Icom IC-F4022T Bedienungsanleitung
INSTRUCTION MANUAL
iF3022T/S
VHF TRANSCEIVERS
The photo shows the 10-key
version VHF transceiver.
iF4022T/S
UHF TRANSCEIVERS
PRECAUTIONS
i
RCAUTION! NEVER hold the transceiver so that the
antenna is very close to, or touching exposed parts of the
body, especially the face or eyes, while transmitting. The
transceiver will perform best if the microphone is 5 to 10 cm
away from the lips and the transceiver is vertical.
RCAUTION! NEVER operate the transceiver with a
headset or other audio accessories at high volume levels.
RCAUTION! NEVER short the terminals of the bat-
tery pack.
DO NOT push [PTT] when not actually desiring to trans-
mit.
AVOID using or placing the transceiver in direct sunlight or
in areas with temperatures below –25°C or above +55°C.
The basic operations, transmission and reception of the trans-
ceiver are guaranteed within the specified operating temper-
ature range. However, the LCD display may not be operate
correctly, or show an indication in the case of long hours of
operation, or after being placed in extremely cold areas.
WORD DEFINITION
RWARNING Personal injury, fire hazard or electric shock
may occur.
CAUTION Equipment damage may occur.
NOTE If disregarded, inconvenience only. No risk
of personal injury, fire or electric shock.
READ ALL INSTRUCTIONS carefully and com-
pletely before using the transceiver.
SAVE THIS INSTRUCTION MANUAL— This
instruction manual contains important operating instructions
for the IC-F3022T/S VHF TRANSCEIVERS and the IC-
F4022T/S UHF TRANSCEIVERS.
IMPORTANT
Icom, Icom Inc. and the logo are registered trademarks of Icom
Incorporated (Japan) in the United States, the United Kingdom, Germany,
France, Spain, Russia and/or other countries.
EXPLICIT DEFINITIONS
ii
DO NOT modify the transceiver for any reason.
KEEP the transceiver from the heavy rain, and Never
immerse it in the water. The transceiver construction is water
resistant, not waterproof.
The use of non-Icom battery packs/chargers may impair
transceiver performance and invalidate the warranty.
iii
IMPORTANT ........................................................................ i
EXPLICIT DEFINITIONS ..................................................... i
PRECAUTIONS ................................................................... i
TABLE OF CONTENTS ...................................................... iii
1 ACCESSORIES ......................................................... 1–3
■Supplied accessories ................................................. 1
■Accessory attachments .............................................. 1
2 PANEL DESCRIPTION ............................................. 4–9
■Front panel ................................................................. 4
■Function display ......................................................... 6
■Programmable function keys ..................................... 7
3 BASIC OPERATION ............................................. 10–15
■Turning power ON .................................................... 10
■Channel selection ..................................................... 11
■Call procedure........................................................... 11
■Receiving and transmitting........................................ 12
■User set mode........................................................... 14
■Emergency transmission .......................................... 15
■Scrambler function .................................................... 15
■Stun function ............................................................ 15
■Priority A channel selection ...................................... 15
4 BATTERY CHARGING .......................................... 16–20
■Caution ..................................................................... 16
■Optional battery chargers ......................................... 18
5 BATTERY CASE ......................................................... 21
■Optional battery case (BP-240) ................................ 21
6 OPTIONAL SWIVEL BELT CLIP .......................... 22–23
■MB-93 contents ........................................................ 22
■Attaching .................................................................. 22
■Detaching ................................................................. 23
7 OPTIONS ............................................................... 24–25
8 DOC ....................................................................... 26–27
TABLE OF CONTENTS
1
1
ACCESSORIES
1
■Supplied accessories ■Accessory attachments
DFlexible antenna
Connect the supplied flexible antenna
to the antenna connector.
CAUTION!
• NEVER HOLD the antenna when
carrying the transceiver.
• Transmitting without an antenna
may damage the transceiver.
Flexible antenna Battery pack Belt clip
Unit cover
(double-sided tape)*
Jack cover
(with screws)
*Use the unit cover as a spare. Ask your dealer for details.
2
1ACCESSORIES
ïBattery pack
To attach the battery pack:
Slide the battery pack in the direction of the arrow (q), then
lock it with the battery release button.
• Slide the battery pack until the battery release button makes a ‘click’
sound.
To release the battery pack:
Slide the battery release button in the direction of the arrow
(w) as shown below. The battery pack is then released.
NEVER release or attach the battery pack when the trans-
ceiver is wet or soiled. This may result water or dust get-
ting into the transceiver/battery pack and may result in the
transceiver being damaged.
DBelt clip
To attach the belt clip:
qRelease the battery pack if it is attached.
wSlide the belt clip in the direction of the arrow until the belt
clip is locked and makes a ‘click’ sound.
To detach the belt clip:
qRelease the battery pack if it is attached.
wPinch the clip (q), and slide the belt clip in the direction of
the arrow (w).
q
w
q
w
Battery release button
3
1
ACCESSORIES
1
ïJack cover
Attach the jack cover when the optional speaker-microphone
or headset is not used.
To attach the jack cover:
qAttach the jack cover to the [MIC/SP] jack.
wTighten the screws.
CAUTION!
• Attach the jack cover when the optional speaker-micro-
phone or headset is not used.
• Use the supplied screws only.
To detach the jack cover:
qUnscrew the screws using a phillips screwdriver.
wDetach the jack cover for the speaker-microphone or
headset connection.
q
q
w
qw
[MIC/SP] jack
Jack cover
4
2PANEL DESCRIPTION
■Front panel
qANTENNA CONNECTOR
Connects the supplied antenna.
wDEALER-PROGRAMMABLE KEY [Emer]
Desired function can be programmed by your dealer.
(p. 7)
eDEALER-PROGRAMMABLE KEY [Side1]
Desired function can be programmed by your dealer.
(p. 7)
rPTT SWITCH [PTT]
Push and hold to transmit; release to receive.
tDEALER-PROGRAMMABLE KEYS [Side2]/[Side3]
Desired functions can be programmed independently by
your dealer. (p. 7)
y10-KEYPAD (Depending on version)
The keypad allows you to enter digits to:
• Select memory channels
• Select tone channels
• Select DTMF codes (during transmit)
• Set TX codes
• Start up with the password
uDEALER-PROGRAMMABLE KEYS [P0] to [P3]
Desired functions can be programmed independently by
your dealer. (p. 7)
iFUNCTION DISPLAY (p. 6)
Displays a variety of information such as an operating
channel number/name, 5-tone code, DTMF numbers,
selected function, etc.
q
w
r
eo
i
u
y
Microphone
Speaker
!0
t
5
2
PANEL DESCRIPTION
2
oEXTERNAL MICROPHONE/SPEAKER JACK
Connect an optional speaker-microphone or headset.
NOTE: Connect or disconnect the optional equipment
after the transceiver is turned OFF.
!0 VOLUME CONTROL [VOL]
Rotate to turn the power ON/OFF and adjusts the audio
level.
Jack cover
NOTE: Attach the jack
cover when the optional
equipment is not used.
See (p. 3) for details.
6
2PANEL DESCRIPTION
■Function display
qTRANSMIT INDICATOR
Appears while transmitting.
wBUSY INDICATOR
Appears while the channel is busy.
eSIGNAL STRENGTH INDICATOR
Indicates relative signal strength level.
rLOW POWER INDICATOR
Appears when low output power is selected.
• When the battery power decreases to a specified level, low
power is selected automatically.
tAUDIBLE INDICATOR
➥Appears when the channel is in the ‘audible’ (unmute)
condition.
➥Appears when the specified 5-tone code is received.
ySCRAMBLER INDICATOR
Appears when the voice scrambler function is activated.
uBELL INDICATOR
Appears/blinks when the specific 5-tone code is received,
according to the pre-programming.
iKEY LOCK INDICATOR
Appears during the key lock function is ON.
oBATTERY INDICATOR
Appears or blinks when the battery power decreases to a
specified level.
!0 ALPHANUMERIC DISPLAY
Displays an operating channel number, channel name, Set
mode contents, DTMF code, etc.
yq iutrew
o
!0
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere Icom Transceiver Handbücher
Icom
Icom IC-440N Bedienungsanleitung
Icom
Icom IC-M503 Bedienungsanleitung
Icom
Icom IC-24ET Bedienungsanleitung
Icom
Icom IC-E91 Bedienungsanleitung
Icom
Icom IC-2SAT Bedienungsanleitung
Icom
Icom IC-7000 Bedienungsanleitung
Icom
Icom IC-M32 Bedienungsanleitung
Icom
Icom A25N 46 USA Installationsanleitung
Icom
Icom IC-F9011B Bedienungsanleitung
Icom
Icom IC-7100 Einrichtungshandbuch
Icom
Icom iF3102D Bedienungsanleitung
Icom
Icom IC-746 Installationsanleitung
Icom
Icom IC-A210 Bedienungsanleitung
Icom
Icom ID-1 Bedienungsanleitung
Icom
Icom IC-M604 Bedienungsanleitung
Icom
Icom IC-41S Bedienungsanleitung
Icom
Icom ID-5100A Bedienungsanleitung
Icom
Icom IC-M87 Bedienungsanleitung
Icom
Icom IC-F3262DT Bedienungsanleitung
Icom
Icom IC-A110 Bedienungsanleitung
