The following important notes must be followed carefully to run the camera and respective
accessories in total safety. The camera and relative accessories are called video system in this
section.
Before installing the camera, please read this manual carefully. Please follow instructions of
installation indicated in this manual during installation. Please keep this manual for future use.
Before powering on the camera, please check the power voltage carefully.
Please put the power cable, video cable and control cable in safe place.
Do not operate the camera beyond the specified temperature and humidity. The camera working
temperature range is between 0℃and +50℃. The ambient humidity range is less than 95﹪.
Avoid violent shake or force to the camera during transportation.
Do not remove screws or covers of the camera to prevent electric shock. There are no
self-serviceable parts inside. Refer to qualified service personnel for servicing.
Video cable and RS485 cable should be far away from other cables.
Never aim the lens of the camera at the sun or other extremely bright objects. Otherwise, it may
cause damage.
Use soft cloth to clean the camera. If the camera is very dirty, wipe it off gently with a soft cloth
moistened with a weak solution of water and a neutral kitchen detergent. Wring all liquid from the
cloth before wiping the camera, then wipe off all remaining dirt with a soft, dry cloth. Use lens
cleaning paper to clean the lens.
The following installation should be performed by qualified service personnel or system installers
in accordance with all local rules.
Do not move the camera head manually. Otherwise, malfunction of the camera may occur.
Do not hold the camera head when carrying the video camera.
Put the camera in inclined place may cause malfunction and it will shorten the life of the camera.
This camera is for indoor use only. It is not designed for outdoor use.
Make sure the camera is not directly exposed to rain and water
Make sure the camera is far away from area where radiation, X-rays, strong electric waves, or
magnetism is generated
The total weight of the camera is less than 1.5kg, in order to be safe, it needs to be installed or
connected on materials that are 5 times the weight of the camera.
