JL Audio Stealthbox SB-F-EDG2G/10TW1 Bedienungsanleitung

INSTALLATION GUIDE

for the

SB-F-EDG2G/10TW1

SKU# 94662

2015 & Up Ford Edge

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.

With proper installation, your new vehicle-specific enclosed subwoofer system

will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your

authorized JL Audio dealer. The installation professionals employed by your

dealer have the necessary tools and experience to disassemble and reassemble

your vehicle properly. If you prefer to perform your own installation, please read

this installation guide completely before beginning the process.

If you choose to perform the installation yourself, it is absolutely

vital that the Stealthbox®be properly mounted to the vehicle

according to these instructions. Failure to mount the enclosure

properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the

enclosure caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a

collision or sudden deceleration.

INSTALLATION

DIFFICULTY:

ESTIMATED TIME:

23 HOURS

Enclosure Type: Sealed

Driver Type: 10TW1-2

Nominal Impedance: 2 ohms

Continuous Power Handling: 300 watts (RMS method)

Continued on Next Page

OUT

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

INCLUDED HARDWARE

Continued on Next Page

Page 2 • JL Audio, Inc., 2018

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

BOM ID Qty SKU Description

1 6 151137 1/4 - 20 x 1” Hex Bolt

2 6 151098 1/4” Split Lock Washer

3 6 151021 1/4” Flat Washer

4 1 53676 Side Bracket

5 2 151164 1/4 - 20 U-Nut

6 1 150223 Top Bracket

7 1 153971 Bottom Bracket

8 1 151094 1/4 - 20 Keps Nut

- 1 152499 Grille Assembly (not shown)

321

2 31

321

POWER RECOMMENDATION

JL Audio recommends high quality ampliers such as the JL Audio XD300/1v2. The diagram below shows the recommended crossover settings for the XD300/1v2. For a detailed description of the

amplier settings, consult the owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.

Rem. |Oset | Signal

Input Voltage

Low | High

Turn-On Mode

Monoblock Subwoofer Amplifier

CONNECTIONS

Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your

Stealthbox® amplier. Other kits are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for

both channels of the amplier. JL Audio recommends using 12 AWG speaker wire for subwoofers such as our XC-BCS12-25.

Continued on Next Page

Page 3 • JL Audio, Inc., 2018

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

Page 4 • JL Audio, Inc., 2018 Continued on Next Page

STEP 8

Pictured is the vehicle with the cargo side

panel removed.

STEP 7

Carefully unclip the cargo side panel. Unplug

the cargo light from the backside of the panel,

and remove the panel from the vehicle.

STEP 6

Open the rear door on the passenger’s side.

Carefully unclip and remove the door sill panel.

STEP 5

Remove the cargo sill panel.

STEP 4

Carefully remove the clip from under each side

of the cargo sill panel.

STEP 3

Remove the two foam storage inserts.

STEP 2

Remove the cargo floor panel.

STEP 1

Empty the cargo area, and fold down the rear

seat on the passenger side.

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

Page 5 • JL Audio, Inc., 2018 Continued on Next Page

STEP 16

Align the hole in the short side of the Bottom

Bracket with the hole drilled in the previous

step.

Slide a 1/4” Split Lock Washer and a 1/4” Flat

Lock Washer over a 1/4 - 20 x 1” Hex Bolt, and

pass the assembly through the hole in the

Bottom Bracket and through the drilled hole.

From the back, thread a 1/4 - 20 Keps Nut over

the 1/4 - 20 x 1” Hex Bolt. Align the Bottom

Bracket as shown, and fully tighten.

STEP 15

Remove the factory bolt from the lower

subwoofer mounting location.

This will not be reinstalled.

Measure 1/2” down from the factory hole, and

mark the location. Using a 3/8” drill bit,

carefully drill through the panel.

STEP 14

Install a 1/4 - 20 U-Nut in each of the locations

indicated in Step 13, as shown.

STEP 13

Remove the molded jute panel from behind

the factory subwoofer enclosure location.

Remove the two indicated factory U-nuts from

the vehicle.

These will not be reinstalled.

STEP 12

Remove the factory subwoofer enclosure from

the vehicle.

This will not be reinstalled.

ST E P 11

Using a 10mm socket and wrench, remove the

two indicated factory bolts from the top of the

factory subwoofer enclosure.

These will not be reinstalled.

STEP 10

Using a 10mm socket and wrench, remove the

indicated factory nut at the bottom of the

factory subwoofer enclosure.

This will not be reinstalled.

STEP 9

Note: Steps 9-13 are for vehicles equipped

with a factory subwoofer enclosure. For

vehicles without a factory subwoofer

enclosure, skip to Step 14.

Disconnect the factory subwoofer.

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

Page 6 • JL Audio, Inc., 2018 Continued on Next Page

STEP 24

Pictured is the cargo side panel with the

factory subwoofer grille removed.

STEP 23

Place the cargo side panel on a soft, flat surface

with the rear surface facing up.

Using a grinder, carefully remove the plastic

welds to separate the factory subwoofer grille

(or storage pocket for vehicles not equipped

with factory subwoofer) from the cargo side

panel, using caution to not grind through the

panel itself.

STEP 22

Pictured is the Stealthbox installed in the

vehicle.

STEP 21

Connect speaker cable to the terminal cup on

the side of the enclosure, and route the cable

as necessary.

STEP 20

Slide a 1/4” Split Lock Washer and a 1/4” Flat

Washer over a 1/4 - 20 x 1” Hex Bolt, pass the

assembly through the slot in the Side Bracket,

into the 1/4 - 20 U-Nut, and hand tighten.

Repeat the process for the Top Bracket.

Fully tighten the hardware installed in Steps

17-19, then fully tighten the two 1/4 - 20 x 1”

Hex Bolts.

STEP 19

Place the Stealthbox into position in the

vehicle. Align the slot in the Bottom Bracket,

with the threaded insert in the bottom of the

enclosure.

Slide a 1/4” Split Lock Washer and a 1/4” Flat

Washer over a 1/4 - 20 x 1” Hex Bolt, pass

the assembly through the slot in the Bottom

Bracket, into the threaded insert, and hand

tighten.

STEP 18

Align the hole in the short side of the Top

Bracket with the threaded insert in the top of

the enclosure. Slide a 1/4” Split Lock Washer

and a 1/4” Flat Washer over a 1/4 - 20 x 1” Hex

Bolt, pass the assembly through the hole in the

Top Bracket, into the threaded insert, and hand

tighten.

STEP 17

Align the hole in the short side of the Side

Bracket with the threaded insert in the side of

the enclosure. Slide a 1/4” Split Lock Washer

and a 1/4” Flat Washer over a 1/4 - 20 x 1” Hex

Bolt , pass the assembly through the hole in

the Side Bracket, into the threaded insert, and

hand tighten.

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

Page 7 • JL Audio, Inc., 2018

CONGRATULATIONS!

You have completed the installation for this model! Enjoy your new Stealthbox®!

All specifications are subject to change without notice. “JL Audio®” and “How we play®” are registered trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo are trademarks

of JL Audio, Inc.

(954) 443-1100

www.jlaudio.com

JLA-SKU# 011507 • ver. 05.15.2018 • 10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA

MID/HIGH FREQUENCY DRIVER FITMENT

A variety of JL Audio coaxial and component systems will t in the factory speaker locations of you vehicle.

Location / OEM

Speaker Size

Suggested JL Audio Speaker Models

Coaxial Models Component Models

Front Doors /

6.5-inch C1-650x, C2-650x, C5-650x C1-650, C2-650, C3-650,

C5-650, C7-650cw(2)

Rear Doors /

6.5-inch C1-650x, C2-650x, C5-650x C1-650, C2-650, C3-650,

C5-650, C7-650cw(2)

1 - Installation may require adaptor, 2 - Component woofer only

STEP 28

Reinstall the cargo floor panel.

STEP 27

Reinstall the cargo sill panel and the two foam

storage inserts.

STEP 26

Plug in the cargo light, and reinstall the cargo

side panel.

Reinstall the rear door sill panel.

STEP 25

Align the Grille Assembly with the opening on

the front of the cargo side panel. Secure the

Grille Assembly to the panel by turning each of

the retaining clips from the back, as shown.

SB-F-EDG2G/10TW1 INSTR_SKU# 011507

Inhaltsverzeichnis

Andere JL Audio Autolautsprecher Handbücher

JL Audio

JL Audio C2-600x Bedienungsanleitung

JL Audio

JL Audio C5-650x Bedienungsanleitung

JL Audio

JL Audio XR653-CS Bedienungsanleitung

JL Audio

JL Audio C2-570x Bedienungsanleitung

JL Audio

JL Audio VR600-CSi Bedienungsanleitung

JL Audio

JL Audio TR600-CXi Bedienungsanleitung

JL Audio

JL Audio VR525-CSi Bedienungsanleitung

JL Audio

JL Audio C3-100ct Bedienungsanleitung

JL Audio

JL Audio C2-600x Bedienungsanleitung

JL Audio

JL Audio C2-690tx Bedienungsanleitung

JL Audio

JL Audio Evolution C5-650 Bedienungsanleitung

JL Audio

JL Audio SB-F-Edg Bedienungsanleitung

JL Audio

JL Audio C2-650x Bedienungsanleitung

JL Audio

JL Audio VR650-CSi Bedienungsanleitung

JL Audio

JL Audio stealthbox SB-J-WRUD/10TW1 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-POL-RZG2SPKR/MX650 Bedienungsanleitung

JL Audio

JL Audio MX650-CCX Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-AVAL/12W3v3 Bedienungsanleitung

JL Audio

JL Audio XR650-CSi Bedienungsanleitung

JL Audio

JL Audio SB-F-SUPRCNSL/10W3v2 Bedienungsanleitung

JL Audio

JL Audio XR525-CXi Bedienungsanleitung

JL Audio

JL Audio C2-650x Bedienungsanleitung

JL Audio

JL Audio Evolution C5-650 Bedienungsanleitung

JL Audio

JL Audio C5-570X Bedienungsanleitung

Beliebte Autolautsprecher Handbücher anderer Marken

Blaupunkt

Blaupunkt GTt 300 Technisches Datenblatt

Boston Acoustics

Boston Acoustics SX55 Bedienungsanleitung

Kenwood

Kenwood KFC-W212 Bedienungsanleitung

VR3

VR3 Elite VRS653 Bedienungsanleitung

Premier

Premier TS-W3001D4 Bedienungsanleitung

Infinity

Infinity 6530cx Bedienungsanleitung

Focal

Focal K2 Power 165 KRX3 Bedienungsanleitung

Precision Power

Precision Power PPI4.2 Bedienungsanleitung

Jensen

Jensen XS Series Bedienungsanleitung

Blaupunkt

Blaupunkt GTx Series Bedienungsanleitung

AudioBahn

AudioBahn AT60 Bedienungsanleitung

Focal

Focal BombA 27 V1 Bedienungsanleitung

Blueant

Blueant S1 Bedienungsanleitung

Naxa

Naxa NCS-768 Bedienungsanleitung

Focal

Focal Polyglass 130 VRS Bedienungsanleitung

Boston Mobile Audio

Boston Mobile Audio SR80 Bedienungsanleitung

Blaupunkt

Blaupunkt GTx 352 DE Bedienungsanleitung

Focal

Focal K2 POWER 130 KF Bedienungsanleitung