JL Audio Stealthbox SB-POL-SLINGSUBD/10W3v3-4 Bedienungsanleitung

Enclosure Type: Sealed

Driver Type: 10W3v3

Nominal Impedance: 4 or 2 ohms

Continuous Power Handling: 500 watts (RMS method)

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.

With proper installation, your new vehicle-specific enclosed subwoofer system

will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your

authorized JL Audio dealer. The installation professionals employed by your

dealer have the necessary tools and experience to disassemble and reassemble

your vehicle properly. If you prefer to perform your own installation, please read

this installation guide completely before beginning the process.

If you choose to perform the installation yourself, it is absolutely

vital that the Stealthbox®be properly mounted to the vehicle

according to these instructions. Failure to mount the enclosure

properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the

enclosure caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a

collision or sudden deceleration.

INSTALLATION

D IFF IC U LT Y:

ESTIMATED TIME:

1 HOUR

Continued on Next Page

OUT

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

INSTALLATION GUIDE

for the

SB-POL-SLINGSUBD/10W3v3-4

SB-POL-SLINGSUBD/10W3v3-2

SKU# 94637 (4 W)& 94638 (2 W)

2015-Up Polaris Slingshot

INCLUDED HARDWARE

Continued on Next Page

Page 2 • JL Audio, Inc., 2017

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

BOM ID Qty SKU Description

1 2 153814 8 - 32 x 1/2” Pan Head Phillips Machine Screw

2 1 153850 ABS Plate

3 2 153855 M6 - 1 x 50mm Hex Drive Flanged Button Head Screw

4 4 153858 Nylon Plastic Washer

5 2 153853 M6 - 1 x 25mm Hex Drive Flanged Button Head Screw

6 4 153856 M6 - 1 U-Nut

7 1 153848 Bottom Bracket

8 1 150285 Nylon Cable Tie

9 1 153847 Top Bracket

- 1 153857 3/4” x 3/4” EPDM Foam (not shown)

- 1 150249 Foam Tape (not shown)

Note: For optimum performance, JL Audio recommends applying the included Foam Strips (or sound damping material) to surrounding plastic panels to reduce unwanted vibrations.

POWER RECOMMENDATION

JL Audio recommends high quality ampliers such as the JL Audio MX500/1. The diagram below shows the recommended crossover settings for the MX500/1. For a detailed description of the

amplier settings, consult the owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.

CONNECTIONS

Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your

Stealthbox® amplier. Other kits are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for

both channels of the amplier. JL Audio recommends using 12 AWG speaker wire for subwoofers such as our XC-BCS12-25.

Continued on Next Page

Page 3 • JL Audio, Inc., 2017

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

Page 4 • JL Audio, Inc., 2017 Continued on Next Page

STEP 8

From inside the storage compartment, pass

the Nylon Cable Tie through one of the inner

holes in the Top Bracket and ABS Plate, around

the front of the compartment latch, and back

through the opposite inner hole in the ABS

Plate and Top Bracket, into the storage

compartment, as shown.

STEP 7

Position the Top Bracket assembly behind the

rear plastic panel, with its center cutout around

the compartment latch, as shown. Position the

ABS Plate between the Top Bracket and the

compartment latch, aligning the holes in both

parts.

Secure with a pair of 8 - 32 x 1/2” Pan Head

Phillips Machine Screws, as shown.

STEP 6

Slide an M6 - 1 U-Nut over each of the outer

holes in the Top Bracket, as shown. Be sure the

U-Nuts are oriented downward.

STEP 5

Position the Bottom Bracket assembly behind

the hinge, under the storage compartment, as

shown. The center, flat section of the Bottom

Bracket should be placed against the rear

plastic panel. Center the Bottom Bracket below

the storage compartment opening.

STEP 4

Slide an M6 - 1 U-Nut over each of the outer

holes in the Bottom Bracket, as shown. Be sure

the U-Nuts are oriented outward.

STEP 3

Route speaker cable into the storage

compartment.

STEP 2

Open the storage compartment, and remove

the compartment door.

STEP 1

Slide the seat forward.

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

Page 5 • JL Audio, Inc., 2017 Continued on Next Page

STE P 14

Pictured is the Stealthbox fully installed.

Slide the seat back.

Note: For optimum performance, we

recommend applying the included Foam Strips

(or sound damping material) to surrounding

plastic panels to reduce unwanted vibrations.

STE P 13

Lift up on the enclosure, and fully tighten both

M6 - 1 x 50mm Hex Drive Flanged Button Head

Screws and both M6 - 1 x 25mm Hex Drive

Flanged Button Head Screws.

STE P 12

Slide a 1/4” Nylon Plastic Washer over each

of the two M6 - 1 x 25mm Hex Drive Flanged

Button Head Screws. Pass an assembly through

each of the holes in the bottom of the

enclosure, and thread it into the M6 - 1 U-Nut.

Do not fully tighten at this time.

ST E P 11

Slide a 1/4” Nylon Plastic Washer over each

of the two M6 - 1 x 50mm Hex Drive Flanged

Button Head Screws. Pass an assembly through

each of the holes in the top of the enclosure,

and thread it into the M6 - 1 U-Nut.

Do not fully tighten at this time.

STEP 10

Connect the speaker cable to the terminal cup

on the back of the enclosure, and slide the

Stealthbox® into the storage compartment.

STEP 9

With the Top Bracket in the horizontal position,

fully tighten the Nylon Cable Tie so that each of

the M6- 1 U-Nuts on the Top Bracket is aligned

with the factory holes in the rear plastic panel.

Remove the adhesive backing from the 3/4” x

3/4” EPDM Foam, and attach the foam to the

rear panel, above the storage compartment

opening, as shown.

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

Page 6 • JL Audio, Inc., 2017

MID/HIGH FREQUENCY DRIVER FITMENT

SB-POL-SLINGSPKRS/M770 speaker pods are also available for your vehicle. Each weatherproof pod is

designed for a perfect t and houses a premium JL Audio component system.

SB-POL-SLINGSPKR/M770

SKU# 94636

All specifications are subject to change without notice. “JL Audio®”and the JL Audio logo,“Stealthbox®” and the Stealthbox logo, and “How we play®” are registered trademarks of JL Audio, Inc.

“Ahead of the Curve” and its respective logo are trademarks of JL Audio, Inc.

(954) 443-1100

www.jlaudio.com

JLA-SKU# 011482 • ver. 05.23.2017 • 10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA

CONGRATULATIONS!

You have completed the installation for this model! Enjoy your new Stealthbox®!

SB-POL-SLINGSUBD/10W3v3 INSTR_SKU# 011482

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio Fathom f110 Bedienungsanleitung

JL Audio

JL Audio 12W3v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-KW-TRX4/10TW3 Bedienungsanleitung

JL Audio

JL Audio 15WOv3-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-TAHOCNSL/10W1v2 Bedienungsanleitung

JL Audio

JL Audio 10W0v2-4 Bedienungsanleitung

JL Audio

JL Audio 8W7 Bedienungsanleitung

JL Audio

JL Audio M10W5 Bedienungsanleitung

JL Audio

JL Audio 10W6v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CFMINI/10W3v2 Bedienungsanleitung

JL Audio

JL Audio C5-650x Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-EQNX/10W1v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox 5 Series Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-P-987C/13TW5v2 Bedienungs- und Wartungsanleitung

JL Audio

JL Audio 12TW3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-S2000/10W3 Bedienungsanleitung

JL Audio

JL Audio MicroSub+ Bedienungsanleitung

JL Audio

JL Audio Dominion d110 Bedienungsanleitung

JL Audio

JL Audio 10TW3-D4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-MURAN/10W1v2 Bedienungsanleitung

JL Audio

JL Audio 10W1v3-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-PIO1K/10TW3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-TAHOCNSL/10W1v3 Bedienungsanleitung

JL Audio

JL Audio 15W3v2-D4 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung