Impex MARCY MCB-346 Bedienungsanleitung

MARCY CLASSIC

MCB-346 COMBO BENCH

IMPEX®INC.

14777 Don Julian Rd., City of Industry, CA 91746

Tel: (800) 999-8899 Fax (626) 961-9966

www.impex-fitness.com

[email protected]

NOTE:

Please read all

instructions carefully

before using this product

Table of Contents

Safety Notice

Hardware Identifier

Assembly Instruction

Exploded Diagram

Parts List

Warranty

Ordering Parts

Model

MCB-346

Retain This

Manual for

Reference

06-29-06

OWNER'S

MANUAL

TABLE OF CONTENTS

BEFORE YOU BEGIN...............................................................................................1

IMPORTANT SAFETY NOTICE................................................................................2

HARDWARE PACK……............................................................................................4

ASSEMBLY INSTRUCTIONS....................................................................................5

EXPLODED DIAGRAM..............................................................................................10

PARTS LIST..........................................................................................................….11

WARRANTY..........................................................................................................….12

ORDERING PARTS...............................................................................................….12

BEFORE YOU BEGIN

Thank you for selecting the MARCY CLASSIC MCB-346 COMBO BENCH

by IMPEX®INC. For your safety and benefit, read this manual carefully

before using the machine. As a manufacturer, we are committed to

provide you complete customer satisfaction. If you have any questions,

or find there are missing or damaged parts, we guarantee you complete

satisfaction through direct assistance from our factory. To avoid

unnecessary delays, please call our TOLL-FREE customer service

number. Our Customer Service Agents will provide immediate

assistance to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire manual

before you assemble or operate your machine. In particular, note the following safety

precautions:

1. Keep children and pets away from the machine at all times. DO NOT

leave children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine

near water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear

robes or other clothing that could become caught in the machine. Running

or aerobic shoes are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO

NOT use attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or

physician in attendance.

10. Before using the machine to exercise, always do stretching exercises to

properly warm up.

11. Never operate the machine if the machine is not functioning properly.

12. A spotter is recommended during exercise.

13. Maximum user weight: 300 lbs.

14. Maximum weight capacity on the uprights: 200 lbs.

16. Maximum weight capacity on the leg developer: 100 lbs.

17. Maximum weight capacity on the lat bar: 100 lbs.

CARE AND MAINTENANCE

1. Lubricate moving parts with WD-40 or light oil periodically.

2. Inspect and tighten all parts before using the machine.

3. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.

DO NOT use solvents.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE

OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES

NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED

BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

WARNING LABEL REPLACEMENT

The Warning Label shown here has been placed on the Cross Brace. If the label is

missing or illegible, please call customer service at 1-800-999-8899 for replacement.

Apply the label in location shown. 3

HARDWARE PACK

ASSEMBLY INSTRUCTION

Tools required assembling the machine: Two Adjustable Wrenches and Allen

Wrenches

STEP 1 (SEE Diagram 1)

A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#15) in the Mid-span.

Secure them with two M10 x 2 3/8” Hex Bolts (#2), four ∅¾” Washers (#3), one

Bracket (#7), and two M10 Aircraft Nuts (#4) on each end of the Cross Brace.

B.) Insert the Backrest Adjustment Bar (#10) through a selected hole to obtain desired

incline of Backrest.

C.) Insert Right & Left Bar Catches (#13) & (#14) into the selected hole on the Rear Upright

Beams to obtain the desired height to hold the weight bar. DIAGRAM 1

STEP 2 (SEE DIAGRAM 2)

A.) Connect the Front Stabilizer (#42) to the Main Seat Support (#52) and secure them with

two M10 x ¾” Hex Bolts (#46), four ∅¾” Washers (#3), and two M10 Aircraft Nuts (#4).

DO NOT tighten the nuts and bolts yet.

B.) Connect the Main Seat Support (#52) to the open bracket on the Cross Brace (#15).

Secure it with two M10 x 2 3/8” Bolts (#2), four ∅¾” Washers (#3), and two M10

Aircraft Nuts (#4). DO NOT tighten the nuts and bolts yet.

C.) Connect one end of Diagonal Support (#43) to the Main Seat Support (#52). Secure it

with one M8 x 2 1/8” Hex Bolt (#48), two ∅5/8” Washers (#21) and one M8 Aircraft Nut

(#49). Connect the other end to the Front Stabilizer (#42). Secure it with one M8 x ¾”

Hex Bolt (#20) and ∅5/8” Washer (#21).

D.) Securely tighten all the nuts and bolts previously installed.

E.) Insert the Long L-shaped Lock Pin (#53) into the hole on the Main Seat Support (52).

NOTE: The Pin is not designed to sustain any heavy weight. Only use the pin when

changing the backrest board to a vertical position when doing Walk-in-Squat from the

rear.

STEP 3 (SEE DIAGRAM 3)

A.) Attach the Leg Developer (#38) to the bracket on the Front Stabilizer (#42). Secure it

with a Socket axle (#44) and Socket Screw (#45). Do not over tighten the Screw. Make

sure the Leg Developer is able to swivel.

B.) Insert two Foam Roll Tubes (#39) halfway through the holes on the Leg Developer.

Push four Foam Rolls (#37) onto the Tubes from both sided.

C.) Attach a Spring Clip (#34) onto the weight post on the Leg Developer.

D.) Attach the Arm Curl Handle (#54) to the bracket on the Leg Developer. Secure it with a

L-shaped Lock Pin (#8). DIAGRAM 3

STEP 4 (SEE DIAGRAM 4)

A.) Attach the Backrest Supports (#16) onto both ends of the Pivot on the Main Seat

Support (#52). Place the other end rest against the Backrest Adjustment Bar (#10).

B.) Place the Backrest Board (#18) onto the Backrest Supports. Secure it with four M6 x 1

3/8” Hex Bolts (#50) and ∅½” Washers (#51).

C.) Place the Seat (#19) onto the bracket on the Main Seat Support (#52). Align the holes

and secure the Seat with four M6 x 1 3/8” Hex Bolts (#50) and ∅½” Washers (#51).

D.) Attach the Arm Curl Pad (#23) to the Arm Curl Stand (#22). Secure it with two M8 x ¾”

Hex Bolts (#20) and Ø 5/8” Washers (#21).

E.) Insert the Arm Curl Stand into the opening on the top of the Front Stabilizer (#42). Use

a Lock Knob (#47) to secure it at desired height.

DIAGRAM 4

STEP 5 (SEE Diagram 5)

A.) Attach the ball end of the Cable to the Pulley (#28). Place the Pulley in the open slot on

the Lat Bar Frame (#31). Secure it with one M10 x 2 1/8” Hex Bolt (#32), two Bushings

(#29), two ∅¾” Washers (#3), and one M10 Aircraft Nut (#4).

B.) Slide the Weight Holder (#33) onto the Lat Bar Frame from the bottom. Connect the

Cable to the Holder with a Hook (#26). Attach a Spring Clip (#34) onto the post on the

Weight Holder.

D.) Connect the Lat Bar (#25) to the Cable with a Hook (#26). When using the Lat Pull

down, remove the Arm Curl and place it on the storage post behind the Rear Upright

Beam. Then insert the Lat Bar Frame into the opening on the Front Stabilizer.

Inhaltsverzeichnis

Andere Impex Heim-Fitnessstudio Handbücher

Impex

Impex Iron Grip Sport IGS-09 Bedienungsanleitung

Impex

Impex MARCY MWB-9000 Bedienungsanleitung

Impex

Impex EVERLAST EVE-1000 Bedienungsanleitung

Impex

Impex POWERHOUSE PHC 764 Bedienungsanleitung

Impex

Impex NS-1000 Bedienungsanleitung

Impex

Impex Powerhouse Club PHC 698 Bedienungsanleitung

Impex

Impex Gym Dandy TT-320 Bedienungsanleitung

Impex

Impex POWERHOUSE ELITE PHE 2000 Bedienungsanleitung

Impex

Impex MARCY DIAMOND ELITE MD-857 Bedienungsanleitung

Impex

Impex MCB-5700 Bedienungsanleitung

Impex

Impex POWERHOUSE CLUB PWR 6 Bedienungsanleitung

Impex

Impex SB 208 Bedienungsanleitung

Impex

Impex MARCY MWM-1100 Bedienungsanleitung

Impex

Impex SB 650W Bedienungsanleitung

Impex

Impex SA GEAR SAG-71 Bedienungsanleitung

Impex

Impex COMPETITOR CG 1400 Bedienungsanleitung

Impex

Impex MWB 715B Bedienungsanleitung

Impex

Impex Marcy MWM-4965SC Bedienungsanleitung

Impex

Impex MARCY DIAMOND ELITE MD-9010G Bedienungsanleitung

Impex

Impex MARCY MWM 1801 Bedienungsanleitung

Impex

Impex MD-739 Bedienungsanleitung

Impex

Impex COMPETITOR WM-354 Bedienungsanleitung

Impex

Impex POWERHOUSE PHC-700 Bedienungsanleitung

Impex

Impex MARCY MWM-1001 Bedienungsanleitung

Beliebte Heim-Fitnessstudio Handbücher anderer Marken

Horizon Fitness

Horizon Fitness OXFORD 6 Bedienungsanleitung

Energetics

Energetics Multi Trainer 5.1 Bedienungsanleitung

Matrix

Matrix MG-PL Series Bedienungsanleitung

Reebok

Reebok Tbr2i Bedienungs- und Wartungshandbuch

Weider

Weider 8300 Hard Drive Bedienungsanleitung

Pure Fitness

Pure Fitness 8526HE Bedienungsanleitung

Weider

Weider 8700 I Kurzanleitung

Bowflex

Bowflex Sport 001-6961 Bedienungsanleitung

NordicTrack

NordicTrack E8200 Competition Bench Kurzanleitung

Weider

Weider WEMC10161 Bedienungsanleitung

Body Solid

Body Solid GHYP-345 Bedienungsanleitung

Evo

Evo TAHOE 5105 Bedienungsanleitung

cardiobull

cardiobull RA17 Bedienungsanleitung

ParaBody

ParaBody 40 Bedienungsanleitung

JLL

JLL Ventus Pro Air Power Bedienungsanleitung

Trojan

Trojan Colorado 370 Bedienungsanleitung

Octane Fitness

Octane Fitness xRide xR650 Bedienungsanleitung

Precor

Precor Discovery Series Bedienungsanleitung