Thank you for choosing this product from JessEm
Tool Company. We appreciate your support and
hope that our product serves you well. This product
is designed to provide many years of reliable service
provided it is used as intended and taken care of.
This user manual will assist you in assembly and
general operaon of this product. It is not our intent
to teach you about woodworking. It is assumed that
you are an experienced woodworker with the basic
skills and experience necessary to use this product
safely. If aer reading the following instrucons you
are unsure or uncomfortable about safely using this
product, we urge you to seek addional informaon
through widely available woodworking books or
classes.
As part of our Connuous Product Improvement
Policy, JessEm products are always advancing in
design and funcon. Therefore, there may be
dierences between what is shown in our catalogs,
website or at retail display and what is sold at me
of purchase. We reserve the right to make posive
changes to our products at our discreon.
Assembly Instrucons
1. Place two legs (part #5) on a at surface with the
castor holes facing out on either side (see Figure #3)
and the leveling feet closest to you. Take the front
lower brace (Part #8) and align it with the
corresponding holes as seen in gure #3, ensuring the
ange is oriented correctly. Using four ¼” Washers
and four ¼”-20 x 3/8” Stainless steel Cap Screws (parts
#2 and #4), loosely aach this brace to both legs. Do
not fully ghten the screws at this point. All screws
will be le loose unl the enre stand is built.
Repeat this procedure to mount an upper brace to
both legs (part #3), using the same mounng
hardware as before. At this point you should have one
side assembled, as seen in gure #3.
2. Take the two remaining legs and again lay them in
front of you as done in Step 1. Build the rear leg and
brace assembly the same way as done in Step 1, again
leaving the screws slightly loose.
