IDEAL RF Electronic Bedienungsanleitung

RF ELECTRO-MECHANICAL TIMER

& RF ROOM THERMOSTAT

USER GUIDE

When replacing any part on this appliance, use only spare parts that you can be

assured conform to the safety and performance speciﬁcation that we require.

Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.

CONTENTS

The national regulations and respective safety instructions are to be observed.

Interferences and changes to the device will lead to cancellation of the warranty.

RF Electro-Mechanical Timer .................................4

RF Room Thermostat .............................................5

Room Temperature.................................................6

Setting the time.......................................................7

Timed/On/Off ..........................................................8

Setting the Central Heating On/Off Times ..............9

Fault Help ........................................................10,11

Battery Replacement............................................12

Suitable for the following products:

Logic+ Combi

Logic Combi

Logic Combi E

Logic Combi ES

Logic Code Combi

Logic Code Combi ES

RF Electro-Mechanical Timer

& RF Room Thermostat

Continuously OFF

Continuously ON

Room Stat

Signal

off

Timed

DO NOT Turn

Anti-Clockwise

RFT1

RT1

Set

ºC

23.5

RF Electro-Mechanical Boiler Mounted Timer

Continuously OFF

Continuously ON

Room Stat

Signal

Timed

DO NOT Turn

Anti-Clockwise

RFT1

off

Program

Tappets

Heat

Demand

RF Signal

Strength

Indication

On/Timed/Off

Switch

Actual

Time

Note. The heat demand indicator will be illuminated whenever both the timer and room

thermostat indicate that central heating is required.

Note. RF signal strength light illuminates green for good signal and red for a poor signal.

RT1

Frost

Protection

Operation Signal

Strength

Indication

Actual Temperature

(standard display)

(Set Temperature

shown when knob

rotated)

Temperature

Setting

Knob

Low

Battery

Indication

Note. If the low battery symbol is visible or the display is blank then replace the batteries.

Frost Protection Operation will occur if the Room Temperature is less than 5ºC.

Set

ºC

23.

Room Thermostat

RT1

Temperature

Setting

Knob

To set the Room Temperature, rotate the knob until the desired

temperature is shown on the display.

Set

ºC

23.

Room Temperature

Setting the Time

Continuously OFF

Continuously ON

Room Stat

Signal

Timed

DO NOT Turn

Anti-Clockwise

RFT1

off

Outer

Dial

Clock

Hands

The outer dial should be set to the current time.

Rotate the dial slowly in a clockwise direction, until the correct hour is aligned with the arrow printed on the dial.

Note that the outer dial is printed with 24 hour clock. 8.00 am = 8 on the dial. 8.00pm = 20 on the dial.

Clock hands will allow for fine adjustment of the current time setting of the dial.

Do not attempt to rotate the dial in an anti-clockwise direction.

Timed, Continuously On and Continuously Off Operation

Continuously OFF

Continuously ON

Room Stat

Signal

Timed

DO NOT Turn

Anti-Clockwise

RFT1

off

On/Timed/Off

Switch

To set the timer for Continuously On, Timed or Continuously Off

operation, slide the On/Timed/Off switch into the desired position.

Setting the Central Heating On/Off Times

Continuously OFF

Continuously ON

Room Stat

Signal

Timed

DO NOT Turn

Anti-Clockwise

RFT1

Tappets

set to

OFF period

Tappets

set to

ON period

Set Tappets to outer edge for ON periods

Set Tappets to inner edge for OFF periods

off

Fault Potential Corrective Actions

Central Heating will not

switch on

Check that the timer tappets are set to the outer edge of the dial.

Rotate the room thermostat knob until the set point is 30ºC.

Check that the power to the boiler is switched on.

Check that the “Mode” knob on the front of the boiler is in the winter

position.

Check that the link wire in the incoming mains connection to the boiler

is in place across the room stat connections (see boiler installation

instructions).

Check that the Timer On/Timed/Off switch is on (or the unit is timed on)

Stand next to the boiler holding the room thermostat for 5 mins. If the

central heating switches on then the room thermostat was either too far

away from the boiler or there were unsuitable materials between the

boiler and the room thermostat. Re-position room thermostat.

Change the batteries in the room thermostat.

Replace both the RF Timer and the RF Room Thermostat for a new pair.

Fault Help

Andere Handbücher für RF Electronic

Inhaltsverzeichnis

Andere IDEAL Thermostat Handbücher

IDEAL

IDEAL Halo Combi RF Bedienungsanleitung

IDEAL

IDEAL LOGIC COMBI Bedienungsanleitung

IDEAL

IDEAL Touch Bedienungsanleitung

IDEAL

IDEAL Halo Combi RF Bedienungsanleitung

IDEAL

IDEAL Vogue S15 Bedienungsanleitung

IDEAL

IDEAL Vogue Combi c26 Bedienungsanleitung

IDEAL

IDEAL Touch Bedienungsanleitung

IDEAL

IDEAL LOGIC+ Combi 24 Bedienungsanleitung

IDEAL

IDEAL Halo Combi Wi-Fi Bedienungsanleitung

IDEAL

IDEAL Touch Bedienungsanleitung

IDEAL

IDEAL Touch Bedienungsanleitung

IDEAL

IDEAL Touch Logic Combi C Bedienungsanleitung

IDEAL

IDEAL Touch Bedienungsanleitung

IDEAL

IDEAL Touch Logic Combi Bedienungsanleitung

IDEAL

IDEAL RF Electronic Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Honeywell

Honeywell T6811 Bedienungsanleitung