicator.
And “0.5H” cycle time LED
will illuminate(see pic.4.2.2)
You may select 0.5Hr, 1Hr or
2Hrs cleaning time using the
“ ”button on the
Remote Control and relative
L E D i n d i c a t o r s w i l l
illuminate on the Power Box
when selected.
（Pic.4.2.1）
（Pic.4.2.2）
- 7 -
4.3 Proper Shut Down and Care
(1) To Shut Down The iCleaner-200:
Turn the power switch on the power
Box to the off position, once the
iCleaner-200 finishes working, pull the
Floating Cable slowly until the Handle
emerges from the water (Pic.4.3.1), and
then pull the iCleaner-200 out of the
pool by its Handle.
(2) Clean iCleaner-200: Invert the iCleaner-200 gently onto the floor, unlock the
Latch on the Base Plate (Pic4.3.2) and remove the Filter Bag from Base Plate,
clean the Filter Bag (Pic.4.3.3), once clean place the Filter Bag on its frame,
reassemble the Base Plate and put it back into the iCleaner-200 once the Filter
Bag is dry.
(Note: When re-fitting the Filter Bag to the Base Plate, please ensure the long
sides of the Filter Bag are smooth to ensure an easy fit into the base of the
iCleaner-200.)
6
4
OPEN
OPEN
Bottom Button
Pull
(3) iCleaner-200 Storage: When the iCleaner-200 is dry,disconnect the floating
cable reel it in hand-over-hand and place on the iCleaner-200, then store the
iCleaner-200 in a dry,well-ventilated area. If you have the Caddy , please put the
iCleaner-200 & Floating Cable on to the Caddy Cart, details please refer
Pic.4.3.4
- 9 -
（Pic.4.4.1）
Floor Only Cleaning
The Remote Control (Pic.4.4.1) includes:
On/Off Power Button
LED Light Indicator
Direction Button
Timer Button
Floor Only Cleaning
On/Off Power Button:
Turn on or Turn off iCleaner-200
Direction Button:
Control iCleaner-200's movement Backward , Left Rotation and Right
Rotation
Timer Button :
Select the timing mode from 0.5hour, 1 hour and 2hours
Floor Only Cleaning :
To clean the “Floor Only ” press . To return to floor and wall cleaning, turn the
iCleaner-200 off, then on using the remote contorl .
Inhaltsverzeichnis
Andere ICHRoboter Schwimmbadreiniger Handbücher
Beliebte Schwimmbadreiniger Handbücher anderer Marken
Hayward
Hayward Aquabug Bedienungsanleitung
Hayward Pool Products
Hayward Pool Products MAGIC CLEAN Bedienungsanleitung
Polaris
Polaris 3900 Sport Bedienungsanleitung
Maytronics
Maytronics MCC8-UNI Bedienungsanleitung
GRE
GRE 90399 Bedienungsanleitung
Blue Lagoon
Blue Lagoon UV-C Pro Buster 450.000 l Bedienungsanleitung
