JL Audio Stealthbox SB-GM-HUMR2/12W6v2 Bedienungsanleitung

➔

Stealthbox®

INSTALLATION GUIDE

SB-GM-HUMR2/12W6v2, JL AUDIO, Inc 2004 Sheet SKU#011182 Revision8/5/2004Page 1

for the

SB-GM-HUMRH2/12W6v2

(2003-Up Hummer H2)

This Stealthbox is a product which

requires professional installation skills and

tools.

Please read this installation guide thor-

oughly before beginning the project. It

will guide you step by step through the

installation. Several of the steps in this

process may require two people to

accomplish.

It is absolutely vital that the enclosure

be properly mounted to the vehicle

according to these instructions. Failure

to mount the enclosure properly pres-

ents two problems: 1) The sub-bass

performance will suffer due to the

movement of the enclosure caused by

the force exerted by the woofer(s) and

2) A loose enclosure presents a serious

safety hazard in the event of a collision

or sudden deceleration.

Please enjoy your JL Audio Stealthbox

responsibly.

STEP 1:

Remove the third “jump” seat.

*STEPS 2-4 are for the vehicle that are

equip with the internal spare tire.*

STEP 2:

Remove the spare tire

STEP 3:

Remove the jack and jack tools.

STEP 4:

With an 8mm socket, remove the

four bolts that secure the spare tire rack.

STEP 5:

By pulling up, remove the driver’s

side rear storage bucket.

STEP 6:

With a 10mm socket, flat head

screw driver, Phillips® head screw driver and a

T-15 socket.

Remove the driver’s side rear wheel well plas-

tic trim.

START

HERE

Continued on Next Page ➔

www.jlaudio.com

➔

➔➔

➔➔➔

STEP 7: With the plastic trim out of the way,

remove the plastic inner wheel well.

STEP 11: Thread the supplied pair of socket ca

set screws into the enclosure, leaving 1/2” exposed.

Place the enclosure into place and firmly press

down.

Cont.

From

Page

Continued on Next Page ➔

➔

STEP 8: Rest the plastic inner wheel well on the

rear tire. Keep the trim and all the mounting hard-

ware together.

STEP 12: *CAUTION*

Before drilling, make sure that you are not going to

be drilling into any gas lines, brake lines, transmission

lines, electrical wiring, transfer case(4x4 vehicles) or

anything else that might cause a reduction in your

weekly pay. Always wear eye protection when

drilling.

With the use of a 1/2” drill bit and drill. Drill out the

floor at the impression on the wax square.

➔

STEP 13: Remove the wax square sheets from the

mounting area.

STEP 14: Run speaker wire to the enclosure loca-

tion.

Also check the woofer for proper operation.

STEP 9: (Inside the vehicle) Cut and remove

the factory jute(sound deadening), from the

removed storage area, from STEP 5.

STEP 10: Place the supplied pair of wax sheets

into place.

Remember to remove the rear paper backing, from

the wax sheets.

SB-GM-HUMR2/12W6v2, JL AUDIO, Inc 2004 Sheet SKU#011182 Revision8/5/2004Page 2

www.jlaudio.com

➔➔

➔➔➔

STEP 15: Back out the socket cup set screws, that

was threaded in from STEP 11, to expose 1-1/4”.

Connect the speaker wire to the terminal and place

the enclosure into position.

STEP 19: With the spare tire rack placed into

position. Loosely tighten the lower factory bolts to

the lower mounting feet.

Cont.

From

Page

Continued on Next Page ➔

➔

STEP 16: (Outside the vehicle) Place the sup-

plied hardware in order onto the exposed socket

cup screw. If more exposed threads are needed, back

out the socket cup set screws.

*Do not back out too much, you can cause a

conflict when mounting the plastic inner

wheel well, back into location.*

Fender washer, flat washer, lock washer and hex nut

onto each socket cup set screw.

Secure tightly.

STEP 20: Placed A supplied spacer, between each

upper mounting foot of the spare tire rack and the

side panel.

Loosely secure each upper mount assembly with a

supplied hex cap screw.

➔

STEP 21: Align the spare tire rack, for proper

positioning.

STEP 22: With the spare tire rack properly posi-

tioned, it should not interfere with the enclosure.

STEP 17: Mount the plastic inner wheel well and

plastic trim from STEPS 6 & 7.

You didn’t leave too much of the socket cup set

screws exposed, did you?

*STEPS 18-24 are for only for the vehicles

that are equip with the internal spare tire.*

STEP 18: The spare tire rack needs to be modi-

fied for the proper spacing,This needs to be accom-

plished on both bottom mounting feet.

Measure 9/16” from the center of the factory

mounting hole, back. Mark and drill with the a 1/2”

drill bit or Uni-bit®.

SB-GM-HUMR2/12W6v2, JL AUDIO, Inc 2004 Sheet SKU#011182 Revision8/5/2004

Page 3

www.jlaudio.com

Specifications:

Enclosure Type: Sealed

Driver Type: 12W6v2-D4

Nominal Impedance: 2Ω

Cont. Power Handling: 400 Watts

JL Audio recommends using a high quality amplifier such as the JL Audio 500/1. The diagram below shows the recommended

crossover, infrasonic filter and equalizer settings for the 500/1 when being used to power your Stealthbox®.

Included Hardware:

(2) 3” x 3” Wax sheets

(2) 3/8”-16 x 2-1/4” Socket Cup Set Screw

(2) 3/8” x 1-1/4” Fender Washer

(2) 3/8” USS Flat Washer

(2) 3/8” - 16 HEx Nuts

(2) 1/2”(w) x 1”(od) Spacers

(2) 12mm x 70mm Hex Cap Screws

10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111

+12VDC RemoteGround

JL AUDIO 500/1

five-channel system amplifier

Subwoofer Output

MONO OUTPUT ONLY

120

200

Filter Freq. (Hz)

Mode / Slope

Off / 12dB / 24dB

Amp LP Filter

Infrasonic Freq. (Hz)

Off / 30Hz

Infrasonic Filter

0.5

0.7

1.1

1.6

2.7

4.3

"Q"

Center Freq.

+10

+13

+15

Boost (dB)

Off / On

Bass EQ

Remote Bass Port

Advanced

Bass

Control

Preamp Output Section

Full Range / Amp Filter / Out Filter

Output Mode Filter Slope

12dB / 24dB

120

200

Filter Freq. (Hz)

Left Ch. Right Ch.

Filter Mode

LP / HP

Amplifier Input Section

Input Sens.

Left Ch. Right Ch.

Signal Sensing

Off / On

Input Voltage

Low / High

The JL Audio 500/1 is a very versatile audio component. Please consult the owner’s manual for detailed information

about installing and tuning this amplifier.

➔➔➔

STEP 23: Replace the jack and the jack tools, that

were removed in STEP 3.

STEP 24: Secure the spare tire onto the rack and

replace the tire cover.

➔

SB-GM-HUMR2/12W6v2, JL AUDIO, Inc 2004 Sheet SKU#011182 Revision8/5/2004Page 4

www.jlaudio.com

Mid/High Frequency Driver Information:

CONGRATULATIONS!

INSTALL COMPLETE.

ZR650-CSi

XR525-CXi

Front Location Driver Size:

6.5”(door) & Tweeter(A-pillar)

Applicable JL Audio Products:

TR,VR, XR, ZR 650-CSi

Rear Door Location Driver Size:

5.25”

Applicable JL Audio Products:

TR,VR, XR525-CXi

Rear Cargo Location Driver Size:

2.25”

Applicable JL Audio Products:

N/A

Cont.

From

Page

Difficulty Of Installation:

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio 12W3v2 Bedienungsanleitung

JL Audio

JL Audio e112 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-TUNDC/8W7 Bedienungsanleitung

JL Audio

JL Audio 13TW5-3 Bedienungsanleitung

JL Audio

JL Audio 12TW3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-POL-SLINGSUBD/10W3v3-4 Bedienungsanleitung

JL Audio

JL Audio ACP1 08LG-W3v3 Bedienungsanleitung

JL Audio

JL Audio gotham v2 Bedienungsanleitung

JL Audio

JL Audio 10W6V2-D4 Bedienungsanleitung

JL Audio

JL Audio e110 Bedienungsanleitung

JL Audio

JL Audio M6-8IB Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-TTCRW/10W3v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CAM/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 10W5-D4 Speci?cations Bedienungsanleitung

JL Audio

JL Audio FS110-W5 Series Bedienungsanleitung

JL Audio

JL Audio 10W6v2-D4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-4RNR/10W Bedienungsanleitung

JL Audio

JL Audio 15W3v2-D2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-S-IMPRZA/10W6v2 Bedienungsanleitung

JL Audio

JL Audio 10W6v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-SLVEXT/10W6v2 Bedienungsanleitung

JL Audio

JL Audio 12W4-4 Bedienungsanleitung

JL Audio

JL Audio 12W1v2-4 Bedienungsanleitung

JL Audio

JL Audio M121B6 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung