IMMOOS SS1 oGB Bedienungsanleitung
Operating instructions
1-person evacuation system
for fixed and detachable ropeways
The 1-person evacuation system is compatible with the self-driven carriage Type SS1
mGB / Typ SS1 oGB / Typ SS1 Twin mGB / Typ SS2 mGB.
Corresponds to the today‘s valid, European harmonized CEN standards and the regulation
(EU) 2016/424 „cableway installation“ and is additionally certified as subsystem
GA_EN_1-Personen_Bergungssystem_Rev3; Datum: 07/2018
2
Table of Contents
1. Important Information 3
2. Presentation of the equipment (1-person evacuation system) 4
2.1 Self-driven carriage equipment 4
2.2 Equipment for the rescuer on the rope 5
2.3 Lowering equipment 6
3. Preparation of the evacuation 7
3.1 Equipment rescuer (on cable) 7
3.2 Preparation of the IMMOOS self-driven carriage Type SS1 8
3.3 Preparing the lowering equipment 10
4. Evacuation Procedure 11
4.1 Ascending to the tower 11
4.2 Preparations on Platform 12
4.3 Travelling with the Self-driven Carriage Type SS1, Sloping Rope 13
4.4 Travelling with the Self-driven Carriage Type SS1, Flat Rope 14
4.5 Stopping at the Grip of a Cable Car Vehicle or Pulley Array 16
4.6 Moving the Self-driven Carriage at the Grip of the Cable Car Vehicle 16
4.7 Taking the Self-driven Carriage o the Rope 16
4.8 Descending to the passenger in the carrier 17
4.9 Descending to the passenger on the chair lift 18
4.10 Prepare the passengers for lowering 19
4.11 Lowering the passengers 20
4.12 Abseil lowering in shuttle mode 21
4.13 Ascent of the Rescuer on the Rope 22
5. Cleaning and Lubricating 23
6. Storage 23
7. Inspection / Maintenance / Repair 24
8. Longevity 24
9. Disclaimer 25
10. Documentation of the Annual Expert Inspection 26
11. Documentation of roping work 27
3
1. Important Information
Ropeways with hydraulic promotion rope tensioning arrangement have to be switched o before beginning of the eva-
cuation, in order to prevent a moving of the rope by the tensioning arrangement. Evacuation work within the endanger-
ment range of the rope may take place only after the disconnection was operated.
These operating instructions manual does not describe the usage of singular devices, but rather the entire IMMOOS
Evacuation System for chairlifts and gondolas. These operating instructions must be studied and obeyed by the salvage
personnel. Read these carefully and keep you all product, guidances and information.
Activities at high altitudes are dangerous and can lead to serious and even fatal injuries. It is solely your responsibility to
learn the user and safety precautions. Only medically appropriate persons are allowed.
Each evacuation team requires 2 members. (Rescuer on cable and saver on ground)
Only instructed and trained personnel may carry out the rescuing of persons with the IMMOOS Evacuation System.
Watch at the dangers of pinching and confiscating between rope and reels (especially in loose clothing or long hair).
The owner of the ropeway system is solely responsible for the training of the evacuation personnel. Obligatory training
repetition provides confidence to the evacuation personnel.
Before usage all devices and units must be visually inspected to ensure that the material used is functioning and comple-
te. All materials are to be checked on an annual basis according to EN 365.
The recovery system must always be kept in faultless condition and must be ready for use at any time. After a rescue, if
questions arise regarding the condition or function, return the parts involved to IMMOOS GmbH for repair and inspec-
tion. Defective parts must always be replaced.
It is forbidden to alter or modify, either totally or partially, the system’s original state.
During evacuation operations, the safety of the evacuation team should always be observe. During all procedures, the
Rescuer (on cable) must secure himself with at least 1 hook to dependable points (ladders, rails, platforms, ropes, etc.).
The rope shortener should be used to reduce the falling height to a minimum.
The IMMOOS Evacuation System may only be used with originally tested ropes. Delivery is exclusive over IMMOOS
GmbH.
As the danger of rope brake and rope deflection device warming, protective hand gear should be worn at all times duri-
ng usage.
The annual expert inquiries and the roping work are sequential to document!
The fall arrest device must fit to the rope on the tower (certified)!
The system have to be used only for the evacuation. Other use (for example material transports, etc) is not permitted.
4
2.1 Self-driven carriage equipment
2. Presentation of the equipment (1-person evacuation system)
Self-driven carriage equipment
1. IMMOOS self-driven carriage Type SS1 with (optional) manual drive (crank) and element for
cordless drill
2. Safety line with rope shortener Grillon with carabiner
3. Line ladder with carabiner and material bag
5
2.2 Equipment for the rescuer on the rope
Equipment for the rescuer on the rope
5. Full body harness
6. Safety line with rope shortener Grillon, aluminimum safety hook, screw link, carabiner and
ascender from grabbing the rope with carabiner
7. Shock absorber with integrated energy absorber, aluminium safety hook, triangular quick link
with plastic stay and carabiner
8. Fall arrest device
9. Gloves and helmet
6
2.3 Lowering equipment
Lowering equipment
10. IMMOOS rope deflection with fixing loop, aluminium safety hook and screw link
11. Descending rope, ø 9 mm with carabiner with eye
12. Rope clamlp with carabiner (optional)
13. Evacuation harness or evacuation triangle
14. Rope brake with carabiner
19. Fixing loop with carabiner
20. Material bag with fixing loop and carabiner
7
The rope needs to have two safety knots, in a distance
from 0.5 m of the end to avoid that the rope glides
through the self-braking descender.
3. Preparation of the evacuation
The function from unlocking the child safety device and from the door release control have to be
clairfied at the meeting point.
Preparations are to be made at the meeting point.
3.1 Equipment rescuer (on cable)
Putting on and adjusting the full body harness.
Parts may only be attached to the eyelets marked
for this purpose.
Fasten the safety line with rope shortener Grillon
at the ventral eyelet (according to EN 813).
Fasten the fall arrest device and the shock absor-
ber with integrated energy absorber (if available)
at the sternal eyelet (according to EN 361).
Tighten the gloves and helmet.
8
3.2 Preparation of the IMMOOS self-driven carriage Type SS1
Before starting the recue, the rope diameter (hoist cable or towing rope) must be determined
and the device must be adjusted accordingly using the ball lock pin.
Ball lock pin with
T-handle for adjustment of
the rope diameter
9
The „Operating instructions IMMOOS self-driven carriage Type SS1“ (GA_EN_Seilfahrgerät_
Typ_SS1) is an integral part of this operating instruction.
safety line with rope
shortener
Line ladder
Material bag
Manual drive (crank)
Element for cord-
less drill
Self-driven carriage Type
SS1
Motor
10
3.3 Preparing the lowering equipment
The „Operating instructions descender and ascender device type Stopbloc 2“ (GA_EN_Ab-Aufseilvor-
richtung_Typ_Stopbloc2) constitute an integral component of these operating instructions.
If a shuttle operation is intended, the second evacuation harness resp. evacuation triangle and the associated rope
clamb must be prepared.
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere IMMOOS Sicherheitssensor Handbücher
