3.3 Open the accessory pack, take out expansion bolt,
expansion bolt nail into drilled holes inside;
3.4 Open the attachment pack, take out the screws; With this
screw will play good expansion bolt installation device fixed
to the surface (wall or ceiling);
3.5 Plug the external cables according to the use requirements
of equipment.
Picture 4 Equipment installation diagram(2)
3.6 Using tools to adjust screw loose device;
3.7 The up and down or so regulating equipment, according to
the use requirements set equipment of direction;
3.8 Using tools to screw locking device;
4.Network Operation
4.1 Use correct power supply
4.2 After startup, connect the device with switch or router,
see below picture
Picture 5 Network structure
4.3 Make sfault IPaddress is 192.168.1.10
4.4 Go to CD->English->Software to fnd UpgradeTool and
install it.
ure the device ip address is in the same LAN of router, de
4.5 Run UpgradeTool, Clock “IP Search”,you will fnd
the device ip,see below picture
Picture 6 IP Configure
4.6 Select the device to config IP, see below picture
Picture7 IP Configure
4. 7 Default IP setting:
IP address: 192.168.1.10
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
User name: admin
Password: no password
4.8 Open IE,type IPaddress.login with user name
and password,see below picture.
Picture 8 WEB GUI After login,enter into below picture
4.9 Login with user name and password,see below picture
Picture 9 Bit rate type
Picture10 WEB GUI after login
Equipment specific relevant parameter Settings please
refer to IP camera user manual in the CD“IPC Fast User
Manual.pdf”and“IP Camera user manual_Common
Version.pdf”.
5.SPECIFICATIONS
IPv4, HTTP, SSL, TCP/IP, UDP, UPnP, ICMP, IGMP,
SNMP, RTSP, RTP, SMTP, NTP, DHCP, DNS, PPPOE,
DDNS, FTP, IP Filter, QoS, Cloud
