IDEAL C80 ff Bedienungsanleitung

Supplied By www.heating spares.co Tel. 0161 620 6677

Householders guide to central heating boilers

the combi boiler

Wall mounted,

gas fired fanned flue

combination boiler

C95 FF

C80 FF

the combi boiler

Supplied By www.heating spares.co Tel. 0161 620 6677

2C80 FF and C95 FF - User's

Safety

It is essential that the instructions in this booklet are strictly

followed, for safe and economical operation of the boiler.

Current Gas Safety (Installation and Use) Regulations or

rules in force. In your own interest, and that of safety, it is the

law that this boiler must be installed by a CORGI registered

installer, in accordance with the above regulations.

Tampering with sealed components or incorrect use of the

boiler will invalidate the boiler guarantee.

CAUTION.

To avoid the possibility of injury during the installation, servicing

or cleaning of this appliance care should be taken when handling

edges of sheet steel components.

Electricity Supply

This appliance must be connected to the supply via a double-

pole switch, fused at 3 A.

C80 FF ......................... G.C. Appliance No. 47 348 05

C95 FF ......................... G.C. Appliance No. 47 348 06

CAUTION.

To avoid the possibility of injury during the installation, servicing or cleaning of

this appliance care should be taken when handling edges of sheet steel components.

Natural Gas Models Only

Minimum Clearances

The minimum clearances given below must be complied with in

order to maintain the safe running of the boiler and to facilitate

servicing. Above the boiler - 160 mm (6 1/4")

At LH side of the boiler - 15 mm (5/8")

At RH side of the boiler - 35 mm (1 3/8")

Underneath the boiler casing:

for service - 150 mm (6")

Front of the boiler:

for service - 450 mm (18")

Supplied By www.heating spares.co Tel. 0161 620 6677

C80 FF and C95 FF - User's

AB CDEF

Rap 1387

Control of water temperature

DOMESTIC HOT WATER

The domestic hot water draw-off temperature is normally limited

by the modulating gas control to approximately 60 oC at the

minimum water draw-off rate of about 3.5 litre/min. (0.75 g.p.m.).

It can be varied between 60 oC and 35 oC by adjusting the hot

water temperature control (C).

CENTRAL HEATING

The boiler modulating control automatically maintains the central

heating radiator temperature between 84 oC and 40 oC by

adjusting the variable heating temperature control (B).

If your system includes a room thermostat the heating

temperature control (B) may be left in its maximum position.

If your household includes very young or elderly people you may,

however, reduce this setting, for safety reasons.

To light the boiler

(see illustration )

Summer Conditions - Domestic Hot Water Only

Set the main switch (A) to HOT WATER .

Note. Whenever domestic hot water is drawn off, the boiler will

fire to provide hot water at the tap.

Winter Conditions - Central Heating & Domestic Hot Water

Set the main switch (A) to HEATING & HOT WATER .

The boiler will fire and supply heat to the radiators but will give

priority to domestic hot water when required.

NOTE TO THE INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE HOUSEHOLDER

Important Notes

1. THIS APPLIANCE MUST NOT BE OPERATED WITHOUT

THE INNER FRONT SEALING PANEL BEING CORRECTLY

FITTED.

2. Compartment Installations

If the boiler is installed in a compartment then the

compartment MUST NOT be used for storage purposes.

Ventilation provided for boilers installed in compartments

MUST NOT be blocked, and a check should be made

periodically that the ventilation areas are free from any

obstruction.

3. If it is known or suspected that a fault exists on the boiler then

it MUST NOT BE USED until the fault has been corrected by

a CORGI registered installer.

Escape of gas

Should a gas leak or fault be suspected contact your local gas

supplier without delay.

Do NOT search for gas leaks with a naked flame.

Cleaning

For normal cleaning simply dust with a dry cloth.

To remove stubborn marks and stains use a damp cloth and mild

detergent.

DO NOT use abrasive cleaning materials.

Maintenance

The appliance should be serviced at least once a year by a

CORGI registered installer.

IMPORTANT - DRAINING THE SYSTEM

It is not good practice to drain off radiators to decorate behind

them. In the case of sealed system boilers, such as this, it will

lower the system pressure AND MAY CAUSE THE BOILER TO

STOP WORKING.

BOILER CONTROLS DOverheat thermostat reset button

ESystem water pressure gauge

FProgrammer (optional)

LEGEND

AMain switch

BHeating temperature control

CHot water temperature control

Supplied By www.heating spares.co Tel. 0161 620 6677

Caradon Plumbing Limited pursues a policy of continuing

improvement in the design and performance of its products. The

right is therefore reserved to vary specification without notice.

September 2000 155 553A01

Caradon Plumbing Limited, P.O. Box 103,

National Ave, Kingston upon Hull, HU5 4JN.

Telephone: 01482492251Fax:01482448858.

Registration No. London 322 137. Registered

Office:NationalAvenue,KingstonuponHull, HU5

4JN. A subsidiary of Caradon p.l.c

deal Consumer Helpline: 01482 498 660

Faults

A. No heating or hot water

Check that gas and electricity are available at the boiler and

that all switches are on.

Check that the system water pressure gauge (F) reads at

least 0.5 bar.

Check that the overheat thermostat has not tripped.

Remove cover and press button (D) to reset.

Turn the main switch (A) to OFF (O) position,wait 5seconds

and return to desired setting.

B.Hot water but no heating

Check that the programmer and room thermostat (if fitted)

are both calling for heat.

C. Heating but no hot water

Check that cold water does flow out of the hot taps at a

minimum rate of 3.5 litres per minute (or 1 pint in 10

seconds or less).

If not, look for stop valves not fully open.

If these simple checks fail to solve the problem, or the

problem recurs, consult your service engineer.

Caradon Plumbing Ltd. is a member of the Benchmark

initiative and fully supports the aims of the programme.

Benchmark has been introduced to improve the

standards of installation and commissioning of central

heating systems in the UK and to encourage the

regular servicing of all central heating systems to

ensure safety and efficiency.

The code of practice for the installation,

commissioning & servicing of central heating systems

To shut down the boiler

Set the main switch (A) to OFF (O).

When heating is again required, restore the switch to the HOT

WATER or HEATING & HOT WATER.

Frost

If no frost protection is provided and frost is likely during a short

absence from home, leave the heating control (B) at a reduced

temperature setting.

For longer periods, the entire system should be drained -

including the domestic water supply .

If the system includes a frost thermostat then, during cold

weather, the boiler should be turned OFF by selecting the OFF

programme at the time control.

The mains supply should be left switched ON.

If in doubt, ask your installer.

To relight the boiler

Repeat the procedure detailed in 'To light the boiler'.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere IDEAL Kessel Handbücher

IDEAL

IDEAL Exalt FSB 110 Benutzerhandbuch

IDEAL

IDEAL CF440 Bedienungsanleitung

IDEAL

IDEAL LOGIC HIU Direct MT Bedienungsanleitung

IDEAL

IDEAL Concord CXAP 40 Bedienungsanleitung

IDEAL

IDEAL F80 Bedienungsanleitung

IDEAL

IDEAL MINI C24 Bedienungsanleitung

IDEAL

IDEAL EVO S 50 Bedienungsanleitung

IDEAL

IDEAL Concord CXA120 Benutzerhandbuch

IDEAL

IDEAL Vogue Combi c26 Bedienungsanleitung

IDEAL

IDEAL F320 Bedienungsanleitung

IDEAL

IDEAL IMAX XTRA EL 320 Bedienungsanleitung

IDEAL

IDEAL Logic HEAT 12 Bedienungsanleitung

IDEAL

IDEAL Response FF80 Bedienungsanleitung

IDEAL

IDEAL Concord CXSi 120/H Datenblatt

IDEAL

IDEAL EXALT Combi 155 Bedienungsanleitung

IDEAL

IDEAL imax W45 Datenblatt

IDEAL

IDEAL Esprit eco 30 Benutzerhandbuch

IDEAL

IDEAL GTE 5 Bedienungsanleitung

IDEAL

IDEAL EVOMAX 2 Series Bedienungsanleitung

IDEAL

IDEAL Viceroy GT Series Leitfaden

IDEAL

IDEAL Concord CX40 Beilage

IDEAL

IDEAL Concord CXA 40/H Benutzerhandbuch

IDEAL

IDEAL Concord CXSD 40 Bedienungsanleitung

IDEAL

IDEAL Vogue System Gen 2 S15 Bedienungsanleitung

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung

IDEAL c80 ff Bedienungsanleitung

Beliebte Kessel Handbücher anderer Marken