Icom IC-F51 Bedienungsanleitung
INSTRUCTION MANUAL
UHF TRANSCEIVER
iF61
VHF TRANSCEIVER
iF51
i
FOREWORD
READ ALL INSTRUCTIONS carefully and completely before
using the transceiver.
SAVE THIS INSTRUCTION MANUAL— This instruction
manual contains important operating instructions for the IC-F51
vhf transceiver and IC-F61 uhf transceiver.
EXPLICIT DEFINITIONS
WORD DEFINITION
RWARNING Personal injury, fire hazard or electric shock
may occur.
NOTE If disregarded, inconvenience only. No risk
of personal injury, fire or electric shock.
CAUTION Equipment damage may occur.
OPERATING NOTES
• When transmitting with a portable radio, hold the radio in a ver-
tical position with its microphone 5 to 10 centimeters away from
your mouth. Keep the antenna at least 2.5 centimeters from your
head and body.
• If you wear a portable two-way radio on your body, ensure that
the antenna is at least 2.5 centimeters from your body when
transmitting.
ii
PRECAUTIONS
RWARNING! NEVER hold the transceiver so that the an-
tenna is very close to, or touching exposed parts of the body, espe-
cially the face or eyes, while transmitting. The transceiver will per-
form best if the microphone is 5 to 10 cm away from the lips and
the transceiver is vertical.
RWARNING! NEVER operate the transceiver with a headset
or other audio accessories at high volume levels.
CAUTION! NEVER short the terminals of the battery pack.
NEVER connect the transceiver to a power source other than the
BP-227AX. Such a connection will ruin the transceiver.
NEVER use non-Icom battery packs/chargers to prevent the loss
of the transceiver’s good performance and warranty.
DO NOT push the PTT when not actually desiring to transmit.
DO NOT use or place the transceiver in direct sunlight or in areas
with temperatures below –20°C or above +55°C.
The basic operations, transmission and reception of the trans-
ceiver, are guaranteed within the specified operating temperature
range (depending on version). However, the LCD display may be
operate correctly, or show an indication in the case of long hours of
operation, or after being placed in extremely cold areas.
DO NOT modify the transceiver for any reason.
MAKE SURE the flexible antenna and battery pack are securely
attached to the transceiver, and that the antenna and battery pack
are dry before attachment. Exposing the inside of the transceiver to
water will result in serious damage to the transceiver.
Icom optional equipment is designed for optimal performance when
used with this transceiver. We are not responsible for the trans-
ceiver being damaged or any accident caused when using non-
Icom optional equipment.
iii
TABLE OF CONTENTS
FOREWORD……………………………………………………………… i
EXPLICIT DEFINITIONS ……………………………………………… i
OPERATING NOTES …………………………………………………… i
PRECAUTIONS ………………………………………………………… ii
TABLE OF CONTENTS ………………………………………………… iii
SUPPLIED ACCESSORIES …………………………………………… iv
INTRINSIC SAFETY …………………………………………………… v
1 ACCESSORIES …………………………………………………… 1–3
‘Accessory attachments …………………………………………… 1
2 PANEL DESCRIPTION ………………………………………… 4–12
‘ Front, top and side panels ………………………………………… 4
‘Function display …………………………………………………… 7
‘Programmable function keys ……………………………………… 8
3 CONVENTIONAL OPERATION ……………………………… 13–19
‘Turning power ON …………………………………………………13
‘Channel selection ……………………………………………………13
‘Call procedure ………………………………………………………14
‘ Receiving and transmitting …………………………………………15
‘ Scrambler function …………………………………………………18
‘ User set mode ………………………………………………………19
4 BIIS OPERATION………………………………………………… 20–35
‘ Default setting ………………………………………………………20
‘Receiving a call………………………………………………………21
‘Transmitting a call …………………………………………………24
‘Receiving a message ………………………………………………27
‘Transmitting a status ………………………………………………30
‘Transmitting an SDM ………………………………………………31
‘Position data transmission …………………………………………32
‘Printer connection……………………………………………………33
‘PC connection ………………………………………………………33
‘Digital ANI ……………………………………………………………33
iv
TABLE OF CONTENTS
‘Auto emergency transmission ……………………………………34
‘Stun function …………………………………………………………34
‘BIIS indication ………………………………………………………35
‘Priority A channel selection…………………………………………35
5 BATTERY CHARGING ………………………………………… 36–42
‘ Battery charging ……………………………………………………36
‘Caution ………………………………………………………………37
‘Optional battery chargers …………………………………………38
6 SPEAKER-MICROPHONE……………………………………… 43–44
‘ Optional HM-138 description ………………………………………43
‘Attachment……………………………………………………………44
7 OPTIONS ………………………………………………………………45
8 ATEX CAUTIONS………………………………………………… 46–47
9 DOC ……………………………………………………………………48
SUPPLIED ACCESSORIES
The following accessories are supplied: Qty.
• Flexible antenna…………………………………………………… 1
• Battery pack ……………………………………………………… 1
• Jack cover ……………………………………………………… 1 set
• Belt clip ………………………………………………………… 1 set
• Function name stickers* (KEY-STICKER)……………………… 1
*
There are no names on the programmable function keys since the
functions can be freely assigned to [P0] to [P3], [Red], [ ] and [ ]
keys.
Attach the supplied function name stickers above the appropriate
keys for easy recognition of that key’s assigned function.
v
INTRINSIC SAFETY
Versions of the IC-F51/F61 which display the “EX” mark-
ing on the serial number seal.
The approval rating for these models is II2G Ex ib IIA T3.
WARNING! NEVER charge the BP-227AX (with/without the trans-
ceiver) in an explosive atmosphere. The optional battery chargers are
not approved as Intrinsically Safe.
When the transceiver is used in a hazardous area, the BP-227AX
MUST be attached, either the jack cover or HM-138 MUST be at-
tached to the speaker-microphone connector.
KEEP the transceiver and the BP-227AX clean to avoid any risk of ig-
nition due to the build-up of electrostatic charges.
Repair of Icom radios should only be carried out by authorized Icom
distributors. In particular, repair of ATEX approved radios can ONLY
be done by Icom to maintain the intrinsically safe rating. NEVER at-
tempt to repair an ATEX approved radio. Only Icom has the repair ex-
pertise and procedures to maintain the ATEX approval. Contact your
Icom distributor or authorised dealer for details.
The ATEX standard is described on the 94/9/EC sticker (Ex Mark-
ing) and BP-227AX as below.
The following illustrations are show for the IC-F51/F61.
BP-227AX
1
1
ACCESSORIES
1
■Accessory attachments
DFlexible antenna
Connect the supplied flexible antenna
to the antenna connector.
CAUTION!
• NEVER HOLD by the antenna when
carrying the transceiver.
• Transmitting without an antenna
may damage the transceiver.
ïJack cover
Attach the jack cover when the optional speaker-microphone is not
used.
When the transceiver is used in a hazardous areas, either the jack
cover or HM-138 must be attached to the connector. Failure to do
this will make the radio ATEX non-compliant and may result in an
accident during use in hazardous areas.
To attach the jack cover:
qInsert the jack cover into the
[SP MIC] connector.
wTighten the screw.
To detach the jack cover:
qUnscrew the screw with a
phillips screwdriver.
wDetach the jack cover for the
speaker-microphone con-
nection.
q
w
q
w
2
1ACCESSORIES
ïBattery pack
To attach the battery pack:
Slide the battery pack on the back of the transceiver in the direction
of the arrow (q), then lock it with the battery release button.
• Slide the battery pack until the battery release button makes a ‘click’
sound.
To release the battery pack:
Push the battery release button in the direction of the arrow (w) as
shown below. The battery pack is then released.
NEVER release or attach the battery pack when the transceiver
is wet or soiled. This may result in water or dust getting into the
transceiver/battery pack and may damage the transceiver.
q
w
Battery pack
Battery release button
3
1
ACCESSORIES
1
DBelt clip
Attach the belt clip to the back of the transceiver with the supplied
screws.
Supplied screws
4
2PANEL DESCRIPTION
■Front, top and side panels
q
w
e
r
t
y
i
uMicrophone
Function display
(p. 7)
Speaker
(See the following
NOTE.)
NOTE: If the speaker netting (for dust proofing) becomes
wet, dry it with a hair drier (cool mode) etc. before operating
the transceiver. Otherwise the audio may be difficult to hear
for loss of the sound pressure.
Andere Handbücher für IC-F51
4
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Icom Transceiver Handbücher
Icom
Icom IC-W32A Bedienungsanleitung
Icom
Icom IC-iA210 Bedienungsanleitung
Icom
Icom IC-M85 Bedienungsanleitung
Icom
Icom IC-240 Bedienungsanleitung
Icom
Icom IC-F3061S Bedienungsanleitung
Icom
Icom IC-7100 Installationsanleitung
Icom
Icom IC-M45EURO Bedienungsanleitung
Icom
Icom IC-G88 Bedienungsanleitung
Icom
Icom IC-A25N Installationsanleitung
Icom
Icom IC-A210 Bedienungsanleitung
Icom
Icom UltraTech IC-F4GT-4 Bedienungsanleitung
Icom
Icom IC-F70T Bedienungsanleitung
Icom
Icom IC-F29SDR Installationsanleitung
Icom
Icom IC-F4GS Bedienungsanleitung
Icom
Icom IC-756PRO III Bedienungsanleitung
Icom
Icom IC-3SAT Bedienungsanleitung
Icom
Icom IC-M57 Bedienungsanleitung
Icom
Icom IC-7700 Bedienungsanleitung
Icom
Icom IC-F6011-67 Bedienungsanleitung
Icom
Icom IC-E2820 Bedienungsanleitung
