InSinkErator Model LC-50 Bedienungsanleitung

Part No. 13693 - January 2008

LC-50 FOOD WASTE DISPOSER

Installation Manual

www.insinkerator.com

Please be certain that the person who installs or uses this appliance carefully reads

and understands the Safety Instructions contained in this manual.

The Warning signal alerts you to potential hazards or unsafe practices which,

if not avoided, could result in severe personal injury or death.

The Caution signal alerts you to hazards of unsafe practices which, if not avoided,

may result in minor personal injury or property damage.

The Danger signal indicates an immediately hazardous situation which, if not

avoided, will result in death or serious injury.

Table of Contents

Introduction

Clean the Drain Line ....................................................................... 3

Required Tools/Materials ................................................................ 3

In This Package ............................................................................................ 3

Typical Installation ........................................................................................ 4

Installation with Wall Switch ........................................................... 4

Installation with Remote Air Switch ................................................ 4

Removing Existing Disposer ................................................................... 5-6

Installing the Disposer ............................................................................. 6-7

Electrical Connections ................................................................................. 8

Final Installation ........................................................................................... 9

Operating Instructions

Operating the Disposer ................................................................ 10

Do's and Dont's ........................................................................... 10

Operating Instructions .................................................................. 11

Troubleshooting

Troubleshooting ............................................................................ 12

For Dishwasher or Direct Water Connection ................................ 13

Warranty

FOODSERVICE DISPOSER LIMITED WARRANTY

The InSinkErator®LC-50 Foodservice disposer is warranted against defects in material and workmanship for one

year from the date of installation. The warranty includes parts and labor, provided the service is performed by an

InSinkErator Factory Authorized Service Center. This warranty does not apply if failure is due to: faulty or improper

electrical installation, faulty or improper plumbing installation, product abuse or misuse, accidental damage, grinding

elements jammed by foreign objects, clogged drain lines, or an improperly sized unit (as speciﬁed by InSinkErator).

InSinkErator Foodservice disposer accessories are included in this warranty only if they are included in the original

disposer purchase package.

Introduction

In This Package

REQUIRED TOOLS/MATERIALS

The following items are needed to install the disposer:

• Screwdriver

• Pipe wrench

• Hammer

The following items may be needed to install the disposer:

• Plumbing putty

• On/Off electrical switch (1/2 HP, 20A DP)

• Hacksaw

• Drain auger or rod

• Connector kit (Part #8301)

• Solenoid valve (Part #14495)

• Siphon breaker (Part #11477)

• Flow-control valve (Part #13763A)

Stopper

Sink Flange Rubber Gasket

Fiber Gasket

Metal Flange

Backup Ring

Mounting Ring

Screws

Screw

Snap Ring

Discharge Tube

Lower Mounting Ring

Mounting AssemblyDisposer Discharge Tube Assembl

Dishwasher Inlet

Tailpipe Mount

Wrenchette

The model LC-50 food waste disposer is designed

speciﬁcally for light foodservice use in applications

such as:

• Grocery/convenience stores

• Ofﬁce/church kitchens

• Fast food restaurants

• Bed and breakfast inns

Important – These installation instructions are for the

beneﬁt of the installing contractor. InSinkErator and/or

InSinkErator Factory Authorized Service Centers do not

make original installations. For technical information not

covered in these instructions, contact the supplier, an

InSinkErator Field Sales Representative, or InSinkErator

Foodservice Sales and Service at 1-800-845-8345.

CLEAN THE DRAIN LINE

With a drain line auger, clear away all hardened waste

material in the horizontal drain pipe running from the

drain trap to the main waste line.

Wall Switch

Electric Supply

Push Button

Syphon Breaker

Solenoid Valve

Water Shutoff Valve

Cold Water

Supply

Electrical

Junction Box

Air Hose

Air Switch

Power Junction

OPTIONAL

DIRECT WATER

CONNECTION

Dimension A B* C* D E

Inches 14-9/16 6-13/16 4 8 5-3/4

Cm 37.0 17.3 10.2 20.3 14.6

B* – Distance from bottom of sink to center line of disposer outlet.

Add 1/2" (13mm) when stainless steel sinks are used.

C* – Length of discharge tube from center line of disposer outlet to

end of discharge tube.

Important – Plumb waste line to prevent standing water in

disposer motor housing.

Typical Installation

INSTALLATION WITH WALL SWITCH INSTALLATION WITH REMOTE AIR

SWITCH AND OPTIONAL DIRECT

WATER CONNECTION

Disconnect drain trap from waste discharge tube.

Disconnect dishwasher or direct water connection if

connected to the disposer.

Support disposer, insert end of wrenchette into right

side of mounting lug, and turn. Disposer will fall free.

With the electrical supply turned off, ﬂip disposer

over and remove electrical cover plate. Save cable

connector if applicable.

With the electrical supply turned off, disconnect the

disposer wires from the electrical supply.

Removing Existing Disposer

If there is no existing disposer, disconnect sink drain and skip to step 9.

FALLING HAZARD

Do not position your head or body under the

disposer. It could fall during installation.

ELECTRICAL SHOCK

Disconnect power before installing or servicing unit.

Test the circuit with a voltmeter or circuit tester to

ensure the power is off.

Loosen the 3 screws on the mounting assembly. Using a screwdriver, remove the snap ring.

Removing Existing Disposer

Evenly apply 1/2" thick rope of plumber’s putty around

new ﬂange.

Press ﬂange ﬁrmly into sink drain. Remove excess putty.

Remove ﬂange from sink. Remove old plumber’s putty from sink with putty knife.

Installing the Disposer

Sink Flange

If the new disposer mounting is the same as the old one, you can go to step 14.

Installing the Disposer

Tighten screws evenly and ﬁrmly against backup ﬂange.

Use shorter 1-1/8" screws if sink is more than 3/8"thick.

Turn disposer onto side and insert screwdriver into

dishwasher inlet.

Knock out drain plug and remove plug from inside

of disposer.

> 3/8"

1-1/8"

< 3/8"

1-1/2"

Insert ﬁber gasket, backup ring and mounting ring. Hold

in place while inserting snap ring.

Place a weight such as the disposer on the sink ﬂange

to hold it in place. Use a towel to prevent scratching

sink. Pull snap ring open and press ﬁrmly until it snaps

into place.

OPTIONAL: DISHWASHER OR DIRECT WATER CONNECTION ONLY

If you do not need to attach the dishwasher or direction water connection, go to step 16.

Fiber Gasket

Backup Ring

Mounting Ring

Optional

Electrical Connections

Push wires into disposer (do not displace cardboard

shield) and replace electrical cover plate.

Connect white to white and black to black or red

with wire nuts (not included); ground wire to green

grounding screw. Unit must be grounded for safe and

proper installation.

Turn disposer over and remove electrical cover plate.

Pull out wires. DO NOT REMOVE CARDBOARD SHIELD.

With electrical supply turned off, insert cable connector

(not included) and run electrical cable through access

hole on bottom of disposer. Tighten cable connector.

ELECTRICAL SHOCK

• Disconnect power before installing or servicing

unit. Test the circuit with a voltmeter or circuit

tester to ensure the power is off.

• Use only a properly grounded and polarized

electric outlet.

• Improper connection of the equipment-grounding

conductor can result in a risk of electric shock.

• Installation must conform to all local

electrical codes.

• All control centers and disposers must

be grounded.

PERSONAL INJURY/PROPERTY DAMAGE

If the electrical installer is not experienced in

electrical installation, we recommend seeking

competent professional assistance. Disposer or

accessory damage due to improper installation is

not covered under warranty. All installations must

comply with local electrical codes.

Final Installation

Hang disposer by aligning 3 mounting tabs with

slide-up ramps on mounting ring.

Turn mounting ring until all 3 mounting tabs lock over

the ridges on the slide-up ramps.

You may need to trim tube for proper ﬁt. Reconnect

plumbing (and dishwasher or direct water connection if

used). Make sure tailpipe mount is straight.

Insert stopper into sink opening. Fill sink with water,

then test for leaks.

Rotate the disposer around. Place the rubber gasket

on the end of the discharge tube and slide on the metal

ﬂange from the reverse end. Place assembled discharge

tube in the tailpipe mount opening and secure with

screw provided.

Discharge Tube

Rubber Gasket

Screw

Metal Flange

DO'S AND DON'TS

DO …

• First turn on a moderate to strong ﬂow of cold water

and then turn on the disposer. Continue running cold

water for a few seconds after grinding is completed

to ﬂush the drain line.

• Grind hard materials such as small bones, fruit pits,

and ice. A scouring action is created by the particles

inside the grind chamber.

• Grind peelings from citrus fruits to freshen up

drain smells.

Important – The model LC-50 is designed speciﬁcally for light commercial use. Examples of these applications

include: grocery/convenience store delis, fast food restaurants, ofﬁce/church kitchens, and bed and breakfast inns.

Use of this disposer in applications other than those named above may void your warranty.

• Use a disposer cleaner, degreaser, or deodorizer as

necessary to relieve objectionable odors caused by

grease build-up.

OPERATING THE DISPOSER

1. Remove stopper from sink opening and run strong flow of cold water.

2. Turn on wall switch to start disposer.

3. Slowly insert food waste into disposer and position stopper to minimize possible ejection of material while

grinding. After grinding is complete, turn disposer off and run water for a few seconds to flush drain line.

DON'T …

• Don't pour grease or fat down your disposer or any

drain. It can build up in pipes and cause drain

blockages. Put grease in a jar or can and dispose in

the trash.

• Don't use hot water when grinding food waste. It

is OK to drain hot water into the disposer between

grinding periods.

• Don't ﬁll disposer with a lot of vegetable peels all at

once. Instead, turn the water and disposer on ﬁrst

and then feed the peels in gradually.

• Don't grind large amounts of egg shells or ﬁbrous

materials like corn husks, artichokes, etc., to avoid

possible drain blockage.

• Don't turn off disposer until grinding is completed and

only sound of motor and water is heard.

Operating Instructions

Andere Handbücher für Model LC-50

Inhaltsverzeichnis

Andere InSinkErator Müllentsorgung Handbücher

InSinkErator

InSinkErator PowerRinse PRP Series Installationshandbuch

InSinkErator

InSinkErator AnswerLine EVOLUTION SEPTIC ASSIST Bedienungsanleitung

InSinkErator

InSinkErator Evolution CoverControl Plus Bedienungsanleitung

InSinkErator

InSinkErator Model LC-50 Bedienungsanleitung

InSinkErator

InSinkErator Evolution Pro Cover Control Plus Bedienungsanleitung

InSinkErator

InSinkErator Badger 1 Bedienungsanleitung

InSinkErator

InSinkErator Evolution PRO 750 Bedienungsanleitung

InSinkErator

InSinkErator EVOLUTION COVER CONTROL Bedienungsanleitung

InSinkErator

InSinkErator Model SS-200 Bedienungsanleitung

InSinkErator

InSinkErator WASTEXPRESS 14481 Bedienungsanleitung

InSinkErator

InSinkErator Badger 100 Bedienungsanleitung

InSinkErator

InSinkErator Evolution Compact Leitfaden

InSinkErator

InSinkErator Evolution Excel Leitfaden

InSinkErator

InSinkErator SS100-28 Bedienungsanleitung

InSinkErator

InSinkErator Badger 1 Installationshandbuch

InSinkErator

InSinkErator PRO 880 Bedienungsanleitung

InSinkErator

InSinkErator Badger 5 Bedienungsanleitung

InSinkErator

InSinkErator Evolution Essential Bedienungsanleitung

InSinkErator

InSinkErator Model SS-1000 Bedienungsanleitung

InSinkErator

InSinkErator Evolution Series Bedienungsanleitung

InSinkErator

InSinkErator Evolution Essential Bedienungsanleitung

InSinkErator

InSinkErator LC50-13 Leitfaden

InSinkErator

InSinkErator 13954 Gebrauchsanweisung

InSinkErator

InSinkErator PRO 750 Bedienungsanleitung

Beliebte Müllentsorgung Handbücher anderer Marken

Insinger

Insinger I-6 Bedienungsanleitung

Franke

Franke CE-50 Betriebsanleitung

Leafield Environmental

Leafield Environmental Envirobank 140 Merkblatt

Meiko

Meiko TopCut B Bedienungsanleitung

KitchenAid

KitchenAid KCDB250G2 Bedienungsanleitung

Gladiator

Gladiator Garage Compactor Bedienungsanleitung

Maytag

Maytag DFC1500 Installationshandbuch

Weber mt

Weber mt CR 7 Betriebsanleitung

THERMEx

THERMEx WASTEMINATOR II Bedienungsanleitung

Weber mt

Weber mt CR 7-II Hd Betriebsanleitung

ROBINHOOD

ROBINHOOD SE390 Bedienungsanleitung

Whirlpool

Whirlpool GC2000PE2 Bedienungsanleitung

Scheppach

Scheppach HP3000S Montageanleitung

Haigh

Haigh Quattro Vanguard Original Bedienungsanleitung

Maxmatic

Maxmatic 5000 Technisches Datenblatt

Toro

Toro FP-2200 Bedienungsanleitung

Elephants Foot

Elephants Foot eDiverter Bedienungsanleitung

Zanussi

Zanussi DU 4400 Bedienungsanleitung