Intel ISP1100 - Server Platform - 0 MB RAM Bedienungsanleitung

SCSI Cable Option Kit

Installation Guide for

Intel®ISP1100 Internet Server

The most current version of this document and other documents relating to the

Intel®ISP1100 Internet Server can be found at http://www.intel.com/isp.

may be copied, or reproduced in any form, or by any means without prior written

consent of Intel.

Intel Corporation (Intel) makes no warranty of any kind with regard to this material,

including, but not limited to, the implied warranties of merchantability and fitness for a

particular purpose. Intel assumes no responsibility for any errors that may appear in

this document. Intel makes no commitment to update nor to keep current the informa-

tion contained in this document.

† Third-party brands and trademarks are the property of their respective owners.

February 29, 2000

Revision 1.0

Document Number:A16589-001

Intel ISP1100 Internet Server SCSI Cable Kit 1

Introduction

This document explains how to install the SCSI cable kit, which is used with third-

party SCSI adapters in the Intel ISP1100 Internet Server. It assumes the system is

configured for IDE and contains either a 3.5” floppy drive or a slimline CD-ROM/

floppy drive assembly. Please ignore steps that do not apply to your system.

Note: You cannot mixIDEand SCSIharddrives insidetheserver. Theharddrives

mustbethe sametype.

Before you begin:

1. Make sure you have one (1) pre-folded SCSI cable.

2. Make sure you have the following tools:

• A phillips (cross-head) screwdriver, number 2 bit

• An antistatic wrist strap and conductive foam pad (recommended)

3. Read the safety and warnings information in the Intel®ISP1100 Internet Server

Quick Start Guide.

4. Make sure the server is turned off and is not plugged in to an electrical

outlet.

Intel ISP1100 Internet Server SCSI Cable Kit2

Open the Server Cover

1. Remove the screw (A) from the cover.

2. Slide the cover back and out from under the edge of the server’s front panel.

3. When the cover is free of the front panel, use the notch (B) in the cover to lift the

cover off the chassis.

OM09745

Intel ISP1100 Internet Server SCSI Cable Kit 3

Remove the Riser Card and Add-in Card(s)

1. Remove the two screws (A) from the retention bracket (B), and remove

the retention bracket.

2. Grasp the riser card at each end (C) and gently rock and lift until the

riser releases from the server board connector.

OM09772

Intel ISP1100 Internet Server SCSI Cable Kit

Install the SCSI Card

1. Plug the SCSI card (A) in the left slot (B) of the riser card (C).

OMO9778

2. Set the riser assembly aside for now.

Intel ISP1100 Internet Server SCSI Cable Kit

Remove the IDE Hard Drive(s) from the Server

For each hard drive:

1. Lift the back of the drive until the drive mounting bracket (A) releases from the

two snaptop standoffs (B).

2. Slide the drive back until the mounting bracket tabs are free of the slots (C) in the

server front panel, then lift the drive above the chassis.

3. When the drive is clear of the chassis, disconnect the power (D) and

data cables (E) from the back of the drive.

OM09764

Intel ISP1100 Internet Server SCSI Cable Kit6

Remove the IDE Hard Drive(s) from the Bracket(s)

For each IDE hard drive:

1. Remove the four screws (A) that attach the mounting bracket (B) to the drive.

There are two screws on each side.

2. Lift the drive from the mounting bracket.

OM09765

Intel ISP1100 Internet Server SCSI Cable Kit 7

Install the SCSI Hard Drive(s) in the Bracket(s)

For each SCSI hard drive:

1. Configure the SCSI ID for the drive according to the manufacturer’s guide.

2. Place the drive in the mounting bracket. Orient it with the component side down,

and the front of the drive facing the front of the mounting bracket (A).

3. Align the mounting bracket screw holes (B) with the matching holes (C) in the

drive housing.

4. Fasten the mounting bracket to the drive using the four screws (D) that were

holding the IDE drive in the bracket.

Note: Do not overtightenthescrews. Thebracketsides canbendinward, which

canaffectthealignment ofthe brackettabs withthe slotsin thechassis.

OM09766

Intel ISP1100 Internet Server SCSI Cable Kit

Remove the 3.5 Floppy Drive

You must remove the 3.5” floppy drive so you can route the SCSI cable underneath it.

You will reinstall the drive in a later step.

1. Remove the three screws (A) that hold the drive in the chassis.

2. Lift the back of the drive at an angle and disconnect the power (B) and data

cables (C).

3. Remove the drive from the bay and set it aside.

OMO9771

Andere Handbücher für ISP1100 - Server Platform - 0 MB RAM

Andere Intel Server Handbücher

Intel

Intel SR1625UR - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel SBX44 - Server Compute Blade Bedienungsanleitung

Intel

Intel H2000G Series Bedienungsanleitung

Intel

Intel M50FCP2UR Bedienungsanleitung

Intel

Intel SR870BH2 - Server Platform - 0 MB RAM Bedienungsanleitung

Intel

Intel SR1530AHLX - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel NSC2U - IP Network Server Bedienungsanleitung

Intel

Intel MFSYS25 - AXXPSU 1000W Power Supply Module Bedienungsanleitung

Intel

Intel R2000WF series Bedienungsanleitung

Intel

Intel SC5650HCBRP Einrichtungshandbuch

Intel

Intel IP Network server NSI2U Bedienungsanleitung

Intel

Intel SBXD132 - Server Compute Blade Bedienungsanleitung

Intel

Intel R1304BTLSFAN Einrichtungshandbuch

Intel

Intel ISP1100 - Server Platform - 0 MB RAM Bedienungsanleitung

Intel

Intel SR2600UR - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel ASR1500PASBP Bedienungsanleitung

Intel

Intel SBX82 - Server Compute Blade Bedienungsanleitung

Intel

Intel MFSYS25 - AXXPSU 1000W Power Supply Module Bedienungsanleitung

Intel

Intel MFSYS25 - AXXPSU 1000W Power Supply Module Bedienungsanleitung

Intel

Intel SR9000MK4U - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel MFSYS25V2 Bedienungsanleitung

Intel

Intel SR870BH2 - Server Platform - 0 MB RAM Bedienungsanleitung

Intel

Intel SC5650BCDP Konfigurationshandbuch

Intel

Intel R2000WT Kurzanleitung zur Einrichtung

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

Dell

Dell PowerEdge R410 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

MSI

MSI P1-109N-L70 Bedienungsanleitung

Dell

Dell PowerEdge XE9640 Handbuch

Dell

Dell PS4100 Montageanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

NEC

NEC Express5800/T110j Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

Dell

Dell PowerEdge 3YPMN Bedienungsanleitung

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung