IDEAL CONCORD SUPER SERIES 4 Bedienungsanleitung

USER GUIDE

IDEAL CONCORD SUPER SERIES 4

50 TO 600 VERTICAL &

250 TO 600 HORIZONTAL,

MODULAR GAS FIRED BOILERS

When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance

speciﬁcation that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.

For the very latest copy of literature for speciﬁcation and maintenance practices visit our website www.idealcommercialboilers.com

where you can download the relevant information in PDF format.

July 2018

UIN 100921 A03

Page 2

Mains on

Overheat

Lockout

Burner on

Lockout reset

IDEAL • CONCORD SUPER • S4

WARNING. Isolate mains supply before removing this cover.

MODULE

The Gas Safety (Installation & Use) Regulations: 1984

impose certain statutory obligations on gas users.

Further information may be obtained on application to

the Gas Region.

This appliance should be installed by a qualied

installer.

WARNING: This appliance must be earthed.

TO LIGHT A MODULE (See Frame 1)

1. Ensure that water is owing through the boiler and

that all external controls are turned ON.

2. Check that the main inlet gas service tap is ON.

3. Turn the module gas service tap to ON.

4. Switch the electrical supply to the boiler ON. The

following sequence of events will now take place:

(a) The ‘Mains On’ light will be illuminated.

(b) For multi-module boilers

All the fans will start and run for approximately 30

seconds then, depending on the module’s position

in the switching sequence, the fan will stop for a

period of up to 50 seconds, restart and run for a

further 15 seconds. The operation is part of the

pre-purge safety feature of the Ideal Concord

Super boiler.

For single-module boilers

For single-module boilers with no wiring centre,

the fan will start and run for approximately 15

seconds.

commence. The ignition electrode will spark to the

burner, the gas valves will open and the burner will

light. The ‘Burner On’ light will be illuminated.

(d) The burner will continue to re until the thermostat

is satised. The gas supply to the burner will then

be cut off and the fan will stop. The ‘Burner On’

light will go out.

Note:

If the burner fails to light the ‘Lockout’ light will

illuminate at the end of the 4 second ignition

sequence.

To Attempt Re-ignition:

If a module indicator panel is signalling ‘Lockout’

wait for 15 seconds then press in and release the

recessed reset button, using a pen or similar tool.

The ignition sequence will recommence. If, after three

attempts, the burner does not light a qualied gas/

heating engineer should be consulted.

SAFETY TEMPERATURE LIMITER

Each module is tted with a safety temperature limiter.

If the safety temperature limiter has tripped the

‘Overheat’ light will be illuminated.

Tripping of the safety temperature limiter must be

investigated by a qualied gas/heating engineer.

MODULE ELECTRONIC ADJUSTABLE

CONTROL THERMOSTAT

All Models

The module control thermostat has been set by the

boiler commissioning engineer, to give the correct

sequence of module operation.

IMPORTANT

The control thermostat should NOT, therefore,

be readjusted by the user.

1 MODULE CONTROL PANEL

Page 3

TO SHUT DOWN A MULTI-MODULE BOILER

1. For short periods:

Turn off the electricity supply to the boiler.

2. For longer periods:

Turn OFF the mains electricity supply.

Turn OFF all module gas service taps.

Turn OFF the main inlet gas tap.

Turn water and all system controls to OFF.

FROST WARNING

If frost is likely during a short absence, leave the

boiler running.

For longer periods, unless the controls include a

frost thermostat, the system should be drained.

MAINTENANCE

IMPORTANT

In order to ensure safe and reliable operation of

Ideal Concord Super boilers it is essential that

regular maintenance be carried out by a competent

staff who have received instruction in maintenance,

fault nding and commissioning procedures for this

boiler series.

1. Towels etc., MUST NOT be draped over the

boiler case.

2. The user MUST ensure that the boiler-house is

maintained in a clean and tidy condition and that

NO loose items can fall onto the boiler.

The boiler should NOT be operated during the

course of building, painting, piping or lagging

work etc., in the boiler-house.

When such work is in progress, the modules

should be covered by means of clean dust

sheets.

3. The passage of combustion and ventilation air to

the boiler MUST NOT be restricted.

4. The boiler-house MUST NOT be used for

storage purchases.

5. Flammable materials MUST NOT be stored on

or near the boiler.

ESCAPE OF GAS

DO NOT search with a NAKED ame.

Should a gas leak be suspected, contact your local

gas region without delay.

Ideal is a trademark of Ideal Boilers.

Registered Oce

Ideal Boilers Ltd., PO Box 103, National Avenue, Kingston Upon Hull, HU5 4JN

Tel 01482 492251 Fax 01482 448858

Registration No. London 322 137

deal Technical Helpline: 01482 498376

www.idealcommercialboilers.com

Ideal Boilers Ltd. pursues a policy of continuing improvement in the design and performance of its products.

The right is therefore reserved to vary speciﬁcation without notice.

Inhaltsverzeichnis

Andere IDEAL Kessel Handbücher

IDEAL

IDEAL Imax Plus II F90 Benutzerhandbuch

IDEAL

IDEAL classic HE15P Benutzerhandbuch

IDEAL

IDEAL Vogue Combi c26 Bedienungsanleitung

IDEAL

IDEAL Systemiser SE Datenblatt

IDEAL

IDEAL Response SE Bedienungsanleitung

IDEAL

IDEAL IMAX XTRA EL Bedienungsanleitung

IDEAL

IDEAL imax W45 Datenblatt

IDEAL

IDEAL Viceroy GT Series Leitfaden

IDEAL

IDEAL IDEAL SPRINT RS 75 Bedienungsanleitung

IDEAL

IDEAL Evomax 30 Bedienungsanleitung

IDEAL

IDEAL he15 Bedienungsanleitung

IDEAL

IDEAL EVO S 50 Bedienungsanleitung

IDEAL

IDEAL classic HE15P Bedienungsanleitung

IDEAL

IDEAL Mexico Super RS440 Bedienungsanleitung

IDEAL

IDEAL INDEPENDENT COMBI 24 Bedienungsanleitung

IDEAL

IDEAL Europa 224 Bedienungsanleitung

IDEAL

IDEAL Evomax 30 Bedienungsanleitung

IDEAL

IDEAL Classic LXFF 230 Bedienungsanleitung

IDEAL

IDEAL Vanguard L Bedienungsanleitung

IDEAL

IDEAL istor HE325 Bedienungsanleitung

IDEAL

IDEAL IMAX XTRA EL 320 Bedienungsanleitung

IDEAL

IDEAL PRO Series Bedienungsanleitung

IDEAL

IDEAL 36 Bedienungsanleitung

IDEAL

IDEAL British Gas 100 RD2 Datenblatt

Beliebte Kessel Handbücher anderer Marken

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Bedienungsanleitung

Radijator

Radijator BIO max 23.1 Bedienungsanleitung

Brunner

Brunner BSV 20 Bedienungsanleitung

Buderus

Buderus Logamax GB062-24 KDE H V2 Bedienungsanleitung

Potterton

Potterton 50e Datenblatt

UTICA BOILERS

UTICA BOILERS TriFire Bedienungsanleitung

Joannes

Joannes LADY Series Handbuch

ECR International

ECR International UB90-125 Gebrauchsanweisung

Froling

Froling FHG Turbo 3000 Bedienungsanleitung

Froling

Froling P4 Pellet 8 - 105 Bedienungsanleitung

U.S. Boiler Company

U.S. Boiler Company K2 Bedienungsanleitung

Henrad

Henrad C95 FF Bedienungsanleitung

NeOvo

NeOvo EcoNox EF 36 Bedienungsanleitung

Potterton

Potterton PROMAX SL 12 Bedienungsanleitung

Eco Hometec

Eco Hometec EC 25 COMPACT Bedienungsanleitung

Viessmann

Viessmann VITODENS 200 Leitfaden

Baxi

Baxi Prime 1.24 Bedienungsanleitung

REXNOVA

REXNOVA ISA 20 BITHERMAL Bedienungsanleitung