Intellinet 550857 Bedienungsanleitung

NSC18-WN

Pa N / TilT

NeTWork

Camera

quiCk

iNSTall

guide

MODEL

550857

INT-550857-QIG-0709-01

iNTroduCTioN

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS

™

NSC18-WN Pan/Tilt Network Camera, Model 550857.

This quick install guide presents the rudimentary steps required to set

up and operate this device. For software installation procedures, detailed

instructions and specications, refer to the user manual 1) on the CD

enclosed with this product; 2) on the Web site listed below; or 3) in some

cases, printed and enclosed with this product. Contact your INTELLINET

NETWORK SOLUTIONS dealer with comments or questions, or visit

www.intellinet-network.com for information on the latest software and

rmware updates, related products and additional contact information.

Some screen images have been modied to t the format of this guide.

System Requirements

• Windows 2000, XP, Vista

• Computer with network connection

• Web browser support: MS Internet Explorer 6.0 or higher (ActiveX)

Package Contents

• NSC18-WN Pan/Tilt Network Camera

• 2 detachable antennas

• Power adapter

• Quick installation guide

• Software CD with user manual

• Ethernet Cat5 RJ45 cable: 1.0 m (3 ft.)

NOTE: Video and audio surveillance can be forbidden by laws that vary

from country to country. Check the laws where you install this device

before using it for surveillance purposes.

regulaTory STaTemeNTS

EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE

Directive 1999/5/EC. This device is a 2.4 GHz wideband transmission

system (transceiver) intended for use in all EU member states and EFTA

countries, except in France and Italy, where restrictive use applies.

In Italy, the end-user should apply for a license at the national spectrum

authorities in order to obtain authorization to use the device for setting up

outdoor radio links and/or for supplying public access to telecommunications

and/or network services.

This device may not be used for setting up outdoor radio links in France,

and in some areas the RF output power may be limited to 10 mW EIRP

in the frequency range of 2454 – 2483.5 MHz. For detailed information,

the end-user should contact the national spectrum authority in France.

Federal Communications Commission Interference Statement

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: 1) This device may not cause harmful

interference, and 2) This device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution

Any changes or modications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

this equipment.

IEEE 802.11b or 802.11g operation of this product in the U.S. is rmware-

limited to channels 1 through 11.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and

operated with a minimum distance of 20 cm (approximately 8 in.) between

the radiator and your body. This transmitter must not be co-located or

operated in conjunction with any other antenna or transmitter.

SafeTy PreCauTioNS

This product has been designed with safety in mind, but as electrical

products can cause res which may lead to serious damage and injury

if not used properly, observe these precautions:

• Don’t open the camera housing or otherwise expose yourself to

dangerous voltage or other hazards inside.

• Don’t attach/connect accessories that aren’t designed for this device.

• Avoid operating or storing the camera in extreme temperatures (see

Specications in the user manual).

• Avoid exposing the camera to direct sunlight for a long time.

• Don’t place the camera near heat sources.

• Don’t place the camera near water (e.g., next to a bathtub or sink) or

in an extremely hot or humid environment.

• Don’t place the camera near sources of strong magnetism.

• Don’t place the camera near sources of powerful electromagnetic

radiation, such as radios or TV transmitters.

• Don’t place the camera in locations subject to strong vibration or

shock.

Focus

adjustment

ring

Wireless

antenna

(1 of 2)

LEDs

Built-in

mic

hardWare

Front and Side

Wireless Antenna(s) –

Connects the camera to

the wireless network.

Focus Adjustment Ring –

For manually setting

the best image quality.

Built-in Microphone –

For two-way audio.

Power LED – Lights after

the camera completes

the booting process.

Audio LED – Lights when

Audio is enabled;

ashes if active.

LAN LED – Lights

when the LAN

port is in use;

ashes during

data transfers.

WLAN LED – Lights when the wireless LAN

port is in use; ashes during data transfers;

ashes once per second when waiting for

a WPS connection from an access point.

Reset – For reverting to the factory default

settings. Use a straight pin, paper clip or

other pointed object to press and hold this

recessed button in (on the camera base’s

right side, as shown at right) for 5 seconds.

Tripod Ring – For securing the camera to a

tripod or wall/ceiling mount. This twist ring

is on the underside of the camera base.

Back / Connections

1. Connect one end of the included Ethernet cable (or a similar one) to

your local area network and the other end to the LAN port. NOTE: You

can skip this step if you plan to use a wireless LAN only.

2. Plug the included

power adapter into

an A/C outlet and

connect it to the

12VDC power jack.

3. Attach the two

included antennas to the connectors (shown already attached above).

4. As needed, refer to the user manual for the WPS button and connections

to the SD card slot and Audio Out jack.

5. Position the camera in a secure location and aim it as desired.

SofTWare

Installation

1. With your computer on, insert the included software CD in the CD-ROM

drive. The Welcome to Internet Camera Install Wizard screen will

display automatically. NOTE: If the wizard doesn’t display, double-click

the CD/DVD drive icon or double-click “autorun.exe” on the CD.

2. Click “Install

Administrator

Utility” to

continue with

the installation

procedure.

3. When the Welcome

to the IPCam Admin

Utility Setup Wizard

screen displays,

click “Next.”

4. When the Select

Destination Location

screen displays,

click “Next” to

continue or click

“Browse” to select

another folder or

drive to install the

admin utility.

5. When the Select

Additional Tasks

screen displays,

click “Next” to

continue. If you

prefer, deselect the

“Create a desktop

icon” and “Create a

Quick Launch icon”

options, which are

both selected by

default.

6. When the Ready to

Install screen

displays, click

“Install.”

7. When the Completing

the IPCam Admin

Utility Setup Wizard

screen displays,

click “Finish” to

complete the install.

NOTE: The “Launch

IPCam Admin Utility”

option should be

selected by default.

Admin Utility

1. The admin utility will automatically search for all cameras available on

your local network.

To update the list,

click on the Search

Camera icon in the

lower-left corner of

the screen (shown

at right).

2. When a camera is found and listed (as shown above), highlight it to

select it, then click on the Browse Camera via Web icon (the middle of

the three icons in the lower-left corner of the screen). This will launch

your Web browser so you can connect to the camera. NOTE: If the

camera selected in the list on the above screen is presented with an

IP address (as shown), proceed to Step 6. If the IP Address listing of

the camera is “0.0.0.0,” however, click the Congure Camera icon (the

right-hand icon among the three) and proceed with Step 3.

3. When the Login screen displays

after the Congure Camera icon

is clicked, ll in the “Password”

eld (the default password is

“1234”) and click “OK” to display

the LAN Setting conguration

screen. The default username,

“admin,” cannot be changed

here.

Andere Handbücher für 550857

Inhaltsverzeichnis

Andere Intellinet Sicherheitskamera Handbücher

Intellinet

Intellinet IBC-607IR Bedienungsanleitung

Intellinet

Intellinet 550857 Bedienungsanleitung

Intellinet

Intellinet BGC-2010S Series Bedienungsanleitung

Intellinet

Intellinet IDC-757IR Handbuch

Intellinet

Intellinet 550260 Bedienungsanleitung

Intellinet

Intellinet NSC11-WN Bedienungsanleitung

Intellinet

Intellinet NSC10-WG 550918 Bedienungsanleitung

Intellinet

Intellinet 550413 Bedienungsanleitung

Intellinet

Intellinet NSC15 Bedienungsanleitung

Intellinet

Intellinet NSC10 Bedienungsanleitung

Intellinet

Intellinet NSC15-WG Bedienungsanleitung

Intellinet

Intellinet 503792 Bedienungsanleitung

Intellinet

Intellinet NFC31-WG Bedienungsanleitung

Intellinet

Intellinet 503181 Bedienungsanleitung

Intellinet

Intellinet 550260 Bedienungsanleitung

Intellinet

Intellinet NFD130-IR Bedienungsanleitung

Intellinet

Intellinet IBC-667IR Handbuch

Intellinet

Intellinet NSC15 Bedienungsanleitung

Intellinet

Intellinet 550437 Bedienungsanleitung

Intellinet

Intellinet NSC15-WG Bedienungsanleitung

Intellinet

Intellinet NFC30-IRWG Bedienungsanleitung

Intellinet

Intellinet IBC-637IR Betriebsanleitung

Intellinet

Intellinet NSC10-WG 550918 Bedienungsanleitung

Intellinet

Intellinet PRO SERIES Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung

Lumens

Lumens VC-A50PNW Bedienungsanleitung