IPC CT110 Bedienungsanleitung

CT110 Quick guide

This guide is intended for quick consultation only and does not replace the user and maintenance manual.

Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the

instructions.

PREPARATION & OPERATION

1 2

PLDC01850

CHEM

H2O

O

SELECT

O

SELECTSELECT

O

SELECTSELECT

O

SELECT

O

SELECT

O

SELECT

O

SELECT

STANDARD AUTOMATIC

ECONOMY

REPLACING THE SQUEEGEE BLADES

ATTACHING/REMOVING THE BRUSHES

Open the clip (Ref. 1).

Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.

Remove the blade.

Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the

screws on the body of the squeegee.

Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing

devices inwards.

Close the hook again.

Attaching the brushes: THIS MUST BE DONE WITH THE MACHINE OFF, remove the side aps, then position the brushes under the head drive disk. Lift the right brush with your hands and turn it clockwise, locking it in

position on the drive disk. Lift the left brush with your hands and turn it anticlockwise, locking it in position on the drive disk.

Removing the brushes: THIS MUST BE DONE WITH THE MACHINE OFF, turn the right brush anticlockwise to release it from the drive disk. Turn the left brush clockwise to release it from the drive disk.

DAILY MAINTENANCE

Clean the dirty

water tank.

Check the suction lter is

undamaged and clean.

Check that the

detergent outlet lter

is clean.

Check that the

brushes are clean.

Check that the

squeegee is clean